Home
last modified time | relevance | path

Searched +full:stm32 +full:- +full:lptimer +full:- +full:counter (Results 1 – 10 of 10) sorted by relevance

/Linux-v6.1/Documentation/devicetree/bindings/mfd/
Dst,stm32-lptimer.yaml1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/mfd/st,stm32-lptimer.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
7 title: STMicroelectronics STM32 Low-Power Timers bindings
10 The STM32 Low-Power Timer (LPTIM) is a 16-bit timer that provides several
12 - PWM output (with programmable prescaler, configurable polarity)
13 - Trigger source for STM32 ADC/DAC (LPTIM_OUT)
14 - Several counter modes:
15 - quadrature encoder to detect angular position and direction of rotary
[all …]
/Linux-v6.1/drivers/clocksource/
Dtimer-stm32-lp.c1 // SPDX-License-Identifier: GPL-2.0
3 * Copyright (C) STMicroelectronics 2019 - All Rights Reserved
11 #include <linux/mfd/stm32-lptimer.h>
40 regmap_write(priv->reg, STM32_LPTIM_CR, 0); in stm32_clkevent_lp_shutdown()
41 regmap_write(priv->reg, STM32_LPTIM_IER, 0); in stm32_clkevent_lp_shutdown()
43 regmap_write(priv->reg, STM32_LPTIM_ICR, STM32_LPTIM_ARRMCF); in stm32_clkevent_lp_shutdown()
54 /* disable LPTIMER to be able to write into IER register*/ in stm32_clkevent_lp_set_timer()
55 regmap_write(priv->reg, STM32_LPTIM_CR, 0); in stm32_clkevent_lp_set_timer()
57 regmap_write(priv->reg, STM32_LPTIM_IER, STM32_LPTIM_ARRMIE); in stm32_clkevent_lp_set_timer()
58 /* enable LPTIMER to be able to write into ARR register */ in stm32_clkevent_lp_set_timer()
[all …]
/Linux-v6.1/drivers/counter/
Dstm32-lptimer-cnt.c1 // SPDX-License-Identifier: GPL-2.0
3 * STM32 Low-Power Timer Encoder and Counter driver
9 * Inspired by 104-quad-8 and stm32-timer-trigger drivers.
14 #include <linux/counter.h>
15 #include <linux/mfd/stm32-lptimer.h>
37 ret = regmap_read(priv->regmap, STM32_LPTIM_CR, &val); in stm32_lptim_is_enabled()
51 ret = regmap_write(priv->regmap, STM32_LPTIM_CR, val); in stm32_lptim_set_enable_state()
56 clk_disable(priv->clk); in stm32_lptim_set_enable_state()
57 priv->enabled = false; in stm32_lptim_set_enable_state()
62 ret = regmap_write(priv->regmap, STM32_LPTIM_ARR, priv->ceiling); in stm32_lptim_set_enable_state()
[all …]
DMakefile1 # SPDX-License-Identifier: GPL-2.0-only
3 # Makefile for Counter devices
6 obj-$(CONFIG_COUNTER) += counter.o
7 counter-y := counter-core.o counter-sysfs.o counter-chrdev.o
9 obj-$(CONFIG_104_QUAD_8) += 104-quad-8.o
10 obj-$(CONFIG_INTERRUPT_CNT) += interrupt-cnt.o
11 obj-$(CONFIG_STM32_TIMER_CNT) += stm32-timer-cnt.o
12 obj-$(CONFIG_STM32_LPTIMER_CNT) += stm32-lptimer-cnt.o
13 obj-$(CONFIG_TI_EQEP) += ti-eqep.o
14 obj-$(CONFIG_FTM_QUADDEC) += ftm-quaddec.o
[all …]
DKconfig1 # SPDX-License-Identifier: GPL-2.0-only
3 # Counter devices
6 menuconfig COUNTER config
7 tristate "Counter support"
9 This enables counter device support through the Generic Counter
11 one or more of the counter device drivers below.
13 if COUNTER
16 tristate "ACCES 104-QUAD-8 driver"
20 Say yes here to build support for the ACCES 104-QUAD-8 quadrature
21 encoder counter/interface device family (104-QUAD-8, 104-QUAD-4).
[all …]
/Linux-v6.1/arch/arm/boot/dts/
Dstm32h743.dtsi2 * Copyright 2017 - Alexandre Torgue <alexandre.torgue@st.com>
4 * This file is dual-licensed: you can use it either under the terms
43 #include "armv7-m.dtsi"
44 #include <dt-bindings/clock/stm32h7-clks.h>
45 #include <dt-bindings/mfd/stm32h7-rcc.h>
46 #include <dt-bindings/interrupt-controller/irq.h>
49 #address-cells = <1>;
50 #size-cells = <1>;
53 clk_hse: clk-hse {
54 #clock-cells = <0>;
[all …]
Dstm32mp151.dtsi1 // SPDX-License-Identifier: (GPL-2.0+ OR BSD-3-Clause)
3 * Copyright (C) STMicroelectronics 2017 - All Rights Reserved
6 #include <dt-bindings/interrupt-controller/arm-gic.h>
7 #include <dt-bindings/clock/stm32mp1-clks.h>
8 #include <dt-bindings/reset/stm32mp1-resets.h>
11 #address-cells = <1>;
12 #size-cells = <1>;
15 #address-cells = <1>;
16 #size-cells = <0>;
19 compatible = "arm,cortex-a7";
[all …]
/Linux-v6.1/drivers/pwm/
Dpwm-stm32-lp.c1 // SPDX-License-Identifier: GPL-2.0
3 * STM32 Low-Power Timer PWM driver
9 * Inspired by Gerald Baeza's pwm-stm32 driver
13 #include <linux/mfd/stm32-lptimer.h>
31 /* STM32 Low-Power Timer is preceded by a configurable power-of-2 prescaler */
47 if (!state->enabled) { in stm32_pwm_lp_apply()
50 ret = regmap_write(priv->regmap, STM32_LPTIM_CR, 0); in stm32_pwm_lp_apply()
53 /* disable clock to PWM counter */ in stm32_pwm_lp_apply()
54 clk_disable(priv->clk); in stm32_pwm_lp_apply()
60 div = (unsigned long long)clk_get_rate(priv->clk) * state->period; in stm32_pwm_lp_apply()
[all …]
/Linux-v6.1/drivers/mfd/
DKconfig1 # SPDX-License-Identifier: GPL-2.0-only
44 tristate "Active-semi ACT8945A"
49 Support for the ACT8945A PMIC from Active-semi. This device
50 features three step-down DC/DC converters and four low-dropout
66 sun4i-gpadc-iio and the hwmon driver iio_hwmon.
69 called sun4i-gpadc.
88 tablets etc. It has 4 DC/DC step-down regulators, 3 DC/DC step-down
119 over at91-usart-serial driver and usart-spi-driver. Only one function
135 tristate "Atmel HLCDC (High-end LCD Controller)"
172 tristate "X-Powers AC100"
[all …]
/Linux-v6.1/
DMAINTAINERS9 -------------------------
30 ``diff -u`` to make the patch easy to merge. Be prepared to get your
40 See Documentation/process/coding-style.rst for guidance here.
46 See Documentation/process/submitting-patches.rst for details.
57 include a Signed-off-by: line. The current version of this
59 Documentation/process/submitting-patches.rst.
70 that the bug would present a short-term risk to other users if it
76 Documentation/admin-guide/security-bugs.rst for details.
81 ---------------------------------------------------
97 W: *Web-page* with status/info
[all …]