Searched +full:stm32 +full:- +full:dac (Results 1 – 15 of 15) sorted by relevance
/Linux-v5.15/Documentation/devicetree/bindings/iio/dac/ |
D | st,stm32-dac.yaml | 1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause) 3 --- 4 $id: "http://devicetree.org/schemas/iio/dac/st,stm32-dac.yaml#" 5 $schema: "http://devicetree.org/meta-schemas/core.yaml#" 7 title: STMicroelectronics STM32 DAC bindings 10 The STM32 DAC is a 12-bit voltage output digital-to-analog converter. The DAC 11 may be configured in 8 or 12-bit mode. It has two output channels, each with 13 It has built-in noise and triangle waveform generator and supports external 14 triggers for conversions. The DAC's output buffer allows a high drive output 18 - Fabrice Gasnier <fabrice.gasnier@st.com> [all …]
|
/Linux-v5.15/drivers/iio/dac/ |
D | stm32-dac.c | 1 // SPDX-License-Identifier: GPL-2.0 3 * This file is part of STM32 DAC driver 5 * Copyright (C) 2017, STMicroelectronics - All Rights Reserved 18 #include "stm32-dac-core.h" 27 * struct stm32_dac - private data of DAC driver 28 * @common: reference to DAC common data 39 struct stm32_dac *dac = iio_priv(indio_dev); in stm32_dac_is_enabled() local 43 ret = regmap_read(dac->common->regmap, STM32_DAC_CR, &val); in stm32_dac_is_enabled() 57 struct stm32_dac *dac = iio_priv(indio_dev); in stm32_dac_set_enable_state() local 58 struct device *dev = indio_dev->dev.parent; in stm32_dac_set_enable_state() [all …]
|
D | stm32-dac-core.c | 1 // SPDX-License-Identifier: GPL-2.0 3 * This file is part of STM32 DAC driver 5 * Copyright (C) 2017, STMicroelectronics - All Rights Reserved 18 #include "stm32-dac-core.h" 21 * struct stm32_dac_priv - stm32 DAC core private data 24 * @common: Common data for all DAC instances 33 * struct stm32_dac_cfg - DAC configuration 34 * @has_hfsel: DAC has high frequency control 58 ret = regulator_enable(priv->vref); in stm32_dac_core_hw_start() 64 ret = clk_prepare_enable(priv->pclk); in stm32_dac_core_hw_start() [all …]
|
D | stm32-dac-core.h | 1 /* SPDX-License-Identifier: GPL-2.0 */ 3 * This file is part of STM32 DAC driver 5 * Copyright (C) 2017, STMicroelectronics - All Rights Reserved 14 /* STM32 DAC registers */ 27 * struct stm32_dac_common - stm32 DAC driver common data (for all instances) 28 * @regmap: DAC registers shared via regmap
|
D | Makefile | 1 # SPDX-License-Identifier: GPL-2.0 3 # Makefile for industrial I/O DAC drivers 7 obj-$(CONFIG_AD5360) += ad5360.o 8 obj-$(CONFIG_AD5380) += ad5380.o 9 obj-$(CONFIG_AD5421) += ad5421.o 10 obj-$(CONFIG_AD5624R_SPI) += ad5624r_spi.o 11 obj-$(CONFIG_AD5064) += ad5064.o 12 obj-$(CONFIG_AD5504) += ad5504.o 13 obj-$(CONFIG_AD5446) += ad5446.o 14 obj-$(CONFIG_AD5449) += ad5449.o [all …]
|
D | Kconfig | 1 # SPDX-License-Identifier: GPL-2.0-only 3 # DAC drivers 10 tristate "Analog Devices AD5064 and similar multi-channel DAC driver" 14 AD5045, AD5064, AD5064-1, AD5065, AD5625, AD5625R, AD5627, AD5627R, 24 tristate "Analog Devices AD5360/61/62/63/70/71/73 DAC driver" 28 AD5362, AD5363, AD5370, AD5371, AD5373 multi-channel 29 Digital to Analog Converters (DAC). 35 tristate "Analog Devices AD5380/81/82/83/84/90/91/92 DAC driver" 41 AD5382, AD5383, AD5384, AD5390, AD5391, AD5392 multi-channel 42 Digital to Analog Converters (DAC). [all …]
|
/Linux-v5.15/arch/arm/boot/dts/ |
D | stm32f429.dtsi | 2 * Copyright 2015 - Maxime Coquelin <mcoquelin.stm32@gmail.com> 4 * This file is dual-licensed: you can use it either under the terms 22 * MA 02110-1301 USA 48 #include "armv7-m.dtsi" 49 #include <dt-bindings/clock/stm32fx-clock.h> 50 #include <dt-bindings/mfd/stm32f4-rcc.h> 53 #address-cells = <1>; 54 #size-cells = <1>; 57 clk_hse: clk-hse { 58 #clock-cells = <0>; [all …]
|
D | stm32h743.dtsi | 2 * Copyright 2017 - Alexandre Torgue <alexandre.torgue@st.com> 4 * This file is dual-licensed: you can use it either under the terms 43 #include "armv7-m.dtsi" 44 #include <dt-bindings/clock/stm32h7-clks.h> 45 #include <dt-bindings/mfd/stm32h7-rcc.h> 46 #include <dt-bindings/interrupt-controller/irq.h> 49 #address-cells = <1>; 50 #size-cells = <1>; 53 clk_hse: clk-hse { 54 #clock-cells = <0>; [all …]
|
D | stm32mp151.dtsi | 1 // SPDX-License-Identifier: (GPL-2.0+ OR BSD-3-Clause) 3 * Copyright (C) STMicroelectronics 2017 - All Rights Reserved 6 #include <dt-bindings/interrupt-controller/arm-gic.h> 7 #include <dt-bindings/clock/stm32mp1-clks.h> 8 #include <dt-bindings/reset/stm32mp1-resets.h> 11 #address-cells = <1>; 12 #size-cells = <1>; 15 #address-cells = <1>; 16 #size-cells = <0>; 19 compatible = "arm,cortex-a7"; [all …]
|
D | stm32mp15xx-dhcom-drc02.dtsi | 1 // SPDX-License-Identifier: GPL-2.0+ OR BSD-3-Clause 6 #include <dt-bindings/input/input.h> 7 #include <dt-bindings/pwm/pwm.h> 17 stdout-path = "serial0:115200n8"; 25 &dac { 32 * GPIO line, however the STM32 UART driver assumes RX happens 36 rs485-rx-en-hog { 37 gpio-hog; 39 output-low; 40 line-name = "rs485-rx-en"; [all …]
|
D | stm32mp15-pinctrl.dtsi | 1 // SPDX-License-Identifier: (GPL-2.0+ OR BSD-3-Clause) 3 * Copyright (C) STMicroelectronics 2017 - All Rights Reserved 6 #include <dt-bindings/pinctrl/stm32-pinfunc.h> 9 adc1_in6_pins_a: adc1-in6-0 { 15 adc12_ain_pins_a: adc12-ain-0 { 24 adc12_ain_pins_b: adc12-ain-1 { 31 adc12_usb_cc_pins_a: adc12-usb-cc-pins-0 { 38 cec_pins_a: cec-0 { 41 bias-disable; 42 drive-open-drain; [all …]
|
/Linux-v5.15/Documentation/devicetree/bindings/mfd/ |
D | st,stm32-lptimer.yaml | 1 # SPDX-License-Identifier: (GPL-2.0-only OR BSD-2-Clause) 3 --- 4 $id: http://devicetree.org/schemas/mfd/st,stm32-lptimer.yaml# 5 $schema: http://devicetree.org/meta-schemas/core.yaml# 7 title: STMicroelectronics STM32 Low-Power Timers bindings 10 The STM32 Low-Power Timer (LPTIM) is a 16-bit timer that provides several 12 - PWM output (with programmable prescaler, configurable polarity) 13 - Trigger source for STM32 ADC/DAC (LPTIM_OUT) 14 - Several counter modes: 15 - quadrature encoder to detect angular position and direction of rotary [all …]
|
/Linux-v5.15/drivers/iio/trigger/ |
D | Kconfig | 1 # SPDX-License-Identifier: GPL-2.0-only 7 menu "Triggers - standalone" 17 module will be called iio-trig-hrtimer. 26 module will be called iio-trig-interrupt. 29 tristate "STM32 Low-Power Timer Trigger" 32 Select this option to enable STM32 Low-Power Timer Trigger. 33 This can be used as trigger source for STM32 internal ADC 34 and/or DAC. 37 module will be called stm32-lptimer-trigger. 40 tristate "STM32 Timer Trigger" [all …]
|
/Linux-v5.15/drivers/iio/adc/ |
D | Kconfig | 1 # SPDX-License-Identifier: GPL-2.0-only 10 bool "ST-Ericsson AB8500 GPADC driver" 29 Say yes here to build support for Analog Devices AD7091R-5 ADC. 32 tristate "Analog Devices AD7124 and similar sigma-delta ADCs driver" 36 Say yes here to build support for Analog Devices AD7124-4 and AD7124-8 100 tristate "Analog Devices AD7476 1-channel ADCs driver and other similar devices from AD and TI" 126 ad7605-4, ad7606, ad7606-6, ad7606-4 analog to digital converters (ADC). 137 ad7605-4, ad7606, ad7606-6, ad7606-4 analog to digital converters (ADC). 148 Say yes here to build support for Analog Devices AD7766, AD7766-1, 149 AD7766-2, AD7767, AD7767-1, AD7767-2 SPI analog to digital converters. [all …]
|
/Linux-v5.15/ |
D | MAINTAINERS | 9 ------------------------- 30 ``diff -u`` to make the patch easy to merge. Be prepared to get your 40 See Documentation/process/coding-style.rst for guidance here. 46 See Documentation/process/submitting-patches.rst for details. 57 include a Signed-off-by: line. The current version of this 59 Documentation/process/submitting-patches.rst. 70 that the bug would present a short-term risk to other users if it 76 Documentation/admin-guide/security-bugs.rst for details. 81 --------------------------------------------------- 97 W: *Web-page* with status/info [all …]
|