| /Linux-v6.6/drivers/mtd/nand/raw/ |
| D | mpc5121_nfc.c | 34 /* Addresses for NFC SPARE BUFFER areas */
392 /* Copy data from/to NFC spare buffers. */
401 * NAND spare area is available through NFC spare buffers. in mpc5121_nfc_copy_spare()
402 * The NFC divides spare area into (page_size / 512) chunks. in mpc5121_nfc_copy_spare()
403 * Each chunk is placed into separate spare memory area, using in mpc5121_nfc_copy_spare()
406 * For NAND device in which the spare area is not divided fully in mpc5121_nfc_copy_spare()
407 * by the number of chunks, number of used bytes in each spare in mpc5121_nfc_copy_spare()
409 * and all remaining bytes are added to the last used spare area. in mpc5121_nfc_copy_spare()
415 /* Calculate number of valid bytes in each spare buffer */ in mpc5121_nfc_copy_spare()
419 /* Calculate spare buffer number */ in mpc5121_nfc_copy_spare()
[all …]
|
| D | mtk_nand.c | 161 * supported spare size of each IP.
162 * order should be the same with the spare size bitfiled defination of
323 u32 fmt, spare, i; in mtk_nfc_hw_runtime_config() local
328 spare = mtk_nand->spare_per_sector; in mtk_nfc_hw_runtime_config()
365 spare >>= 1; in mtk_nfc_hw_runtime_config()
368 if (nfc->caps->spare_size[i] == spare) in mtk_nfc_hw_runtime_config()
373 dev_err(nfc->dev, "invalid spare size %d\n", spare); in mtk_nfc_hw_runtime_config()
945 u32 spare = mtk_nand->spare_per_sector; in mtk_nfc_read_subpage() local
958 column = start * (chip->ecc.size + spare); in mtk_nfc_read_subpage()
960 len = sectors * chip->ecc.size + (raw ? sectors * spare : 0); in mtk_nfc_read_subpage()
[all …]
|
| /Linux-v6.6/arch/powerpc/platforms/pseries/ |
| D | vio.c | 81 * @reserve: pool of memory from which devices reserve entitlement, incl. spare
82 * @excess: pool of excess entitlement not needed for device reserves or spare
83 * @spare: IO memory for device hotplug functionality
96 size_t spare; member
138 * IO memory available to all devices. The spare pool used to service
158 /* If spare is not fulfilled, the excess pool can not be used. */ in vio_cmo_alloc()
159 if (vio_cmo.spare >= VIO_CMO_MIN_ENT) in vio_cmo_alloc()
183 * The spare pool is replenished first from either memory pool, then
211 /* Spare is a subset of the reserve pool, replenish it first. */ in vio_cmo_dealloc()
212 spare_needed = VIO_CMO_MIN_ENT - vio_cmo.spare; in vio_cmo_dealloc()
[all …]
|
| D | msi.c | 217 int spare; member
260 counts->spare += counts->quota - req; in count_spare_msis()
308 * use the remainder as spare MSIs for anyone that wants them. */ in msi_quota_for_device()
309 counts.spare += total % counts.num_devices; in msi_quota_for_device()
311 /* Divide any spare by the number of over-quota requestors */ in msi_quota_for_device()
313 counts.quota += counts.spare / counts.over_quota; in msi_quota_for_device()
|
| /Linux-v6.6/drivers/net/wireless/broadcom/b43/ |
| D | radio_2055.h | 9 #define B2055_GEN_SPARE 0x00 /* GEN spare */
42 #define B2055_RRCCAL_CS 0x22 /* RRCCAL Control spare */
71 #define B2055_RF_MMDSP 0x3F /* RF MMD spare */
102 #define B2055_LGEN_SPARE2 0x5E /* LGEN spare 2 */
109 #define B2055_C1_LGBUF_SPARE 0x65 /* Core 1 LGBUF spare */
128 #define B2055_C1_RX_BB_SPARE1 0x78 /* Core 1 RX Baseband spare 1 */
142 #define B2055_C1_TX_RF_SPARE 0x86 /* Core 1 TX RF spare */
156 #define B2055_C2_LGBUF_SPARE 0x94 /* Core 2 LGBUF spare */
175 #define B2055_C2_RX_BB_SPARE1 0xA7 /* Core 2 RX Baseband spare 1 */
189 #define B2055_C2_TX_RF_SPARE 0xB5 /* Core 2 TX RF spare */
[all …]
|
| /Linux-v6.6/Documentation/devicetree/bindings/clock/ |
| D | qcom,lcc.yaml | 59 - description: Mic I2S spare clock
61 - description: Speaker I2S spare clock
93 - description: Mic I2S spare clock
95 - description: Speaker I2S spare clock
|
| /Linux-v6.6/Documentation/driver-api/ |
| D | mtdnand.rst | 431 Most NAND chips mark the bad blocks at a defined position in the spare
434 mark each time when the blocks are accessed by reading the spare area of
547 marked and identified by a pattern which is stored in the spare area
550 the pattern has to be stored in len and the offset in the spare area
578 is stored in 4 consecutive bytes in the spare area of the device. The
600 Spare area (auto)placement
604 filesystem data in the spare area,
645 The eccpos array holds the byte offsets in the spare area where the
650 The oobfree array defines the areas in the spare area which can be
661 spare area buffer along with the data buffer. The spare area buffer size
[all …]
|
| /Linux-v6.6/include/linux/firmware/qcom/ |
| D | qcom_scm.h | 89 extern int qcom_scm_restore_sec_cfg(u32 device_id, u32 spare);
90 extern int qcom_scm_iommu_secure_ptbl_size(u32 spare, size_t *size);
91 extern int qcom_scm_iommu_secure_ptbl_init(u64 addr, u32 size, u32 spare);
92 extern int qcom_scm_iommu_set_cp_pool_size(u32 spare, u32 size);
|
| /Linux-v6.6/crypto/async_tx/ |
| D | async_pq.c | 288 * @spare: temporary result buffer for the synchronous case
289 * @s_off: spare buffer page offset
299 size_t len, enum sum_check_flags *pqres, struct page *spare, in async_syndrome_val() argument
390 BUG_ON(!spare || !scribble); in async_syndrome_val()
403 tx = async_xor_offs(spare, s_off, in async_syndrome_val()
407 s = page_address(spare) + s_off; in async_syndrome_val()
413 Q(blocks, disks) = spare; in async_syndrome_val()
420 s = page_address(spare) + s_off; in async_syndrome_val()
449 pr_err("%s: failed to allocate required spare page\n", __func__); in async_pq_init()
|
| /Linux-v6.6/Documentation/devicetree/bindings/remoteproc/ |
| D | qcom,sc7180-mss-pil.yaml | 118 qcom,spare-regs:
121 Spare registers are multipurpose registers used for errata
178 - qcom,spare-regs
239 qcom,spare-regs = <&tcsr_regs 0xb3e4>;
|
| /Linux-v6.6/drivers/gpu/drm/amd/pm/swsmu/inc/pmfw_if/ |
| D | smu_v13_0_4_ppsmc.h | 57 #define PPSMC_MSG_SPARE0 0x04 ///< SPARE
58 #define PPSMC_MSG_SPARE1 0x05 ///< SPARE
63 #define PPSMC_MSG_SPARE2 0x0A ///< SPARE
64 #define PPSMC_MSG_SPARE3 0x0B ///< SPARE
|
| D | smu13_driver_if_yellow_carp.h | 116 uint8_t Spare[3]; member
136 uint8_t spare[3]; member
164 uint16_t spare; member
|
| D | smu13_driver_if_v13_0_0.h | 376 uint32_t Spare[8]; member
725 uint32_t Spare[13]; member
762 uint32_t Spare[13]; member
869 uint32_t Spare[8]; member
900 uint32_t Spare[11]; member
1269 uint32_t Spare[41]; member
1393 uint32_t Spare[8]; member
1417 uint32_t Spare[32]; member
1489 uint32_t Spare[29]; member
1518 uint32_t Spare[16]; member
|
| D | smu13_driver_if_v13_0_7.h | 377 uint32_t Spare[8]; member
736 uint32_t Spare[12]; member
774 uint32_t Spare[12]; member
878 uint32_t Spare[8]; member
909 uint32_t Spare[11]; member
1263 uint32_t Spare[43]; member
1386 uint32_t Spare[8]; member
1410 uint32_t Spare[32]; member
1479 uint32_t Spare[30]; member
1508 uint32_t Spare[16]; member
|
| D | smu11_driver_if_vangogh.h | 150 uint8_t spare[2]; member
173 uint16_t spare; member
202 uint16_t spare; member
|
| /Linux-v6.6/arch/m68k/include/asm/ |
| D | adb_iop.h | 43 __u8 spare[21]; /* spare */ member
|
| /Linux-v6.6/drivers/soc/tegra/fuse/ |
| D | fuse-tegra30.c | 106 .spare = 0x144,
122 .spare = 0x180,
278 .spare = 0x200,
449 .spare = 0x280,
507 .spare = 0x280,
600 .spare = 0x280,
665 .spare = 0x280,
|
| D | fuse.h | 23 unsigned int spare; member
73 u32 __init tegra_fuse_read_spare(unsigned int spare);
|
| /Linux-v6.6/arch/arm/boot/dts/st/ |
| D | stm32mp15xc-lxa-tac.dtsi | 456 /* spare dmas for other usage */
507 /* spare dmas for other usage */
519 /* spare dmas for other usage */
531 /* spare dmas for other usage */
548 /* spare dmas for other usage */
562 /* spare dmas for other usage */
|
| D | stm32mp15xx-dhcom-picoitx.dtsi | 85 /* spare dmas for other usage */
96 /* spare dmas for other usage */
|
| /Linux-v6.6/drivers/s390/char/ |
| D | sclp_diag.h | 38 * @spare: reserved (zeroes)
53 u8 spare; member
|
| /Linux-v6.6/drivers/gpu/drm/amd/display/dc/clk_mgr/dcn31/ |
| D | dcn31_smu.h | 125 uint8_t Spare[3]; member
145 uint8_t spare[3]; member
173 uint16_t spare; member
|
| /Linux-v6.6/drivers/gpu/drm/amd/display/dc/clk_mgr/dcn314/ |
| D | dcn314_smu.h | 44 uint8_t Spare[3]; member
64 uint8_t spare[3]; member
|
| /Linux-v6.6/include/uapi/linux/raid/ |
| D | md_p.h | 79 #define MD_DISK_ACTIVE 1 /* disk is running or spare disk */
85 #define MD_DISK_CANDIDATE 5 /* disk is added as spare (local) until confirmed
165 __u32 spare_disks; /* 5 Number of spare disks */
303 * into the 'roles' value. If a device is spare or faulty, then it doesn't
306 __le16 dev_roles[]; /* role in array, or 0xffff for a spare, or 0xfffe for faulty */
|
| /Linux-v6.6/fs/hpfs/ |
| D | hpfs.h | 107 /* The spare block has pointers to spare sectors. */
118 u8 sparedir_used: 1; /* spare dirblks used */
132 u8 sparedir_used: 1; /* spare dirblks used */
160 __le32 n_dnode_spares_free; /* spare dnodes unused */
195 /* The code page info pointed to by the spare block consists of an index
|
