Searched full:sequencing (Results 1 – 25 of 92) sorted by relevance
1234
| /Linux-v6.6/Documentation/devicetree/bindings/mfd/ |
| D | max77620.txt | 34 and power-down delays (sequencing). GPIO1, GPIO2, and GPIO3 can be programmed
39 The flexible sequencing structure consists of two hardware enable inputs
40 (EN0, EN1), and 3 master sequencing timers called FPS0, FPS1 and FPS2.
41 Each master sequencing timer is programmable through its configuration
43 source (SW). When enabled/disabled, the master sequencing timer generates
44 eight sequencing events on different time periods called slots. The time
55 clock are set into following state at the sequencing event that
59 the sequencing event.
61 low power mode at the sequencing event.
|
| D | rohm,bd9576-pmic.yaml | 15 The IC provides 6 power outputs with configurable sequencing and safety
|
| /Linux-v6.6/drivers/hid/i2c-hid/ |
| D | i2c-hid.h | 27 * @power_up: do sequencing to power up the device.
28 * @power_down: do sequencing to power down the device.
|
| /Linux-v6.6/Documentation/i2c/busses/ |
| D | i2c-ali1535.rst | 27 Additionally, the sequencing of the SMBus transactions has been modified to
28 be more consistent with the sequencing recommended by the manufacturer and
|
| /Linux-v6.6/Documentation/devicetree/bindings/power/ |
| D | mediatek,power-controller.yaml | 96 power-up sequencing.
100 List of names of clocks, in order to match the power-up sequencing
107 In order to follow properly the power-up sequencing, the clocks must
|
| D | fsl,imx-gpcv2.yaml | 77 power-up sequencing to ensure reset propagation into devices located
90 power-up sequencing of the domain. The resets belong to devices
|
| D | fsl,imx-gpc.yaml | 89 power-up sequencing to ensure reset propagation into devices located
|
| /Linux-v6.6/Documentation/devicetree/bindings/display/panel/ |
| D | panel-edp.yaml | 27 provided anywhere on the DP AUX bus is the power sequencing timings.
33 information) to figure out other power sequencing timings.
35 eDP panels in general can have somewhat arbitrary power sequencing
|
| D | raspberrypi,7inch-touchscreen.yaml | 17 - Atmel microcontroller on I2C for power sequencing the DSI bridge and
|
| /Linux-v6.6/Documentation/devicetree/bindings/pinctrl/ |
| D | pinctrl-max77620.txt | 64 - maxim,active-fps-power-up-slot: Sequencing event slot number on which
71 - maxim,active-fps-power-down-slot: Sequencing event slot number on which
|
| /Linux-v6.6/Documentation/devicetree/bindings/arm/freescale/ |
| D | fsl,imx7ulp-pm.yaml | 13 The Multi-System Mode Controller (MSMC) is responsible for sequencing
|
| /Linux-v6.6/Documentation/devicetree/bindings/regulator/ |
| D | regulator-max77620.txt | 62 - maxim,active-fps-power-up-slot: Sequencing event slot number on which
69 - maxim,active-fps-power-down-slot: Sequencing event slot number on which
|
| /Linux-v6.6/Documentation/devicetree/bindings/soc/imx/ |
| D | fsl,imx8mq-vpu-blk-ctrl.yaml | 14 the NoC and ensuring proper power sequencing of the VPU peripherals
|
| D | fsl,imx93-src.yaml | 60 during domain power-up sequencing to ensure reset
|
| D | fsl,imx8mp-hsio-blk-ctrl.yaml | 14 the NoC and ensuring proper power sequencing of the high-speed IO
|
| D | fsl,imx8mp-hdmi-blk-ctrl.yaml | 14 the NoC and ensuring proper power sequencing of the display pipeline
|
| D | fsl,imx8mm-disp-blk-ctrl.yaml | 14 the NoC and ensuring proper power sequencing of the display and MIPI CSI
|
| D | fsl,imx8mn-disp-blk-ctrl.yaml | 14 the NoC and ensuring proper power sequencing of the display and MIPI CSI
|
| D | fsl,imx8mm-vpu-blk-ctrl.yaml | 14 the NoC and ensuring proper power sequencing of the VPU peripherals
|
| /Linux-v6.6/Documentation/devicetree/bindings/input/ |
| D | goodix,gt7375p.yaml | 15 power sequencing required.
|
| /Linux-v6.6/drivers/gpu/drm/i915/display/ |
| D | intel_pps_regs.h | 11 /* Panel power sequencing */
|
| /Linux-v6.6/net/l2tp/ |
| D | l2tp_core.h | 65 * Tracks runtime state including cookies, dataplane packet sequencing, and IO statistics.
254 /* Receive path helpers. If data sequencing is enabled for the session these
|
| /Linux-v6.6/Documentation/filesystems/ |
| D | xfs-delayed-logging-design.rst | 702 Delayed Logging: Checkpoint Sequencing
717 written directly into the log buffers. Hence some other method of sequencing
955 that is run as part of the checkpoint commit and log force sequencing. The code
961 sequencing also requires the same lock, list walk, and blocking mechanism to
964 These two sequencing operations can use the mechanism even though the
966 sequencing needs to wait until checkpoint contexts contain a commit LSN
968 sequencing needs to wait until previous checkpoint contexts are removed from
|
| /Linux-v6.6/Documentation/driver-api/nvdimm/ |
| D | firmware-activate.rst | 79 The last runtime activation failed due to a sequencing error of the
|
| /Linux-v6.6/arch/arm/boot/dts/st/ |
| D | stm32mp15xx-dhcom-picoitx.dtsi | 46 * port power. This signal should be handled by USB power sequencing
|
1234
