Searched +full:sensorhub +full:- +full:rinato (Results 1 – 2 of 2) sorted by relevance
| /Linux-v6.1/Documentation/devicetree/bindings/iio/ |
| D | samsung,sensorhub-rinato.yaml | 1 # SPDX-License-Identifier: (GPL-2.0 OR BSD-2-Clause)
3 ---
4 $id: http://devicetree.org/schemas/iio/samsung,sensorhub-rinato.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
7 title: Samsung Sensorhub driver
10 - Jonathan Cameron <jic23@kernel.org>
13 Sensorhub is a MCU which manages several sensors and also plays the role
19 - samsung,sensorhub-rinato
20 - samsung,sensorhub-thermostat
28 ap-mcu-gpios:
[all …]
|
| /Linux-v6.1/drivers/iio/common/ssp_sensors/ |
| D | ssp_dev.c | 1 // SPDX-License-Identifier: GPL-2.0-or-later
55 .name = "ssp-accelerometer",
58 .name = "ssp-gyroscope",
64 gpiod_set_value(data->mcu_reset_gpiod, 0); in ssp_toggle_mcu_reset_gpio()
66 gpiod_set_value(data->mcu_reset_gpiod, 1); in ssp_toggle_mcu_reset_gpio()
75 if (data->available_sensors & BIT(i)) { in ssp_sync_available_sensors()
76 ret = ssp_enable_sensor(data, i, data->delay_buf[i]); in ssp_sync_available_sensors()
78 dev_err(&data->spi->dev, in ssp_sync_available_sensors()
86 data->mcu_dump_mode); in ssp_sync_available_sensors()
88 dev_err(&data->spi->dev, in ssp_sync_available_sensors()
[all …]
|
