Searched full:sensing (Results 1 – 25 of 150) sorted by relevance
123456
| /Linux-v6.1/Documentation/hwmon/ |
| D | max16065.rst | 100 Only if the chip supports current sensing and if
101 current sensing is enabled.
121 sensing and if current sensing is enabled.
126 sensing and if current sensing is enabled.
|
| /Linux-v6.1/Documentation/devicetree/bindings/sound/ |
| D | rt5663.txt | 27 The matrix row number of the impedance sensing table.
28 If the value is 0, it means the impedance sensing is not supported.
30 The matrix rows of the impedance sensing table are consisted by impedance
41 impedance in the impedance sensing function.
|
| /Linux-v6.1/Documentation/devicetree/bindings/input/ |
| D | iqs269a.yaml | 14 additional Hall-effect and inductive sensing capabilities.
37 Enables Hall-effect sensing on channels 6 and 7. In this case, keycodes
40 posed on channels 6 and 7 by Hall-effect sensing.
49 1: Low power (all sensing at a reduced reporting rate)
50 2: Ultra-low power (channel 0 proximity sensing)
51 3: Halt (no sensing)
172 Specifies the inductive sensing excitation frequency as follows (paren-
211 Represents a single sensing channel. A channel is active if defined and
291 sensing as follows:
302 Specifies the channel's sensing mode as follows:
[all …]
|
| D | iqs626a.yaml | 14 additional Hall-effect and inductive sensing capabilities.
44 1: Low power (all sensing at a reduced reporting rate)
45 2: Ultra-low power (ULP channel proximity sensing)
46 3: Halt (no sensing)
173 Represents a single sensing channel. A channel is active if defined and
269 sensing as follows:
281 Specifies the channel's sensing frequency as follows (parenthesized
299 description: Enables projected-capacitance sensing (ULP channel only).
377 Specifies the channel's sensing mode as follows:
394 Specifies the inductive sensing excitation frequency as follows
[all …]
|
| D | azoteq,iqs7222.yaml | 14 controllers that feature additional sensing capabilities.
179 description: Represents a conversion cycle serving two sensing channels.
219 description: Enables the bias voltage for use during inductive sensing.
225 Specifies the cycle's sensing mode as follows:
232 Hall-effect sensing.
237 Enables the current reference for use during various sensing modes.
260 Represents a single sensing channel. A channel is active if defined and
264 Hall-effect sensing with events reported on channel 10 only.
343 capacitive sensing as follows:
|
| /Linux-v6.1/drivers/input/mouse/ |
| D | sentelic.h | 3 * Finger Sensing Pad PS/2 mouse driver.
12 /* Finger-sensing Pad information registers */
20 /* Finger-sensing Pad control registers */
63 /* Finger-sensing Pad packet formating related definitions */
|
| /Linux-v6.1/drivers/thermal/tegra/ |
| D | Kconfig | 15 tristate "Tegra BPMP thermal sensing"
18 Enable this option for support for sensing system temperature of NVIDIA
|
| /Linux-v6.1/drivers/iio/chemical/ |
| D | Kconfig | 44 temperature, pressure, humidity and gas sensing capability.
94 dioxide, relative humidity and temperature sensing capabilities.
129 dioxide, relative humidity and temperature sensing capabilities.
|
| /Linux-v6.1/Documentation/ABI/testing/ |
| D | sysfs-bus-iio-light-isl29018 | 19 0 Sensing IR from LED and ambient
20 1 Sensing IR from LED with ambient IR rejection
|
| /Linux-v6.1/Documentation/devicetree/bindings/iio/adc/ |
| D | aspeed,ast2600-adc.yaml | 25 • Integrate dividing circuit for battery sensing.
60 aspeed,battery-sensing:
|
| /Linux-v6.1/drivers/iio/light/ |
| D | Kconfig | 227 If you say yes here you get support for ambient light sensing and
228 proximity infrared sensing from Intersil ISL29018.
230 in lux, proximity infrared sensing and normal infrared sensing.
240 Proximity value via iio. The ISL29028 provides the concurrent sensing
|
| D | isl29018.c | 6 * sensing and infrared sensing.
232 /* Do proximity sensing with required scheme */ in isl29018_read_proximity_ir()
307 * Proximity Sensing Scheme: Bit 7. This bit programs the function
318 * 0 Sensing IR from LED and ambient
319 * 1 Sensing IR from LED with ambient IR rejection
|
| /Linux-v6.1/drivers/usb/phy/ |
| D | phy-gpio-vbus-usb.c | 3 * gpio-vbus.c - simple GPIO VBUS sensing driver for B peripheral devices
24 * A simple GPIO VBUS sensing driver for B peripheral only devices
260 /* Look up the VBUS sensing GPIO */ in gpio_vbus_probe()
281 * The VBUS sensing GPIO should have a pulldown, which will normally be in gpio_vbus_probe()
|
| D | Kconfig | 93 tristate "GPIO based peripheral-only VBUS sensing 'transceiver'"
98 Provides simple GPIO VBUS sensing for controllers with an
|
| /Linux-v6.1/drivers/iio/adc/ |
| D | aspeed_adc.c | 58 * circuit for battery sensing.
230 * Enable compensating sensing: in aspeed_adc_compensation()
240 * After enable compensating sensing mode need to wait some time for ADC stable in aspeed_adc_compensation()
298 * After enable battery sensing mode need to wait some time for adc stable in aspeed_adc_read_raw()
572 if (of_find_property(data->dev->of_node, "aspeed,battery-sensing", in aspeed_adc_probe()
586 "Failed to enable battery-sensing mode\n"); in aspeed_adc_probe()
|
| /Linux-v6.1/drivers/iio/accel/ |
| D | Kconfig | 522 tristate "Freescale MMA9551L Intelligent Motion-Sensing Platform Driver"
528 Intelligent Motion-Sensing Platform Driver.
571 tristate "Memsic MXC6255 Orientation Sensing Accelerometer Driver"
576 Sensing Accelerometer Driver.
|
| D | mxc6255.c | 3 * MXC6255 - MEMSIC orientation sensing accelerometer
194 MODULE_DESCRIPTION("MEMSIC MXC6255 orientation sensing accelerometer driver");
|
| /Linux-v6.1/sound/firewire/tascam/ |
| D | tascam.h | 140 // sensing: 0x0b
143 // fader and knob, bitmasks for button and sensing.
|
| /Linux-v6.1/Documentation/s390/ |
| D | common_io.rst | 20 and device sensing will be done on any of those devices. The subchannel to
76 When a device is un-ignored, device recognition and sensing is performed and
|
| /Linux-v6.1/sound/soc/codecs/ |
| D | mt6660.c | 112 /* voltage sensing enable */ in mt6660_codec_classd_event()
117 "enable voltage sensing fail\n"); in mt6660_codec_classd_event()
124 /* voltage sensing disable */ in mt6660_codec_classd_event()
129 "disable voltage sensing fail\n"); in mt6660_codec_classd_event()
|
| /Linux-v6.1/Documentation/devicetree/bindings/hwmon/ |
| D | lm87.txt | 11 remote temperature sensing channel. By default the pins
|
| D | max31785.txt | 9 management with temperature and remote voltage sensing. Various fan control
|
| /Linux-v6.1/Documentation/devicetree/bindings/iio/light/ |
| D | noa1305.yaml | 13 Ambient sensing with an i2c interface.
|
| D | tsl2583.yaml | 13 Ambient light sensing with an i2c interface.
|
| D | liteon,ltrf216a.yaml | 13 Ambient light sensing with an i2c interface.
|
123456
