| /Linux-v5.10/Documentation/devicetree/bindings/serial/ |
| D | rs485.yaml | 23 milliseconds. It corresponds to the delay before sending data.
27 It corresponds to the delay after sending data and actual release
33 description: drive RTS low when sending (default is high).
42 description: enables the receiving of data even while sending data.
|
| /Linux-v5.10/drivers/hv/ |
| D | hv_trace.h | 130 TP_printk("sending ret %d", __entry->ret)
152 TP_printk("sending child_relid 0x%x, openid %d, "
171 TP_printk("sending child_relid 0x%x, ret %d", __entry->child_relid,
192 TP_printk("sending child_relid 0x%x, gpadl 0x%x, range_buflen %d "
212 TP_printk("sending msgnumber %d, gpadl 0x%x, ret %d",
230 TP_printk("sending child_relid 0x%x, gpadl 0x%x, ret %d",
254 TP_printk("sending vmbus_version_requested %d, target_vcpu 0x%x, "
272 TP_printk("sending child_relid 0x%x, ret %d",
291 TP_printk("sending guest_endpoint_id %pUl, host_service_id %pUl, "
|
| /Linux-v5.10/drivers/net/wireguard/ |
| D | send.c | 30 net_dbg_ratelimited("%s: Sending handshake initiation to peer %llu (%pISpfsc)\n", in wg_packet_send_handshake_initiation()
90 net_dbg_ratelimited("%s: Sending handshake response to peer %llu (%pISpfsc)\n", in wg_packet_send_handshake_response()
116 net_dbg_skb_ratelimited("%s: Sending cookie response for denied handshake message for %pISpfsc\n", in wg_packet_send_handshake_cookie()
131 send = keypair && READ_ONCE(keypair->sending.is_valid) && in keep_key_fresh()
134 wg_birthdate_has_expired(keypair->sending.birthdate, REKEY_AFTER_TIME))); in keep_key_fresh()
218 keypair->sending.key); in encrypt_packet()
234 net_dbg_ratelimited("%s: Sending keepalive packet to peer %llu (%pISpfsc)\n", in wg_packet_send_keepalive()
371 if (unlikely(!READ_ONCE(keypair->sending.is_valid))) in wg_packet_send_staged_packets()
373 if (unlikely(wg_birthdate_has_expired(keypair->sending.birthdate, in wg_packet_send_staged_packets()
400 WRITE_ONCE(keypair->sending.is_valid, false); in wg_packet_send_staged_packets()
|
| /Linux-v5.10/Documentation/driver-api/serial/ |
| D | serial-rs485.rst | 68 /* Set logical level for RTS pin equal to 1 when sending: */
70 /* or, set logical level for RTS pin equal to 0 when sending: */
73 /* Set logical level for RTS pin equal to 1 after sending: */
75 /* or, set logical level for RTS pin equal to 0 after sending: */
84 /* Set this flag if you want to receive data even while sending data */
|
| /Linux-v5.10/net/dccp/ccids/ |
| D | Kconfig | 21 where a flow is "reasonably fair" if its sending rate is generally
22 within a factor of two of the sending rate of a TCP flow under the
26 relatively smooth sending rate is of importance.
|
| /Linux-v5.10/include/uapi/linux/ |
| D | if_pppol2tp.h | 35 __u16 d_tunnel, d_session; /* For sending outgoing packets */
47 __u16 d_tunnel, d_session; /* For sending outgoing packets */
63 __u32 d_tunnel, d_session; /* For sending outgoing packets */
72 __u32 d_tunnel, d_session; /* For sending outgoing packets */
|
| /Linux-v5.10/drivers/hid/intel-ish-hid/ishtp/ |
| D | client.h | 21 /* Number of IPC fragments after which it's worth sending via DMA */
77 * are at the middle of sending.
78 * if so -need to increase FC counter, otherwise, need to start sending
83 int sending; member
|
| /Linux-v5.10/drivers/scsi/device_handler/ |
| D | scsi_dh_hp_sw.c | 66 "%s: sending tur failed, sense %x/%x/%x\n", in tur_done()
97 "%s: sending tur failed with %x\n", in hp_sw_tur()
115 * Sending START STOP UNIT activates the SP.
133 "%s: sending start_stop_unit failed, " in hp_sw_start_stop()
153 "%s: sending start_stop_unit failed, " in hp_sw_start_stop()
|
| /Linux-v5.10/drivers/net/wireless/ath/wcn36xx/ |
| D | smd.c | 658 wcn36xx_err("Sending hal_start failed\n"); in wcn36xx_smd_start()
687 wcn36xx_err("Sending hal_stop failed\n"); in wcn36xx_smd_stop()
725 wcn36xx_err("Sending hal_init_scan failed\n"); in wcn36xx_smd_init_scan()
755 wcn36xx_err("Sending hal_start_scan failed\n"); in wcn36xx_smd_start_scan()
785 wcn36xx_err("Sending hal_end_scan failed\n"); in wcn36xx_smd_end_scan()
826 wcn36xx_err("Sending hal_finish_scan failed\n"); in wcn36xx_smd_finish_scan()
898 wcn36xx_err("Sending hal_start_scan_offload failed\n"); in wcn36xx_smd_start_hw_scan()
926 wcn36xx_err("Sending hal_stop_scan_offload failed\n"); in wcn36xx_smd_stop_hw_scan()
972 wcn36xx_err("Sending hal_switch_channel failed\n"); in wcn36xx_smd_switch_channel()
1034 wcn36xx_err("Sending hal_process_ptt_msg failed\n"); in wcn36xx_smd_process_ptt_msg()
[all …]
|
| /Linux-v5.10/Documentation/process/ |
| D | email-clients.rst | 61 and successfully apply it with 'patch' before sending patches to Linux
68 Here are some specific MUA configuration hints for editing and sending
83 In the :menuselection:`Sending Preferences` section:
86 - :menuselection:`Strip Whitespace Before Sending` must be ``disabled``
146 KMail 1.13.5 (KDE 4.5.4), KMail will apply word wrapping when sending
149 long lines, you must make the composer window very wide before sending
319 Does not work for sending patches.
|
| /Linux-v5.10/drivers/staging/media/zoran/ |
| D | TODO | 12 Note: only recent ffmpeg has the ability of sending non-raw video via v4l2
14 The original way of sending video was via mplayer vo_zr/vo_zr2, but it does not compile
|
| /Linux-v5.10/drivers/gpu/drm/panel/ |
| D | panel-samsung-s6e63m0-dsi.c | 59 dev_err(dev, "error sending DCS command seq cmd %02x\n", cmd); in s6e63m0_dsi_dcs_write()
71 dev_err(dev, "error sending CMD %02x global param %02x\n", in s6e63m0_dsi_dcs_write()
77 dev_err(dev, "error sending CMD %02x chunk\n", cmd); in s6e63m0_dsi_dcs_write()
|
| /Linux-v5.10/Documentation/timers/ |
| D | no_hz.rst | 68 If a CPU is idle, there is little point in sending it a scheduling-clock
73 The CONFIG_NO_HZ_IDLE=y Kconfig option causes the kernel to avoid sending
81 is strong motivation to avoid sending scheduling-clock interrupts to
107 If a CPU has only one runnable task, there is little point in sending it
113 sending scheduling-clock interrupts to CPUs with a single runnable task,
122 again strong motivation to avoid sending scheduling-clock interrupts.
271 this CPU, so there is no point in sending a scheduling-clock
|
| /Linux-v5.10/include/trace/events/ |
| D | fsi_master_ast_cf.h | 113 TP_printk("fsi-acf%d: Sending ABS_ADR %06x",
129 TP_printk("fsi-acf%d: Sending REL_ADR %03x",
143 TP_printk("fsi-acf%d: Sending SAME_ADR",
|
| D | fsi_master_gpio.h | 137 TP_printk("fsi-gpio%d: Sending ABS_ADR %06x",
152 TP_printk("fsi-gpio%d: Sending REL_ADR %03x",
165 TP_printk("fsi-gpio%d: Sending SAME_ADR",
|
| /Linux-v5.10/drivers/infiniband/core/ |
| D | smi.c | 126 * Fixup a directed route SMP for sending
180 /* hop_ptr updated when sending */ in __smi_handle_dr_smp_recv()
189 /* hop_ptr updated when sending */ in __smi_handle_dr_smp_recv()
214 /* hop_ptr updated when sending */ in __smi_handle_dr_smp_recv()
226 /* hop_ptr updated when sending */ in __smi_handle_dr_smp_recv()
|
| /Linux-v5.10/include/linux/ |
| D | tfrc.h | 17 * @tfrcrx_x_recv: receiver estimate of sending rate (3.2.2)
38 * enables a finer resolution of sending rates and avoids problems with
|
| /Linux-v5.10/drivers/platform/chrome/wilco_ec/ |
| D | keyboard_leds.c | 72 "Failed sending keyboard LEDs command: %d\n", ret); in send_kbbl_msg()
97 "EC reported failure sending keyboard LEDs command: %d\n", in set_kbbl()
150 "EC reported failure sending keyboard LEDs command: %d\n", in kbbl_init()
|
| /Linux-v5.10/net/llc/ |
| D | llc_if.c | 30 * llc_build_and_send_pkt - Connection data sending for upper layers.
35 * connection oriented communication mode. During sending data, connection
38 * closed and -EBUSY when sending data is not permitted in this state or
|
| /Linux-v5.10/drivers/net/wireless/rsi/ |
| D | rsi_91x_mgmt.c | 385 rsi_dbg(INFO_ZONE, "%s: Sending rate symbol req frame\n", __func__); in rsi_load_radio_caps()
546 rsi_dbg(MGMT_TX_ZONE, "%s: Sending sta notify frame\n", __func__); in rsi_hal_send_sta_notify_frame()
633 rsi_dbg(MGMT_TX_ZONE, "%s: Sending AMPDU indication frame\n", __func__); in rsi_send_aggregation_params_frame()
670 rsi_dbg(MGMT_TX_ZONE, "%s: Sending program BB/RF frame\n", __func__); in rsi_program_bb_rf()
724 rsi_dbg(MGMT_TX_ZONE, "%s: Sending VAP capabilities frame\n", __func__); in rsi_set_vap_capabilities()
807 rsi_dbg(MGMT_TX_ZONE, "%s: Sending load key frame\n", __func__); in rsi_hal_load_key()
875 rsi_dbg(MGMT_TX_ZONE, "Sending common device config params\n"); in rsi_send_common_dev_params()
920 rsi_dbg(MGMT_TX_ZONE, "%s: Sending boot params frame\n", __func__); in rsi_load_bootup_params()
975 rsi_dbg(MGMT_TX_ZONE, "%s: Sending boot params frame\n", __func__); in rsi_load_9116_bootup_params()
1026 rsi_dbg(MGMT_TX_ZONE, "%s: Sending reset MAC frame\n", __func__); in rsi_send_reset_mac()
[all …]
|
| /Linux-v5.10/include/net/caif/ |
| D | caif_layer.h | 39 * should stop sending data
42 * can start sending data
83 * can start sending data.
86 * should stop sending data.
|
| /Linux-v5.10/Documentation/networking/device_drivers/ethernet/huawei/ |
| D | hinic.rst | 58 Application Programmable Interface commands(API CMD) - Interface for sending
61 Management (MGMT) - the PF to MGMT channel that uses API CMD for sending MGMT
77 Command Queues(CMDQ) - The queues for sending commands for IO management and is
|
| /Linux-v5.10/Documentation/userspace-api/media/rc/ |
| D | lirc-dev-intro.rst | 49 LIRC supports some modes of receiving and sending IR codes, as shown
58 This mode is for both sending and receiving IR.
60 For transmitting (aka sending), create a ``struct lirc_scancode`` with
|
| /Linux-v5.10/Documentation/devicetree/bindings/iio/proximity/ |
| D | devantech-srf04.yaml | 14 - trigger-gpio is raised by the driver to start sending out an ultrasonic
16 - echo-gpio is held high by the sensor after sending ultrasonic burst
|
| /Linux-v5.10/Documentation/hid/ |
| D | uhid.rst | 48 The first thing you should do is sending an UHID_CREATE2 event. This will
50 start sending data to and reading data from UHID. However, unless UHID sends the
99 You can create a new device by sending UHID_CREATE2 again. There is no need to
103 You must send UHID_CREATE2 before sending input to the kernel! This event
|
