Home
last modified time | relevance | path

Searched +full:sdtv +full:- +full:standards (Results 1 – 14 of 14) sorted by relevance

/Linux-v5.15/Documentation/devicetree/bindings/display/connector/
Danalog-tv-connector.yaml1 # SPDX-License-Identifier: GPL-2.0-only
3 ---
4 $id: http://devicetree.org/schemas/display/connector/analog-tv-connector.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Laurent Pinchart <Laurent.pinchart@ideasonboard.com>
15 - composite-video-connector
16 - svideo-connector
20 sdtv-standards:
22 Limit the supported TV standards on a connector to the given ones. If
23 not specified all TV standards are allowed. Possible TV standards are
[all …]
/Linux-v5.15/Documentation/devicetree/bindings/media/i2c/
Dtvp5150.txt4 (and also SECAM in the TVP5151 case) video signals to either 8-bit 4:2:2 YUV
5 with discrete syncs or 8-bit ITU-R BT.656 with embedded syncs output formats.
9 - compatible: Value must be "ti,tvp5150".
10 - reg: I2C slave address.
14 - pdn-gpios: Phandle for the GPIO connected to the PDN pin, if any.
15 - reset-gpios: Phandle for the GPIO connected to the RESETB pin, if any.
19 Documentation/devicetree/bindings/media/video-interfaces.txt. The port nodes
23 --------------------------------------
26 Y-OUT src 2
32 tvp-5150 port@0 (AIP1A)
[all …]
/Linux-v5.15/samples/v4l/
Dv4l2-pci-skeleton.c5 * This skeleton PCI driver assumes that the card has an S-Video connector as
33 #include <linux/v4l2-dv-timings.h>
34 #include <media/v4l2-device.h>
35 #include <media/v4l2-dev.h>
36 #include <media/v4l2-ioctl.h>
37 #include <media/v4l2-dv-timings.h>
38 #include <media/v4l2-ctrls.h>
39 #include <media/v4l2-event.h>
40 #include <media/videobuf2-v4l2.h>
41 #include <media/videobuf2-dma-contig.h>
[all …]
/Linux-v5.15/include/uapi/linux/
Dvideodev2.h1 /* SPDX-License-Identifier: ((GPL-2.0+ WITH Linux-syscall-note) OR BSD-3-Clause) */
5 * Copyright (C) 1999-2012 the contributors
47 * All kernel-specific stuff were moved to media/v4l2-dev.h, so
66 #include <linux/v4l2-common.h>
67 #include <linux/v4l2-controls.h>
80 /* Four-character-code (FOURCC) */
98 buffer, top-bottom order */
99 V4L2_FIELD_SEQ_BT = 6, /* same as above + bottom-top order */
202 /* SMPTE 170M: used for broadcast NTSC/PAL SDTV */
205 /* Obsolete pre-1998 SMPTE 240M HDTV standard, superseded by Rec 709 */
[all …]
/Linux-v5.15/arch/arm/boot/dts/
Dimx6dl-victgo.dts1 // SPDX-License-Identifier: GPL-2.0-or-later OR MIT
7 /dts-v1/;
8 #include <dt-bindings/display/sdtv-standards.h>
9 #include <dt-bindings/gpio/gpio.h>
10 #include <dt-bindings/input/input.h>
11 #include <dt-bindings/leds/common.h>
12 #include <dt-bindings/media/tvp5150.h>
13 #include <dt-bindings/sound/fsl-imx-audmux.h>
21 stdout-path = &uart4;
25 compatible = "pwm-backlight";
[all …]
Dimx6qdl-vicut1.dtsi1 // SPDX-License-Identifier: GPL-2.0-or-later OR MIT
7 #include <dt-bindings/display/sdtv-standards.h>
8 #include <dt-bindings/gpio/gpio.h>
9 #include <dt-bindings/input/input.h>
10 #include <dt-bindings/leds/common.h>
11 #include <dt-bindings/media/tvp5150.h>
12 #include <dt-bindings/sound/fsl-imx-audmux.h>
16 stdout-path = &uart4;
20 compatible = "pwm-backlight";
21 pinctrl-names = "default";
[all …]
Dimx6dl-prtmvt.dts1 // SPDX-License-Identifier: GPL-2.0-or-later OR MIT
7 /dts-v1/;
8 #include <dt-bindings/display/sdtv-standards.h>
9 #include <dt-bindings/gpio/gpio.h>
10 #include <dt-bindings/input/input.h>
11 #include <dt-bindings/leds/common.h>
12 #include <dt-bindings/media/tvp5150.h>
13 #include <dt-bindings/sound/fsl-imx-audmux.h>
21 stdout-path = &uart4;
25 compatible = "pwm-backlight";
[all …]
/Linux-v5.15/drivers/media/platform/davinci/
Dvpif.c2 * vpif - Video Port Interface driver
5 * The hardware supports SDTV, HDTV formats, raw data capture.
6 * Currently, the driver supports NTSC and PAL standards.
8 * Copyright (C) 2009 Texas Instruments Incorporated - https://www.ti.com/
28 #include <linux/v4l2-dv-timings.h>
63 .eav2sav = 138-8,
80 .eav2sav = 144-8,
97 .eav2sav = 700-8,
114 .eav2sav = 370 - 8,
131 .eav2sav = 720 - 8,
[all …]
/Linux-v5.15/include/media/
Dv4l2-fwnode.h1 /* SPDX-License-Identifier: GPL-2.0-only */
8 * Copyright (C) 2012 - 2013 Samsung Electronics Co., Ltd.
22 #include <media/v4l2-mediabus.h>
31 * struct v4l2_fwnode_bus_mipi_csi2 - MIPI CSI-2 bus data structure
48 * struct v4l2_fwnode_bus_parallel - parallel data bus data structure
60 * struct v4l2_fwnode_bus_mipi_csi1 - CSI-1/CCP2 data bus structure
62 * false - not inverted, true - inverted
63 * @strobe: false - data/clock, true - data/strobe
78 * struct v4l2_fwnode_endpoint - the endpoint data structure
112 * V4L2_FWNODE_PROPERTY_UNSET - identify a non initialized property
[all …]
/Linux-v5.15/drivers/media/usb/hdpvr/
Dhdpvr-video.c1 // SPDX-License-Identifier: GPL-2.0-only
3 * Hauppauge HD PVR USB driver - video 4 linux 2 interface
19 #include <linux/v4l2-dv-timings.h>
20 #include <media/v4l2-dev.h>
21 #include <media/v4l2-common.h>
22 #include <media/v4l2-dv-timings.h>
23 #include <media/v4l2-ioctl.h>
24 #include <media/v4l2-event.h>
30 v4l2_dbg(MSG_BUFFER, hdpvr_debug, &dev->v4l2_dev, \
33 list_size(&dev->free_buff_list), \
[all …]
/Linux-v5.15/drivers/media/v4l2-core/
Dv4l2-fwnode.c1 // SPDX-License-Identifier: GPL-2.0-only
6 * formerly was located in v4l2-of.c.
11 * Copyright (C) 2012 - 2013 Samsung Electronics Co., Ltd.
27 #include <media/v4l2-async.h>
28 #include <media/v4l2-fwnode.h>
29 #include <media/v4l2-subdev.h>
43 "MIPI CSI-2 C-PHY",
47 "MIPI CSI-1",
55 "MIPI CSI-2 D-PHY",
85 return conv ? conv->mbus_type : V4L2_MBUS_INVALID; in v4l2_fwnode_bus_type_to_mbus()
[all …]
/Linux-v5.15/drivers/media/test-drivers/vivid/
Dvivid-ctrls.c1 // SPDX-License-Identifier: GPL-2.0-only
3 * vivid-ctrls.c - control support functions.
11 #include <media/v4l2-event.h>
12 #include <media/v4l2-common.h>
14 #include "vivid-core.h"
15 #include "vivid-vid-cap.h"
16 #include "vivid-vid-out.h"
17 #include "vivid-vid-common.h"
18 #include "vivid-radio-common.h"
19 #include "vivid-osd.h"
[all …]
/Linux-v5.15/drivers/media/usb/em28xx/
Dem28xx-cards.c1 // SPDX-License-Identifier: GPL-2.0+
3 // em28xx-cards.c - driver for Empia EM2800/EM2820/2840 USB
31 #include <media/drv-intf/msp3400.h>
33 #include <dt-bindings/media/tvp5150.h>
36 #include <media/v4l2-common.h>
41 static int tuner = -1;
54 static unsigned int card[] = {[0 ... (EM28XX_MAXBOARDS - 1)] = -1U };
58 static int usb_xfer_mode = -1;
61 "USB transfer mode for frame data (-1 = auto, 0 = prefer isoc, 1 = prefer bulk)");
63 /* Bitmask marking allocated devices from 0 to EM28XX_MAXBOARDS - 1 */
[all …]
/Linux-v5.15/drivers/gpu/drm/amd/display/amdgpu_dm/
Damdgpu_dm.c145 switch (link->dpcd_caps.dongle_type) { in get_subconnector_type()
164 struct dc_link *link = aconnector->dc_link; in update_subconnector_property()
165 struct drm_connector *connector = &aconnector->base; in update_subconnector_property()
168 if (connector->connector_type != DRM_MODE_CONNECTOR_DisplayPort) in update_subconnector_property()
171 if (aconnector->dc_sink) in update_subconnector_property()
174 drm_object_property_set_value(&connector->base, in update_subconnector_property()
175 connector->dev->mode_config.dp_subconnector_property, in update_subconnector_property()
228 * struct amdgpu_device *adev - [in] desired amdgpu device
229 * int disp_idx - [in] which CRTC to get the counter from
236 if (crtc >= adev->mode_info.num_crtc) in dm_vblank_get_counter()
[all …]