Searched full:reception (Results 1 – 25 of 422) sorted by relevance
12345678910>>...17
| /Linux-v6.6/Documentation/ABI/stable/ |
| D | firewire-cdev | 28 - Isochronous stream transmission and reception
29 - Asynchronous stream transmission and reception
31 - PHY packet transmission and reception
37 - Bus reset initiation, bus reset event reception
42 link layers, reception of inbound requests to such
55 - PHY packet transmission and reception
80 request reception, or PHY packet reception. Always use a read
83 of all event types and for which ioctls affect reception of
87 Allocate a DMA buffer for isochronous reception or transmission
91 prot = at least PROT_READ for reception and at least PROT_WRITE
[all …]
|
| /Linux-v6.6/drivers/staging/pi433/Documentation/ |
| D | pi433.txt | 9 (www.pi433.de). It supports transmission and reception. It can be opened
10 by multiple applications for transmission and reception. While transmit
12 application asking for reception will block out all other applications
40 b) reception
43 reception there is only one configuration set.
44 As soon as an application sets a request for receiving a telegram, the reception
47 receiver) is reached. Until this hasn't happened, the reception can be
52 read. So also for reception it is possible to receive more data than the hardware
181 If this value is exceeded, a reception cycle starts
|
| /Linux-v6.6/Documentation/networking/device_drivers/can/freescale/ |
| D | flexcan.rst | 10 On/off RTR frames reception
27 As reception of RTR frames is part of the CAN standard, all flexcan
28 cores come up in a mode where RTR reception is possible.
|
| /Linux-v6.6/Documentation/userspace-api/media/v4l/ |
| D | vidioc-g-tuner.rst | 246 - Stereo audio reception is supported.
249 - Reception of the primary language of a bilingual audio program is
256 - Reception of the secondary language of a bilingual audio program
261 - Reception of a secondary audio program is supported. This is a
303 .. flat-table:: Tuner Audio Reception Flags
361 stereo reception the driver shall fall back to ``MODE_MONO``.
369 bilingual audio or SAP, or their reception is not supported the
375 bilingual audio or SAP, or their reception is not supported the
|
| D | ext-ctrls-fm-rx.rst | 10 FM Reception capable devices.
24 Enables/disables RDS reception by the radio tuner
71 Configures the de-emphasis value for reception. A de-emphasis filter
|
| /Linux-v6.6/Documentation/ABI/testing/ |
| D | sysfs-class-led-trigger-netdev | 55 Signal reception of data on the named network device.
57 If set to 0 (default), the LED will not blink on reception.
60 in interval to signal reception.
|
| /Linux-v6.6/net/rxrpc/ |
| D | Kconfig | 40 bool "Inject delay into packet reception"
43 Say Y here to inject a delay into packet reception, allowing an
|
| /Linux-v6.6/include/uapi/linux/ |
| D | firewire-cdev.h | 314 * isochronous reception. In version 1 of the ABI, &header_length was 0.
372 * - trailer quadlet, containing the reception timestamp as described at
618 * As a side effect, reception of %FW_CDEV_EVENT_BUS_RESET events to be read(2)
806 * @header_size: Header size to strip in single-channel reception
807 * @channel: Channel to bind to in single-channel reception or transmission
819 * In case of multichannel reception, @header_size and @channel are ignored
846 * struct fw_cdev_set_iso_channels - Select channels in multichannel reception
933 * for single-channel reception.
950 * Queue a number of isochronous packets for reception or transmission.
978 * struct fw_cdev_start_iso - Start an isochronous transmission or reception
[all …]
|
| /Linux-v6.6/drivers/i2c/busses/ |
| D | i2c-stm32f4.c | 406 * For 2-byte reception, 3-byte reception and for Data N-2, N-1 and N in stm32f4_i2c_handle_read()
407 * for N-byte reception with N > 3, we do not have to read the data in stm32f4_i2c_handle_read()
418 * For N byte reception with N > 3 we directly read data register in stm32f4_i2c_handle_read()
500 * Single byte reception: in stm32f4_i2c_handle_rx_addr()
520 * 2-byte reception: in stm32f4_i2c_handle_rx_addr()
536 * N-byte reception: in stm32f4_i2c_handle_rx_addr()
608 * - in reception : a new byte is received in the shift register in stm32f4_i2c_isr_event()
|
| /Linux-v6.6/drivers/spi/ |
| D | spi-slave-time.c | 2 * SPI slave handler reporting uptime at reception of previous SPI message
4 * This SPI slave handler sends the time of reception of the last SPI message
|
| /Linux-v6.6/tools/testing/selftests/drivers/net/ocelot/ |
| D | tc_flower_chains.sh | 206 check_err "$?" "untagged reception"
229 check_err "$?" "tagged reception"
262 check_err "$?" "tagged reception"
302 check_err "$?" "tagged reception"
|
| /Linux-v6.6/drivers/net/wireless/ath/ath5k/ |
| D | desc.h | 54 #define AR5K_5210_RX_DESC_STATUS0_RECEIVE_RATE 0x00078000 /* reception rate */
63 #define AR5K_5210_RX_DESC_STATUS1_FRAME_RECEIVE_OK 0x00000002 /* reception success */
81 #define AR5K_5212_RX_DESC_STATUS0_RECEIVE_RATE 0x000f8000 /* reception rate */
90 #define AR5K_5212_RX_DESC_STATUS1_FRAME_RECEIVE_OK 0x00000002 /* frame reception success */
|
| /Linux-v6.6/drivers/net/ethernet/i825xx/ |
| D | ether1.h | 193 #define SCB_CMDRXRESUME (2 << 4) /* Resume reception */
194 #define SCB_CMDRXSUSPEND (3 << 4) /* Suspend reception */
195 #define SCB_CMDRXABORT (4 << 4) /* Abort reception */
|
| /Linux-v6.6/Documentation/networking/device_drivers/can/ |
| D | can327.rst | 128 - Reception mode
214 reception mode on its own and can327 will fall back to "``AT MA``"
232 we don't poll it as it would force us to interrupt reception mode.
|
| /Linux-v6.6/drivers/media/common/siano/ |
| D | smscoreapi.h | 682 /* Reception quality */
807 /* Reception quality */
820 u32 partial_reception; /* TRUE - partial reception, FALSE otherwise */
849 /* Reception quality */
862 u32 partial_reception; /* TRUE - partial reception, FALSE otherwise */
1006 /* Reception */
1019 /* Reception */
|
| /Linux-v6.6/drivers/input/serio/ |
| D | maceps2.c | 35 #define PS2_STATUS_RX_INPROGRESS BIT(5) /* reception in progress */
43 #define PS2_CONTROL_RX_CLOCK_ENABLE BIT(4) /* pause reception if set to 0 */
|
| /Linux-v6.6/Documentation/devicetree/bindings/sound/ |
| D | sirf-audio-port.txt | 11 named "tx") and one for reception (should be named "rx").
|
| D | brcm,bcm2835-i2s.txt | 12 named "tx") and one for reception (should be named "rx").
|
| /Linux-v6.6/drivers/nfc/ |
| D | mei_phy.h | 26 * @recv_req_id: reception message counter
|
| /Linux-v6.6/Documentation/networking/ |
| D | can.rst | 164 transmission and reception of media dependent frames. Due to the
166 may be delayed by the reception of a high prio CAN frame. To
201 errors may be selected. The reception of error messages is disabled
395 at the reception of a CAN frame.
472 The reception of CAN frames using CAN_RAW sockets can be controlled
507 To disable the reception of CAN frames on the selected CAN_RAW socket:
522 reception time. To reduce the number of checks that need to be performed
599 needs. The reception of the CAN frames on the same socket that was
611 Note that reception of a socket's own CAN frames are subject to the same
929 is activated directly - even without a former CAN frame reception.
[all …]
|
| /Linux-v6.6/net/can/ |
| D | isotp.c | 7 * - RX path timeout of data reception leads to -ETIMEDOUT
9 * - RX path data reception with wrong padding leads to -EBADMSG
10 * - TX path flowcontrol reception timeout leads to -ECOMM
11 * - TX path flowcontrol reception overflow leads to -EMSGSIZE
12 * - TX path flowcontrol reception with wrong layout/padding leads to -EBADMSG
16 * is done at FF reception time (no support for sending 'wait frames')
187 /* no broadcast modes => register rx_id for FC frame reception */ in isotp_register_rxid()
535 /* initial setup for this pdu reception */ in isotp_rcv_ff()
658 /* if enabled: check reception of my configured extended address */ in isotp_rcv()
665 * CAN frame reception time. This locking is not needed in real world in isotp_rcv()
|
| /Linux-v6.6/include/media/ |
| D | tuner-types.h | 85 * then set PORT1 to 1 to get proper FM reception.
88 * then set PORT2 to 1 to get proper FM reception.
|
| /Linux-v6.6/drivers/net/ethernet/samsung/sxgbe/ |
| D | sxgbe_desc.h | 270 /* Return the reception status looking at the RDES1 */
280 /* Return the reception status looking at Context control information */
|
| /Linux-v6.6/include/soc/fsl/qe/ |
| D | ucc_fast.h | 23 #define R_I 0x10000000 /* interrupt on reception */
36 #define R_I_S 0x1000 /* interrupt on reception */
|
| /Linux-v6.6/Documentation/userspace-api/media/rc/ |
| D | lirc-set-wideband-receiver.rst | 42 reduced range of reception.
|
12345678910>>...17
