Home
last modified time | relevance | path

Searched full:rated (Results 1 – 23 of 23) sorted by relevance

/Linux-v5.15/Documentation/hwmon/
Ddps920ab.rst47 curr2_rated_max Maximum rated output current
55 in2_rated_min Minimum rated output voltage
56 in2_rated_max Maximum rated output voltage
65 power2_rated_max Maximum rated output power
Dpmbus.rst210 inX_rated_min Minimum rated voltage.
212 inX_rated_max Maximum rated voltage.
233 currX_rated_max Maximum rated current.
249 powerX_rated_max Maximum rated power.
272 tempX_rated_min Minimum rated temperature.
274 tempX_rated_max Maximum rated temperature.
Dsysfs-interface.rst253 Minimum rated voltage.
260 Maximum rated voltage.
600 Minimum rated temperature.
607 Maximum rated temperature.
704 Minimum rated current.
711 Maximum rated current.
884 Minimum rated power.
891 Maximum rated power.
945 Minimum rated humidity.
952 Maximum rated humidity.
Dadt7410.rst50 The ADT7310/ADT7410 is a temperature sensor with rated temperature range of
/Linux-v5.15/Documentation/devicetree/bindings/input/
Dti,drv260x.txt30 - vib-rated-mv - The rated voltage of the actuator in millivolts.
45 vib-rated-mv = <3200>;
/Linux-v5.15/Documentation/devicetree/bindings/power/supply/
Dmaxim,ds2760.yaml35 rated-capacity-microamp-hours:
37 The rated capacity of the battery, in mAh.
/Linux-v5.15/drivers/power/supply/
Dds2760_battery.c44 MODULE_PARM_DESC(rated_capacity, "rated battery capacity, 10*mAh or index");
220 /* Some batteries have their rated capacity stored a N * 10 mAh, while
317 * maximum rated capacity. */ in ds2760_battery_read_status()
330 /* If the full_active_uAh value is not given, fall back to the rated in ds2760_battery_read_status()
722 "rated-capacity-microamp-hours", in w1_ds2760_add_slave()
741 /* set rated capacity from module param or device tree */ in w1_ds2760_add_slave()
/Linux-v5.15/arch/arm/boot/dts/
Dsun5i-reference-design-tablet.dtsi88 * The gsl1680 is rated at 400KHz and it will not work reliable at
90 * All other devices on this bus are also rated for 400KHz.
Dsun8i-reference-design-tablet.dtsi67 * The gsl1680 is rated at 400KHz and it will not work reliable at
Dimx53-qsb-common.dtsi132 /* CPU rated to 1GHz, not 1.2GHz as per the default settings */
Dsun8i-a83t-cubietruck-plus.dts308 * I/O is indirectly powered from DCDC1, through SW. It is rated
Dimx53-ppd.dts304 /* CPU rated to 1GHz, not 1.2GHz as per the default settings */
/Linux-v5.15/include/dt-bindings/regulator/
Dqcom,rpmh-regulator.h25 * %RPMH_REGULATOR_MODE_HPM: High power mode in which the full rated current
/Linux-v5.15/Documentation/networking/device_drivers/ethernet/ti/
Dcpsw.rst26 - TX queues must be rated starting from txq0 that has highest priority
28 - CBS shapers should be used with rated queues
172 // TX queues must be rated starting from 0, so set bws for tx0 and tx1
175 // Leave last 2 tx queues not rated.
403 // TX queues must be rated starting from 0, so set bws for tx0 and tx1 for Eth0
407 // Leave last 4 tx queues as not rated
/Linux-v5.15/drivers/input/misc/
Ddrv260x.c238 * Rated and Overdriver Voltages:
241 * and v is the rated or overdriver voltage of the actuator
511 error = device_property_read_u32(dev, "vib-rated-mv", &voltage); in drv260x_probe()
/Linux-v5.15/Documentation/driver-api/
Dregulator.rst144 consumers are rated for.
/Linux-v5.15/Documentation/devicetree/bindings/regulator/
Ddlg,da9121.yaml25 the rated current, this translates across the device range to per
/Linux-v5.15/Documentation/admin-guide/mm/
Dnumaperf.rst93 The values reported here correspond to the rated latency and bandwidth
/Linux-v5.15/kernel/time/
Dtick-common.c316 * Use the higher rated one, but prefer a CPU local device with a lower in tick_check_preferred()
/Linux-v5.15/arch/powerpc/platforms/powernv/
Docxl.c267 * can allocate a pro-rated number of actags to each function. in pnv_ocxl_get_actag()
/Linux-v5.15/drivers/scsi/
DKconfig1274 usually rated at 5 MB/s. 5 is a safe value here unless you know the
/Linux-v5.15/drivers/clk/
Dclk-qoriq.c990 * maximum rated core frequency. If this is an incorrect in create_one_cmux()
/Linux-v5.15/drivers/media/dvb-frontends/
Dstb0899_algo.c501 /* BETA values rated @ 99MHz */ in stb0899_dvbs_algo()