| /Linux-v5.10/include/uapi/linux/ |
| D | ultrasound.h | 45 * _GUS_RAMPRANGE - Sets limits for volume ramping (P1=low volume, P2=high volume)
46 * _GUS_RAMPRATE - Sets the speed for volume ramping (P1=scale, P2=rate)
47 * _GUS_RAMPMODE - Sets the volume ramping mode (P1=ramping mode)
48 * _GUS_RAMPON - Starts volume ramping (no parameters)
49 * _GUS_RAMPOFF - Stops volume ramping (no parameters)
|
| /Linux-v5.10/drivers/regulator/ |
| D | da9055-regulator.c | 176 * There are two voltage register set A & B for voltage ramping but in da9055_regulator_get_voltage_sel()
208 * we use default register set A for voltage ramping. in da9055_regulator_set_voltage_sel()
249 /* Select register set B for suspend voltage ramping. */ in da9055_regulator_set_suspend_voltage()
270 /* Select register set B for voltage ramping. */ in da9055_suspend_enable()
414 * set A/B for voltage ramping.
462 * regulator register set A/B for voltage ramping. in da9055_gpio_init()
472 * will be selected through GPI for voltage ramping. in da9055_gpio_init()
|
| /Linux-v5.10/drivers/cpufreq/ |
| D | pmac32-cpufreq.c | 115 /* ramping up, set voltage first */ in cpu_750fx_cpu_speed()
138 /* ramping down, set voltage last */ in cpu_750fx_cpu_speed()
158 /* ramping up, set voltage first */ in dfs_set_cpu_speed()
171 /* ramping down, set voltage last */ in dfs_set_cpu_speed()
194 /* If ramping up, set voltage first */ in gpios_set_cpu_speed()
216 /* If ramping down, set voltage last */ in gpios_set_cpu_speed()
|
| D | powernv-cpufreq.c | 62 * ramping down
63 * @elapsed_time: Time in ms spent in ramping down from
69 * @timer: Is used for ramping down if cpu goes idle for
613 * @highest_lpstate_idx: pstate from which its ramping down
616 * ramping down and the time elapsed in ramping down. It follows a quadratic
617 * equation which ensures that it reaches ramping down to pmin in 5sec.
780 * If its has been ramping down for more than MAX_RAMP_DOWN_TIME in powernv_cpufreq_target_index()
|
| /Linux-v5.10/sound/soc/codecs/ |
| D | da9055.c | 336 /* Gain ramping rate value */
617 /* Gain Ramping controls */
618 SOC_DOUBLE_R("Aux Gain Ramping Switch", DA9055_AUX_L_CTRL,
620 SOC_DOUBLE_R("Mixin Gain Ramping Switch", DA9055_MIXIN_L_CTRL,
622 SOC_DOUBLE_R("ADC Gain Ramping Switch", DA9055_ADC_L_CTRL,
624 SOC_DOUBLE_R("DAC Gain Ramping Switch", DA9055_DAC_L_CTRL,
626 SOC_DOUBLE_R("Headphone Gain Ramping Switch", DA9055_HP_L_CTRL,
628 SOC_SINGLE("Lineout Gain Ramping Switch", DA9055_LINE_CTRL, 5, 1, 0),
629 SOC_ENUM("Gain Ramping Rate", da9055_gain_ramping_rate),
|
| D | da7213.c | 89 /* Gain ramping rate value */
480 /* Gain Ramping controls */
481 SOC_DOUBLE_R("Aux Gain Ramping Switch", DA7213_AUX_L_CTRL,
484 SOC_DOUBLE_R("Mixin Gain Ramping Switch", DA7213_MIXIN_L_CTRL,
487 SOC_DOUBLE_R("ADC Gain Ramping Switch", DA7213_ADC_L_CTRL,
490 SOC_DOUBLE_R("DAC Gain Ramping Switch", DA7213_DAC_L_CTRL,
493 SOC_DOUBLE_R("Headphone Gain Ramping Switch", DA7213_HP_L_CTRL,
496 SOC_SINGLE("Lineout Gain Ramping Switch", DA7213_LINE_CTRL,
499 SOC_ENUM("Gain Ramping Rate", da7213_gain_ramp_rate),
|
| D | da7219-aad.c | 156 /* Ensure gain ramping at fastest rate */ in da7219_aad_hptest_work()
306 /* Restore gain ramping rate */ in da7219_aad_hptest_work()
|
| D | max98926.c | 68 { 0x2E, 0x02 }, /* Gain Ramping */
|
| D | da7219.c | 585 /* Gain ramping */
929 /* Ensure nominal gain ramping for DAPM sequence */ in da7219_gain_ramp_event()
2534 /* Default gain ramping */ in da7219_probe()
|
| D | max98925.c | 71 { 0x2E, 0x02 }, /* Gain Ramping */
|
| /Linux-v5.10/Documentation/devicetree/bindings/mfd/ |
| D | ti-lmu.txt | 29 - ramp-up-us: Current ramping from one brightness level to
32 - ramp-down-us: Current ramping from one brightness level to
|
| /Linux-v5.10/drivers/clk/ |
| D | clk-tango4.c | 65 writel(0x100, base + CPUCLK_DIV); /* disable frequency ramping */ in tango4_clkgen_setup()
|
| /Linux-v5.10/drivers/gpu/drm/amd/display/modules/inc/ |
| D | mod_freesync.h | 82 bool ramping; member
|
| /Linux-v5.10/Documentation/devicetree/bindings/sound/ |
| D | cs35l33.txt | 30 is not set then soft ramping will be disabled and ramp time would be
|
| /Linux-v5.10/Documentation/devicetree/bindings/regulator/ |
| D | regulator.yaml | 67 required due to the combination of internal ramping of the regulator
|
| /Linux-v5.10/drivers/gpu/drm/amd/display/dc/dce/ |
| D | dce_abm.c | 69 /* set ramping boundary */ in dce_abm_set_pipe()
|
| D | dce_dmcu.c | 412 /* Set initialized ramping boundary value */ in dcn10_dmcu_init()
415 /* Set backlight ramping stepsize */ in dcn10_dmcu_init()
|
| /Linux-v5.10/drivers/gpu/drm/amd/display/modules/freesync/ |
| D | freesync.c | 953 in_out_vrr->fixed.ramping_active = in_config->ramping; in mod_freesync_build_vrr_params()
1000 /* Do not update vtotals if ramping is already active in mod_freesync_build_vrr_params()
1128 /* Gradual Static Screen Ramping Logic */ in mod_freesync_handle_v_update()
|
| /Linux-v5.10/include/sound/sof/ |
| D | topology.h | 140 /* volume ramping types */
|
| /Linux-v5.10/drivers/gpu/drm/amd/display/dc/clk_mgr/dcn10/ |
| D | rv1_clk_mgr.c | 274 /* program dispclk on = as a w/a for sleep resume clock ramping issues */ in rv1_update_clocks()
|
| /Linux-v5.10/sound/synth/emux/ |
| D | emux_oss.c | 457 /* volume ramping not supported */ in gusspec_control()
|
| /Linux-v5.10/drivers/fpga/ |
| D | socfpga.c | 33 #define SOCFPGA_FPGMGR_STAT_POWER_UP 0x0 /*ramping*/
|
| /Linux-v5.10/Documentation/hwmon/ |
| D | lm93.rst | 251 #PROCHOT and #VRDHOT PWM Ramping
|
| /Linux-v5.10/drivers/gpu/drm/nouveau/nvkm/subdev/clk/ |
| D | gk20a.c | 240 /* wait for ramping to complete */ in gk20a_pllg_slide()
|
| /Linux-v5.10/drivers/gpu/drm/amd/display/dc/calcs/ |
| D | dce_calcs.c | 1643 … is set to the maximum, ramping is not required. dispclk required without ramping is less than th… in calculate_bandwidth()
1644 …/*if dispclk required without ramping is more than the maximum dispclk, that is the dispclk requir… in calculate_bandwidth()
1645 …/*if that does not happen, but dispclk required with ramping is more than the maximum dispclk, dis… in calculate_bandwidth()
1646 /*if that does not happen either, dispclk required is the dispclk required with ramping.*/ in calculate_bandwidth()
1647 …/*dispclk required without ramping is the maximum of the one required for display pipe pixel throu… in calculate_bandwidth()
1652 …ramping, instead of multiplying just the pipe throughput by the display pipe throughput factor, we… in calculate_bandwidth()
|
