/Linux-v6.1/arch/arm/boot/dts/ |
D | berlin2q-marvell-dmp.dts | 35 gpio = <&portb 8 GPIO_ACTIVE_HIGH>; 44 gpio = <&portb 10 GPIO_ACTIVE_HIGH>; 53 gpio = <&portb 12 GPIO_ACTIVE_HIGH>; 64 gpio = <&portb 21 GPIO_ACTIVE_HIGH>; 74 gpios = <&portb 16 GPIO_ACTIVE_HIGH>;
|
D | socfpga_cyclone5_sodia.dts | 41 gpios = <&portb 12 GPIO_ACTIVE_LOW>; 46 gpios = <&portb 13 GPIO_ACTIVE_LOW>; 51 gpios = <&portb 14 GPIO_ACTIVE_LOW>; 56 gpios = <&portb 15 GPIO_ACTIVE_LOW>; 103 cd-gpios = <&portb 18 0>;
|
D | socfpga_cyclone5_socdk.dts | 34 gpios = <&portb 15 1>; 39 gpios = <&portb 14 1>; 44 gpios = <&portb 13 1>; 49 gpios = <&portb 12 1>; 115 cd-gpios = <&portb 18 0>;
|
D | socfpga_cyclone5_sockit.dts | 35 gpios = <&portb 24 0>; /* HPS_GPIO53 */ 41 gpios = <&portb 25 0>; /* HPS_GPIO54 */ 47 gpios = <&portb 26 0>; /* HPS_GPIO55 */ 53 gpios = <&portb 27 0>; /* HPS_GPIO56 */
|
D | socfpga_cyclone5_socrates.dts | 64 gpios = <&portb 19 1>; 69 gpios = <&portb 25 1>;
|
D | ep7209.dtsi | 17 gpio1 = &portb; 65 portb: gpio@80000001 { label
|
D | socfpga_cyclone5_mcvevk.dts | 58 irq-gpio = <&portb 28 0x4>; /* GPIO 57, trig. level HI */
|
D | socfpga_cyclone5_chameleon96.dts | 57 gpios = <&portb 3 GPIO_ACTIVE_LOW>;
|
D | socfpga_cyclone5_de0_nano_soc.dts | 38 gpios = <&portb 24 0>;
|
/Linux-v6.1/drivers/media/pci/cx23885/ |
D | cx23885-cards.c | 87 .portb = CX23885_MPEG_ENCODER, 154 .portb = CX23885_MPEG_DVB, 201 .portb = CX23885_MPEG_DVB, 206 .portb = CX23885_MPEG_DVB, 280 .portb = CX23885_MPEG_DVB, 284 .portb = CX23885_MPEG_DVB, 289 .portb = CX23885_MPEG_DVB, 294 .portb = CX23885_MPEG_DVB, 298 .portb = CX23885_MPEG_DVB, 303 .portb = CX23885_MPEG_DVB, [all …]
|
D | cx23885-core.c | 975 if ((cx23885_boards[dev->board].portb == CX23885_MPEG_DVB) || in cx23885_dev_setup() 976 (cx23885_boards[dev->board].portb == CX23885_MPEG_ENCODER)) in cx23885_dev_setup() 1022 if ((cx23885_boards[dev->board].portb == CX23885_MPEG_ENCODER) || in cx23885_dev_setup() 1053 if (cx23885_boards[dev->board].portb == CX23885_MPEG_DVB) { in cx23885_dev_setup() 1062 if (cx23885_boards[dev->board].portb == CX23885_MPEG_ENCODER) { in cx23885_dev_setup() 1112 if (cx23885_boards[dev->board].portb == CX23885_MPEG_DVB) in cx23885_dev_unregister() 1115 if (cx23885_boards[dev->board].portb == CX23885_MPEG_ENCODER) in cx23885_dev_unregister() 1424 if ((!(cx23885_boards[dev->board].portb & CX23885_MPEG_DVB)) && in cx23885_start_dma() 1426 pr_err("%s() Unsupported .portb/c (0x%08x)/(0x%08x)\n", in cx23885_start_dma() 1428 cx23885_boards[dev->board].portb, in cx23885_start_dma() [all …]
|
/Linux-v6.1/arch/arm64/boot/dts/intel/ |
D | socfpga_agilex_socdk_nand.dts | 26 gpios = <&portb 20 GPIO_ACTIVE_HIGH>; 31 gpios = <&portb 19 GPIO_ACTIVE_HIGH>; 36 gpios = <&portb 21 GPIO_ACTIVE_HIGH>;
|
D | socfpga_agilex_socdk.dts | 26 gpios = <&portb 20 GPIO_ACTIVE_HIGH>; 31 gpios = <&portb 19 GPIO_ACTIVE_HIGH>; 36 gpios = <&portb 21 GPIO_ACTIVE_HIGH>;
|
/Linux-v6.1/drivers/media/pci/saa7164/ |
D | saa7164-cards.c | 44 .portb = SAA7164_MPEG_DVB, 90 .portb = SAA7164_MPEG_DVB, 136 .portb = SAA7164_MPEG_DVB, 196 .portb = SAA7164_MPEG_DVB, 256 .portb = SAA7164_MPEG_DVB, 316 .portb = SAA7164_MPEG_DVB, 376 .portb = SAA7164_MPEG_DVB, 436 .portb = SAA7164_MPEG_DVB, 492 .portb = SAA7164_MPEG_DVB, 538 .portb = SAA7164_MPEG_DVB, [all …]
|
/Linux-v6.1/arch/arm64/boot/dts/altera/ |
D | socfpga_stratix10_socdk.dts | 27 gpios = <&portb 20 GPIO_ACTIVE_HIGH>; 32 gpios = <&portb 19 GPIO_ACTIVE_HIGH>; 37 gpios = <&portb 21 GPIO_ACTIVE_HIGH>;
|
D | socfpga_stratix10_socdk_nand.dts | 27 gpios = <&portb 20 GPIO_ACTIVE_HIGH>; 32 gpios = <&portb 19 GPIO_ACTIVE_HIGH>; 37 gpios = <&portb 21 GPIO_ACTIVE_HIGH>;
|
/Linux-v6.1/drivers/gpio/ |
D | gpio-janz-ttl.c | 39 __be16 portb; member 89 port = &mod->regs->portb; in ttl_set_value() 133 iowrite16be(0x0000, &mod->regs->portb); in ttl_setup_device()
|
/Linux-v6.1/sound/soc/codecs/ |
D | cx2072x.c | 888 SOC_DOUBLE_R_TLV("PortB Boost Volume", CX2072X_PORTB_GAIN_LEFT, 894 SOC_DOUBLE_R_TLV("PortB ADC1 Volume", CX2072X_ADC1_AMP_GAIN_LEFT_0, 1125 "PortB Switch", "PortD Switch", "PortC Switch", "Widget15 Switch", 1244 SND_SOC_DAPM_REG(snd_soc_dapm_supply, "PortB Power", 1257 SND_SOC_DAPM_SWITCH("PortB In En", SND_SOC_NOPM, 0, 0, &portbinen_ctl), 1263 SND_SOC_DAPM_MICBIAS("PortB Mic Bias", CX2072X_PORTB_PIN_CTRL, 2, 0), 1266 SND_SOC_DAPM_INPUT("PORTB"), 1316 {"PortB In En", "Switch", "PORTB"}, 1320 {"ADC1 Mux", "PortB Switch", "PortB In En"}, 1339 {"PortB In En", NULL, "PortB Power"},
|
/Linux-v6.1/sound/soc/sh/ |
D | siu_dai.c | 110 /* portA, portB, SIU operate */ in siu_dai_start() 113 /* portA=256fs, portB=256fs */ in siu_dai_start() 120 /* portB's BRG divides SIUCKB by half */ in siu_dai_start() 126 /* portA: 32 bit/fs, master; portB: 32 bit/fs, master */ in siu_dai_start() 157 idx = 2; /* portB */ in siu_dai_spbAselect() 182 idx = 8; /* portB */ in siu_dai_spbBselect() 207 /* portB operates */ in siu_dai_open()
|
/Linux-v6.1/drivers/edac/ |
D | altera_edac.c | 1012 "ECC: cannot init %s PORTB memory\n", in altr_init_a10_ecc_block() 1523 /* Create the PortB EDAC device */ in altr_portb_setup() 1529 "%s: Unable to allocate PortB EDAC device\n", in altr_portb_setup() 1534 /* Initialize the PortB EDAC device structure from PortA structure */ in altr_portb_setup() 1541 /* Update PortB specific values */ in altr_portb_setup() 1552 * Update the PortB IRQs - A10 has 4, S10 has 2, Index accordingly in altr_portb_setup() 1563 edac_printk(KERN_ERR, EDAC_DEVICE, "Error PortB SBIRQ alloc\n"); in altr_portb_setup() 1572 edac_printk(KERN_ERR, EDAC_DEVICE, "PortB SBERR IRQ error\n"); in altr_portb_setup() 1581 "Error PortB DBIRQ alloc\n"); in altr_portb_setup() 1587 edac_printk(KERN_ERR, EDAC_DEVICE, "Error PortB DBIRQ alloc\n"); in altr_portb_setup() [all …]
|
/Linux-v6.1/drivers/media/pci/cx25821/ |
D | cx25821-cards.c | 29 .portb = CX25821_RAW,
|
/Linux-v6.1/include/dt-bindings/pinctrl/ |
D | r7s9210-pinctrl.h | 23 #define PORTB 11 macro
|
/Linux-v6.1/Documentation/devicetree/bindings/mfd/ |
D | altera-a10sr.txt | 41 interrupt-parent = <&portb>;
|
/Linux-v6.1/drivers/scsi/ |
D | aha152x.h | 43 #define PORTB (HOSTIOPORT1+0x1b) /* PORT B */ macro 253 /* On the AHA-152x board PORTA and PORTB contain
|
/Linux-v6.1/Documentation/devicetree/bindings/gpio/ |
D | snps,dw-apb-gpio.yaml | 131 portb: gpio-port@1 {
|