| /Linux-v5.15/include/media/ |
| D | v4l2-dv-timings.h | 146 * @polarities: the horizontal and vertical polarities (same as struct
147 * v4l2_bt_timings polarities).
156 unsigned active_width, u32 polarities, bool interlaced,
165 * @polarities: the horizontal and vertical polarities (same as struct
166 * v4l2_bt_timings polarities).
180 u32 polarities, bool interlaced, struct v4l2_fract aspect,
|
| /Linux-v5.15/drivers/media/v4l2-core/ |
| D | v4l2-dv-timings.c | 254 t1->bt.polarities == t2->bt.polarities && in v4l2_match_dv_timings()
305 (bt->polarities & V4L2_DV_HSYNC_POS_POL) ? "+" : "-", in v4l2_print_dv_timings()
309 (bt->polarities & V4L2_DV_VSYNC_POS_POL) ? "+" : "-", in v4l2_print_dv_timings()
314 (bt->polarities & V4L2_DV_VSYNC_POS_POL) ? "+" : "-", in v4l2_print_dv_timings()
459 * @polarities - the horizontal and vertical polarities (same as struct
460 * v4l2_bt_timings polarities).
472 u32 polarities, in v4l2_detect_cvt() argument
485 if (polarities == V4L2_DV_VSYNC_POS_POL) in v4l2_detect_cvt()
487 else if (polarities == V4L2_DV_HSYNC_POS_POL) in v4l2_detect_cvt()
607 fmt->bt.polarities = polarities; in v4l2_detect_cvt()
[all …]
|
| D | v4l2-fwnode.c | 183 rval = fwnode_property_count_u32(fwnode, "lane-polarities"); in v4l2_fwnode_endpoint_parse_csi2_bus()
186 pr_warn("invalid number of lane-polarities entries (need %u, got %u)\n", in v4l2_fwnode_endpoint_parse_csi2_bus()
238 "lane-polarities", array, in v4l2_fwnode_endpoint_parse_csi2_bus()
247 pr_debug("no lane polarities defined, assuming not inverted\n"); in v4l2_fwnode_endpoint_parse_csi2_bus()
|
| /Linux-v5.15/drivers/gpu/drm/arm/ |
| D | hdlcd_crtc.c | 133 unsigned int polarities, err; in hdlcd_crtc_mode_set_nofb() local
142 polarities = HDLCD_POLARITY_DATAEN | HDLCD_POLARITY_DATA; in hdlcd_crtc_mode_set_nofb()
145 polarities |= HDLCD_POLARITY_HSYNC; in hdlcd_crtc_mode_set_nofb()
147 polarities |= HDLCD_POLARITY_VSYNC; in hdlcd_crtc_mode_set_nofb()
161 hdlcd_write(hdlcd, HDLCD_REG_POLARITIES, polarities); in hdlcd_crtc_mode_set_nofb()
|
| D | hdlcd_regs.h | 55 /* polarities */
|
| /Linux-v5.15/drivers/media/i2c/ |
| D | st-mipid02.c | 412 bool *polarities = ep->bus.mipi_csi2.lane_polarities; in mipid02_configure_clk_lane() local
419 bridge->r.clk_lane_reg1 |= (polarities[0] << 1) | CLK_ENABLE; in mipid02_configure_clk_lane()
425 bool are_lanes_swap, bool *polarities) in mipid02_configure_data0_lane() argument
427 bool are_pin_swap = are_lanes_swap ? polarities[2] : polarities[1]; in mipid02_configure_data0_lane()
444 bool are_lanes_swap, bool *polarities) in mipid02_configure_data1_lane() argument
446 bool are_pin_swap = are_lanes_swap ? polarities[1] : polarities[2]; in mipid02_configure_data1_lane()
462 bool *polarities = ep->bus.mipi_csi2.lane_polarities; in mipid02_configure_from_rx() local
471 polarities); in mipid02_configure_from_rx()
476 polarities); in mipid02_configure_from_rx()
|
| D | ths7303.c | 294 "timings: %dx%d%s%d (%dx%d). Pix freq. = %d Hz. Polarities = 0x%x\n", in ths7303_log_status()
300 (int)bt->pixelclock, bt->polarities); in ths7303_log_status()
|
| D | ths8200.c | 336 if (bt->polarities & V4L2_DV_HSYNC_POS_POL) { in ths8200_setup()
340 if (bt->polarities & V4L2_DV_VSYNC_POS_POL) { in ths8200_setup()
|
| /Linux-v5.15/Documentation/devicetree/bindings/media/ |
| D | video-interfaces.yaml | 124 that if HSYNC and VSYNC polarities are not specified, embedded
196 lane-polarities:
203 An array of polarities of the lanes starting from the clock lane and
207 lane-polarities property is omitted, the value must be interpreted as 0
|
| D | renesas,vin.yaml | 87 If both HSYNC and VSYNC polarities are not specified, embedded
93 If both HSYNC and VSYNC polarities are not specified, embedded
136 If both HSYNC and VSYNC polarities are not specified, embedded
142 If both HSYNC and VSYNC polarities are not specified, embedded
|
| D | ti,omap3isp.txt | 48 lane-polarities : lane polarity (required on CSI-2)
|
| /Linux-v5.15/Documentation/devicetree/bindings/display/bridge/ |
| D | ti,sn65dsi86.yaml | 137 lane-polarities:
147 lane-polarities: [data-lanes]
271 lane-polarities = <0 1 0 1>;
|
| /Linux-v5.15/arch/sh/include/asm/ |
| D | sh7760fb.h | 145 * HSYNC/VSYNC polarities are derived from the fb_var_screeninfo
146 * data above; however the polarities of the following signals
|
| /Linux-v5.15/arch/arm64/boot/dts/qcom/ |
| D | sc7180-trogdor-lazor-r0.dts | 34 lane-polarities = <1 0>;
|
| /Linux-v5.15/drivers/spi/ |
| D | spi-bcm63xx-hsspi.c | 243 /* only change actual polarities if there is no transfer */ in bcm63xx_hsspi_setup()
283 * e. At the end restore the polarities again to their default values. in bcm63xx_hsspi_transfer_one()
431 /* read out default CS polarities */ in bcm63xx_hsspi_probe()
|
| /Linux-v5.15/Documentation/userspace-api/media/v4l/ |
| D | dv-timings.rst | 20 width and height, signal polarities, frontporches, backporches, sync
|
| D | vidioc-g-dv-timings.rst | 108 - ``polarities``
109 - This is a bit mask that defines polarities of sync signals. bit 0
|
| /Linux-v5.15/arch/arm/boot/dts/ |
| D | omap3-n9.dts | 56 lane-polarities = <1 1 1>;
|
| D | omap3-n950.dts | 102 lane-polarities = <1 1 1>;
|
| /Linux-v5.15/Documentation/devicetree/bindings/media/i2c/ |
| D | st,st-mipid02.txt | 40 - lane-polarities: any lane can be inverted or not.
|
| /Linux-v5.15/drivers/video/fbdev/geode/ |
| D | video_gx.c | 266 /* Only change the sync polarities if we are running in gx_configure_display()
267 * in CRT mode. The FP polarities will be handled in in gx_configure_display()
|
| D | video_cs5530.c | 124 /* Sync polarities. */ in cs5530_configure_display()
|
| /Linux-v5.15/drivers/media/dvb-frontends/ |
| D | tda1004x.c | 651 tda1004x_write_mask(state, TDA10046H_CONF_POLARITY, 0xf0, 0x60); // set AGC polarities in tda10046_init()
655 tda1004x_write_mask(state, TDA10046H_CONF_POLARITY, 0xf0, 0x60); // set AGC polarities in tda10046_init()
659 tda1004x_write_mask(state, TDA10046H_CONF_POLARITY, 0xf0, 0x00); // set AGC polarities in tda10046_init()
665 tda1004x_write_mask(state, TDA10046H_CONF_POLARITY, 0xf0, 0x60); // set AGC polarities in tda10046_init()
|
| /Linux-v5.15/drivers/pinctrl/mvebu/ |
| D | pinctrl-armada-37xx.c | 633 * yet their interrupt polarities are kept in old values, we in armada_37xx_edge_both_irq_swap_pol()
634 * should synchronize their interrupt polarities; for example, in armada_37xx_edge_both_irq_swap_pol()
1063 * anymore with their polarities (rising/falling edge) and must be in armada_3700_pinctrl_resume()
|
| /Linux-v5.15/sound/pci/ice1712/ |
| D | maya44.c | 545 0x0a, 0x022, /* R10: DAC I2C mode, std polarities, 24bit */ in wm8776_init()
546 0x0b, 0x022, /* R11: ADC I2C mode, std polarities, 24bit, in wm8776_init()
|
