| /Linux-v6.1/Documentation/devicetree/bindings/phy/ |
| D | hisilicon,hi3670-usb3.yaml | 1 # SPDX-License-Identifier: GPL-2.0
3 ---
4 $id: http://devicetree.org/schemas/phy/hisilicon,hi3670-usb3.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Mauro Carvalho Chehab <mchehab+huawei@kernel.org>
17 const: hisilicon,hi3670-usb-phy
19 "#phy-cells":
22 hisilicon,pericrg-syscon:
24 description: phandle of syscon used to control iso refclk.
26 hisilicon,pctrl-syscon:
[all …]
|
| D | hisilicon,hi3660-usb3.yaml | 1 # SPDX-License-Identifier: GPL-2.0
3 ---
4 $id: http://devicetree.org/schemas/phy/hisilicon,hi3660-usb3.yaml#
5 $schema: http://devicetree.org/meta-schemas/core.yaml#
10 - Mauro Carvalho Chehab <mchehab+huawei@kernel.org>
16 const: hisilicon,hi3660-usb-phy
18 "#phy-cells":
21 hisilicon,pericrg-syscon:
23 description: phandle of syscon used to control iso refclk.
25 hisilicon,pctrl-syscon:
[all …]
|
| /Linux-v6.1/drivers/pinctrl/ |
| D | pinctrl-zynq.c | 1 // SPDX-License-Identifier: GPL-2.0-or-later
10 #include <linux/mfd/syscon.h>
18 #include <linux/pinctrl/pinconf-generic.h>
20 #include "pinctrl-utils.h"
32 * struct zynq_pinctrl - driver data
33 * @pctrl: Pinctrl device
34 * @syscon: Syscon regmap
35 * @pctrl_offset: Offset for pinctrl into the @syscon space
42 struct pinctrl_dev *pctrl; member
43 struct regmap *syscon; member
[all …]
|
| /Linux-v6.1/drivers/phy/hisilicon/ |
| D | phy-hi3660-usb3.c | 1 // SPDX-License-Identifier: GPL-2.0
5 * Copyright (C) 2017-2018 Hilisicon Electronics Co., Ltd.
12 #include <linux/mfd/syscon.h>
60 struct regmap *pctrl; member
72 ret = regmap_write(priv->peri_crg, PERI_CRG_ISODIS, USB_REFCLK_ISO_EN); in hi3660_phy_init()
78 ret = regmap_write(priv->pctrl, PCTRL_PERI_CTRL3, val); in hi3660_phy_init()
84 ret = regmap_write(priv->peri_crg, PERI_CRG_RSTEN4, val); in hi3660_phy_init()
91 ret = regmap_update_bits(priv->otg_bc, USBOTG3_CTRL0, mask, val); in hi3660_phy_init()
97 ret = regmap_update_bits(priv->otg_bc, USBOTG3_CTRL7, mask, val); in hi3660_phy_init()
103 ret = regmap_update_bits(priv->otg_bc, USBOTG3_CTRL2, mask, 0); in hi3660_phy_init()
[all …]
|
| D | phy-hi3670-usb3.c | 1 // SPDX-License-Identifier: GPL-2.0-only
5 * Copyright (C) 2017-2020 Hilisicon Electronics Co., Ltd.
14 #include <linux/mfd/syscon.h>
128 struct regmap *pctrl; member
189 while (retry-- > 0) { in hi3670_phy_cr_wait_ack()
203 return -ETIMEDOUT; in hi3670_phy_cr_wait_ack()
293 ret = regmap_write(priv->usb31misc, USB3OTG_CTRL4, in hi3670_phy_set_params()
294 priv->eye_diagram_param); in hi3670_phy_set_params()
296 dev_err(priv->dev, "set USB3OTG_CTRL4 failed\n"); in hi3670_phy_set_params()
300 while (retry-- > 0) { in hi3670_phy_set_params()
[all …]
|
| /Linux-v6.1/drivers/pinctrl/berlin/ |
| D | berlin.c | 1 // SPDX-License-Identifier: GPL-2.0
7 * Antoine Ténart <antoine.tenart@free-electrons.com>
11 #include <linux/mfd/syscon.h>
23 #include "../pinctrl-utils.h"
37 struct berlin_pinctrl *pctrl = pinctrl_dev_get_drvdata(pctrl_dev); in berlin_pinctrl_get_group_count() local
39 return pctrl->desc->ngroups; in berlin_pinctrl_get_group_count()
45 struct berlin_pinctrl *pctrl = pinctrl_dev_get_drvdata(pctrl_dev); in berlin_pinctrl_get_group_name() local
47 return pctrl->desc->groups[group].name; in berlin_pinctrl_get_group_name()
55 struct berlin_pinctrl *pctrl = pinctrl_dev_get_drvdata(pctrl_dev); in berlin_pinctrl_dt_node_to_map() local
66 dev_err(pctrl->dev, in berlin_pinctrl_dt_node_to_map()
[all …]
|
| /Linux-v6.1/Documentation/devicetree/bindings/clock/ |
| D | hi3670-clock.txt | 8 - compatible: the compatible should be one of the following strings to
11 - "hisilicon,hi3670-crgctrl"
12 - "hisilicon,hi3670-pctrl"
13 - "hisilicon,hi3670-pmuctrl"
14 - "hisilicon,hi3670-sctrl"
15 - "hisilicon,hi3670-iomcu"
16 - "hisilicon,hi3670-media1-crg"
17 - "hisilicon,hi3670-media2-crg"
19 - reg: physical base address of the controller and length of memory mapped
22 - #clock-cells: should be 1.
[all …]
|
| D | hi3660-clock.txt | 8 - compatible: the compatible should be one of the following strings to
11 - "hisilicon,hi3660-crgctrl"
12 - "hisilicon,hi3660-pctrl"
13 - "hisilicon,hi3660-pmuctrl"
14 - "hisilicon,hi3660-sctrl"
15 - "hisilicon,hi3660-iomcu"
16 - "hisilicon,hi3660-stub-clk"
18 - reg: physical base address of the controller and length of memory mapped
21 - #clock-cells: should be 1.
25 - mboxes: Phandle to the mailbox for sending message to MCU.
[all …]
|
| /Linux-v6.1/drivers/pinctrl/nuvoton/ |
| D | pinctrl-wpcm450.c | 1 // SPDX-License-Identifier: GPL-2.0
2 // Copyright (c) 2016-2018 Nuvoton Technology corporation.
4 // Copyright (c) 2021-2022 Jonathan Neuschäfer
7 // - Pin mux registers, in the GCR (general control registers) block
8 // - GPIO registers, specific to each GPIO bank
9 // - GPIO event (interrupt) registers, located centrally in the GPIO register
17 #include <linux/mfd/syscon.h>
24 #include <linux/pinctrl/pinconf-generic.h>
51 struct wpcm450_pinctrl *pctrl; member
84 u8 num_irqs; /* Number of IRQ-capable GPIOs in this bank */
[all …]
|
| D | pinctrl-npcm7xx.c | 1 // SPDX-License-Identifier: GPL-2.0
2 // Copyright (c) 2016-2018 Nuvoton Technology corporation.
9 #include <linux/mfd/syscon.h>
16 #include <linux/pinctrl/pinconf-generic.h>
48 #define NPCM7XX_GP_N_PU 0x1c /* Pull-up */
49 #define NPCM7XX_GP_N_PD 0x20 /* Pull-down */
108 raw_spin_lock_irqsave(&gc->bgpio_lock, flags); in npcm_gpio_set()
113 raw_spin_unlock_irqrestore(&gc->bgpio_lock, flags); in npcm_gpio_set()
122 raw_spin_lock_irqsave(&gc->bgpio_lock, flags); in npcm_gpio_clr()
127 raw_spin_unlock_irqrestore(&gc->bgpio_lock, flags); in npcm_gpio_clr()
[all …]
|
| /Linux-v6.1/arch/arm64/boot/dts/hisilicon/ |
| D | hi3660.dtsi | 1 // SPDX-License-Identifier: GPL-2.0
8 #include <dt-bindings/interrupt-controller/arm-gic.h>
9 #include <dt-bindings/clock/hi3660-clock.h>
10 #include <dt-bindings/thermal/thermal.h>
14 interrupt-parent = <&gic>;
15 #address-cells = <2>;
16 #size-cells = <2>;
19 compatible = "arm,psci-0.2";
24 #address-cells = <2>;
25 #size-cells = <0>;
[all …]
|
| D | hi3670.dtsi | 1 // SPDX-License-Identifier: GPL-2.0
9 #include <dt-bindings/interrupt-controller/arm-gic.h>
10 #include <dt-bindings/clock/hi3670-clock.h>
14 interrupt-parent = <&gic>;
15 #address-cells = <2>;
16 #size-cells = <2>;
19 compatible = "arm,psci-0.2";
24 #address-cells = <2>;
25 #size-cells = <0>;
27 cpu-map {
[all …]
|
| /Linux-v6.1/drivers/i2c/busses/ |
| D | i2c-s3c2410.c | 1 // SPDX-License-Identifier: GPL-2.0-or-later
2 /* linux/drivers/i2c/busses/i2c-s3c2410.c
30 #include <linux/mfd/syscon.h>
35 #include <linux/platform_data/i2c-s3c2410.h>
118 struct pinctrl *pctrl; member
128 .name = "s3c2410-i2c",
131 .name = "s3c2440-i2c",
134 .name = "s3c2440-hdmiphy-i2c",
144 { .compatible = "samsung,s3c2410-i2c", .data = (void *)0 },
145 { .compatible = "samsung,s3c2440-i2c", .data = (void *)QUIRK_S3C2440 },
[all …]
|
