| /Linux-v5.15/Documentation/devicetree/bindings/media/i2c/ |
| D | ov5640.txt | 1 * Omnivision OV5640 MIPI CSI-2 / parallel sensor
4 - compatible: should be "ovti,ov5640"
13 This is an active low signal to the OV5640.
15 if any. This is an active high signal to the OV5640.
25 OV5640 can be connected to a MIPI CSI-2 bus or a parallel bus endpoint.
46 ov5640: camera@3c {
47 compatible = "ovti,ov5640";
72 ov5640: camera@3c {
73 compatible = "ovti,ov5640";
|
| /Linux-v5.15/Documentation/admin-guide/media/ |
| D | imx.rst | 115 MIPI CSI-2 OV5640 sensor, requires the i.MX6 MIPI CSI-2 receiver. But
409 i.MX6Q SabreLite with OV5642 and OV5640
413 camera interface, and the OV5640 module with a MIPI CSI-2
425 The MIPI CSI-2 OV5640 module is connected to the i.MX internal MIPI CSI-2
428 vc2 directly to IPU2 CSI0, and vc3 to the IPU2 CSI1 mux. The OV5640 is
430 OV5640 must not share the same i2c slave address.
434 the OV5640, transmitting on MIPI CSI-2 virtual channel 1 (which is
437 OV5640 UYVY2X8:
445 # Setup links for OV5640
446 media-ctl -l "'ov5640 1-0040':0 -> 'imx6-mipi-csi2':0[1]"
[all …]
|
| D | omap4_camera.rst | 36 - OMAP4430SDP, w/ ES2.1 GP & SEVM4430-CAM-V1-0 (Contains IMX060 & OV5640, in
44 * OV5640
|
| D | imx6q-sabresd.dot | 54 …n00000087 [label="{{} | ov5640 1-003c\n/dev/v4l-subdev15 | {<port0> 0}}", shape=Mrecord, style=fil…
|
| D | i2c-cardlist.rst | 86 ov5640 OmniVision OV5640 sensor
|
| /Linux-v5.15/arch/arm/boot/dts/ |
| D | r8a7742-iwg21d-q7-dbcm-ov5640-single.dtsi | 3 * This include file ties a VIN interface with a single ov5640 sensor on
15 ov5640@3c {
16 compatible = "ovti,ov5640";
|
| D | r8a7742-iwg21d-q7-dbcm-ca.dts | 199 * Below configuration ties VINx endpoints to ov5640/ov7725 camera endpoints
210 #include "r8a7742-iwg21d-q7-dbcm-ov5640-single.dtsi"
244 #include "r8a7742-iwg21d-q7-dbcm-ov5640-single.dtsi"
276 #include "r8a7742-iwg21d-q7-dbcm-ov5640-single.dtsi"
307 #include "r8a7742-iwg21d-q7-dbcm-ov5640-single.dtsi"
|
| D | sun8i-s3-pinecube.dts | 99 ov5640: camera@3c { label
100 compatible = "ovti,ov5640";
|
| D | imx6q-icore-mipi.dts | 27 &ov5640 {
|
| D | stm32mp157c-ev1.dts | 183 ov5640: camera@3c { label
184 compatible = "ovti,ov5640";
|
| D | imx6qdl-icore.dtsi | 199 ov5640: camera@3c { label
200 compatible = "ovti,ov5640";
|
| D | imx6ul-14x14-evk.dtsi | 50 * - ov5640 camera
143 compatible = "ovti,ov5640";
|
| D | imx6-logicpd-baseboard.dtsi | 261 ov5640: camera@10 { label
262 compatible = "ovti,ov5640";
|
| D | dra72-evm-common.dtsi | 280 ov5640@3c {
281 compatible = "ovti,ov5640";
|
| D | imx6qdl-sabrelite.dtsi | 379 ov5640: camera@40 { label
380 compatible = "ovti,ov5640";
|
| D | imx6qdl-sabresd.dtsi | 318 ov5640: camera@3c { label
319 compatible = "ovti,ov5640";
|
| /Linux-v5.15/arch/arm64/boot/dts/allwinner/ |
| D | sun50i-a64-amarula-relic.dts | 32 ov5640: camera@3c { label
33 compatible = "ovti,ov5640";
|
| D | sun50i-a64-pinetab.dts | 47 ov5640: camera@3c { label
48 compatible = "ovti,ov5640";
|
| /Linux-v5.15/Documentation/devicetree/bindings/media/ |
| D | ti,cal.yaml | 155 compatible = "ovti,ov5640";
|
| /Linux-v5.15/drivers/media/i2c/ |
| D | Makefile | 72 obj-$(CONFIG_VIDEO_OV5640) += ov5640.o
|
| D | ov5640.c | 232 struct clk *xclk; /* system clock to OV5640 */
1108 /* download ov5640 settings to sensor through i2c */
2026 * When configured in parallel mode, the OV5640 will in ov5640_set_power_dvp()
3197 {"ov5640", 0},
3203 { .compatible = "ovti,ov5640" },
3210 .name = "ov5640",
3220 MODULE_DESCRIPTION("OV5640 MIPI Camera Subdev Driver");
|
| D | Kconfig | 959 tristate "OmniVision OV5640 sensor support"
967 OV5640 camera sensor with a MIPI CSI-2 interface.
|
| D | ov2680.c | 7 * Based on OV5640 Sensor Driver
|
| D | ov5645.c | 13 * - the OV5640 driver posted on linux-media:
|
| /Linux-v5.15/arch/arm64/boot/dts/qcom/ |
| D | apq8016-sbc.dtsi | 266 compatible = "ovti,ov5640";
|
