Searched full:muxed (Results 1 – 25 of 161) sorted by relevance
1234567
| /Linux-v6.1/Documentation/driver-api/memory-devices/ |
| D | ti-gpmc.rst | 74 3. read async muxed
85 4. read async non-muxed
96 5. read sync muxed
107 6. read sync non-muxed
118 7. write async muxed
131 8. write async non-muxed
144 9. write sync muxed
157 10. write sync non-muxed
|
| /Linux-v6.1/Documentation/devicetree/bindings/leds/ |
| D | leds-bcm6328.yaml | 95 signals can get muxed into these LEDs. Only valid for LEDs 0 to 7,
96 where LED signals 0 to 3 may be muxed to LEDs 0 to 3, and signals 4 to
97 7 may be muxed to LEDs 4 to 7. A signal can be muxed to more than one
106 hardware signals can get muxed into these LEDs. Only valid for LEDs 0
107 to 7, where LED signals 0 to 3 may be muxed to LEDs 0 to 3, and
108 signals 4 to 7 may be muxed to LEDs 4 to 7. A signal can be muxed to
|
| /Linux-v6.1/include/linux/amba/ |
| D | pl08x.h | 36 * @min_signal: the minimum DMA signal number to be muxed in for this
37 * channel (for platforms supporting muxed signals). If you have
40 * when these are not enough they often get muxed (in hardware)
42 * @max_signal: the maximum DMA signal number to be muxed in for
|
| /Linux-v6.1/include/linux/mfd/da9055/ |
| D | pdata.h | 27 * GPI muxed pin to control
32 * GPI muxed pin to control
|
| /Linux-v6.1/arch/arm/boot/dts/ |
| D | imx7-colibri-aster.dtsi | 15 &gpio4 23 GPIO_ACTIVE_LOW /* SODIMM 65 / already muxed pinctrl_gpio2 as SPI_CE0_N */
16 &gpio4 22 GPIO_ACTIVE_LOW /* SODIMM 85 / already muxed pinctrl_gpio2 as SPI_CE1_N */
|
| D | imx6qdl-dhcom-drc02.dtsi | 14 * pins SD3_DAT0 and SD3_DAT1 are muxed as can2 Tx and Rx. The signals for can2
109 * disabled, because the pins SD3_DAT0 and SD3_DAT1 are muxed as
|
| D | omap4-mcpdm.dtsi | 32 * McPDM pads must be muxed at the interconnect target module
|
| D | ste-href-ab8500.dtsi | 41 * are muxed in as GPIO, and configured as INPUT PULL DOWN
226 * Pins 26 and 35 muxed in as GPIO, and configured as OUTPUT LOW
|
| /Linux-v6.1/drivers/pinctrl/bcm/ |
| D | Kconfig | 138 these pins are muxed to GPIO.
141 individually muxed to GPIO function, through interaction with the
189 these pins are muxed to GPIO.
|
| /Linux-v6.1/Documentation/devicetree/bindings/arm/omap/ |
| D | crossbar.txt | 4 time, so they have to be muxed to the irq-controller appropriately.
17 - ti,irqs-reserved: List of the reserved irq lines that are not muxed using
|
| /Linux-v6.1/Documentation/devicetree/bindings/pinctrl/ |
| D | samsung,pinctrl.yaml | 155 /* Pin bank with external GPIO or muxed external wake-up interrupts */
185 /* Pin bank with external GPIO or muxed external wake-up interrupts */
235 /* Pin bank with external GPIO or muxed external wake-up interrupts */
368 /* Pin bank with external GPIO or muxed external wake-up interrupts */
|
| D | brcm,nsp-pinmux.txt | 4 addition, certain pins can be muxed to GPIO function individually.
|
| D | marvell,mvebu-pinctrl.txt | 20 - marvell,pins: string array of mpp pins or group of pins to be muxed.
|
| D | brcm,cygnus-pinmux.txt | 4 addition, certain pins can be muxed to GPIO function individually.
|
| /Linux-v6.1/Documentation/devicetree/bindings/sound/ |
| D | cirrus,madera.yaml | 35 INnAR INnBL INnBR. For non-muxed inputs the first two cells
37 and the second two cells must be 0. For muxed inputs the
|
| /Linux-v6.1/Documentation/devicetree/bindings/net/nfc/ |
| D | marvell,nci.yaml | 19 hci-muxed:
167 hci-muxed;
|
| /Linux-v6.1/Documentation/driver-api/tty/ |
| D | n_gsm.rst | 77 printf("first muxed line: /dev/gsmtty%i\n", first);
147 printf("first muxed line: /dev/gsmtty%i\n", first);
|
| /Linux-v6.1/drivers/pinctrl/ |
| D | Kconfig | 45 (x86 or arm). Most of the pins are usually muxed to some other
124 AXP PMICs provides multiple GPIOs that can be muxed for different
166 The Dialog DA9062 PMIC provides multiple GPIOs that can be muxed for
|
| D | pinmux.c | 76 * is either muxed to a different function or used as gpio.
100 * pin_request() - request a single pin to be muxed in, typically for GPIO
197 * pin_free() - release a single muxed in pin so something else can be muxed
284 * @pin: the affected currently GPIO-muxed in pin
297 * pinmux_gpio_direction() - set the direction of a single muxed-in GPIO pin
|
| /Linux-v6.1/drivers/gpu/drm/pl111/ |
| D | pl111_nomadik.c | 28 * MDIF (Master Display Interface) and gets muxed out here. in pl111_nomadik_init()
|
| /Linux-v6.1/Documentation/devicetree/bindings/net/dsa/ |
| D | mediatek,mt7530.yaml | 33 - PHY 0 or 4 of the switch can be muxed to connect to the gmac of the SoC
52 - PHY 0 or 4 of the switch can be muxed to connect to gmac1 of the SoC.
70 - Port 5 can be muxed to an external phy. Port 5 becomes a DSA slave.
608 /* Commented out, phy4 is muxed to gmac1.
|
| /Linux-v6.1/drivers/pinctrl/spear/ |
| D | pinctrl-spear1310.c | 1324 /* Muxed with I2C */
1353 /* Muxed with SD/MMC */
1576 /* Muxed with SMI & CLCD */
1606 /* Muxed with SD/MMC & I2S1 */
1644 /* Muxed with SMI */
1674 /* Muxed with SD/MMC */
1712 /* Muxed with SD/MMC */
1753 /* Muxed with KBD */
1783 /* Muxed with SD/MMC */
1856 /* Muxed with NOR */
[all …]
|
| /Linux-v6.1/include/linux/platform_data/ |
| D | nfcmrvl.h | 27 /* Tell if transport is muxed in HCI one */
|
| /Linux-v6.1/Documentation/devicetree/bindings/phy/ |
| D | mscc,vsc7514-serdes.yaml | 17 A SerDes X can be "muxed" to work with switch port Y or Z for example.
|
| /Linux-v6.1/Documentation/devicetree/bindings/spi/ |
| D | nuvoton,npcm-fiu.txt | 23 Required properties in case the pins can be muxed:
|
1234567
