Searched full:multiplexers (Results 1 – 25 of 26) sorted by relevance
12
| /Linux-v5.15/drivers/net/mdio/ |
| D | Kconfig | 196 comment "MDIO Multiplexers"
203 multiplexers which connect one of several child MDIO busses
215 the amlogic g12a SoC. The multiplexers connects either the external
219 tristate "Broadcom BCM6368 MDIO bus multiplexers"
224 This module provides a driver for MDIO bus multiplexers found in
230 tristate "Broadcom iProc based MDIO bus multiplexers"
235 This module provides a driver for MDIO bus multiplexers found in
241 tristate "GPIO controlled MDIO bus multiplexers"
245 This module provides a driver for MDIO bus multiplexers that
263 tristate "MMIO device-controlled MDIO bus multiplexers"
[all …]
|
| /Linux-v5.15/drivers/mux/ |
| D | Kconfig | 13 tristate "Analog Devices ADG792A/ADG792G Multiplexers"
16 ADG792A and ADG792G Wide Bandwidth Triple 4:1 Multiplexers
18 The driver supports both operating the three multiplexers in
25 tristate "Analog Devices ADGS1408/ADGS1409 Multiplexers"
43 multiplexers, which in that case will be operated in parallel.
|
| /Linux-v5.15/Documentation/devicetree/bindings/mux/ |
| D | mux-controller.yaml | 15 several parallel multiplexers. Presumably there will be at least one
17 control several multiplexers for a single consumer.
133 * parallel 4-way multiplexers controlled by the same two GPIO-lines.
|
| D | gpio-mux.yaml | 14 multiplexers, if the same pins control more than one multiplexer.
|
| D | adi,adg792a.txt | 1 Bindings for Analog Devices ADG792A/G Triple 4:1 Multiplexers
|
| D | reg-mux.yaml | 13 Define register bitfields to be used to control multiplexers. The parent
|
| /Linux-v5.15/Documentation/devicetree/bindings/i2c/ |
| D | i2c-mux-gpmux.yaml | 60 However, I2C transactions to devices behind all I2C multiplexers connected
67 The properties of mux-locked and parent-locked multiplexers are discussed
|
| D | i2c-mux-ltc4306.txt | 19 multiplexers on the bus and the devices behind them use same I2C addresses.
|
| D | i2c-mux.yaml | 17 For i2c multiplexers/switches that have child nodes that are a mixture of both
|
| D | i2c-mux-pca954x.yaml | 55 necessary for example, if there are several multiplexers on the bus and
|
| /Linux-v5.15/drivers/iio/multiplexer/ |
| D | Kconfig | 7 menu "Multiplexers" menu
|
| /Linux-v5.15/include/linux/platform_data/ |
| D | mlxcpld.h | 11 /* Platform data for the CPLD I2C multiplexers */
|
| /Linux-v5.15/Documentation/devicetree/bindings/clock/st/ |
| D | st,clkgen-mux.txt | 3 This binding supports only simple indexed multiplexers, it does not
|
| /Linux-v5.15/Documentation/devicetree/bindings/sound/ |
| D | simple-audio-mux.yaml | 13 Simple audio multiplexers are driven using gpios, allowing to select which of
|
| /Linux-v5.15/Documentation/admin-guide/media/ |
| D | imx.rst | 68 - Two video multiplexers for selecting among multiple sensor inputs
113 multiplexers, but the internal IPUv3 topology downstream from there
151 multiplexers as described below.
154 two video multiplexers. Both CSI0 and CSI1 can receive any virtual
155 channel, as selected by the video multiplexers.
165 These are the video multiplexers. They have two or more sink pads to
|
| /Linux-v5.15/Documentation/devicetree/bindings/media/ |
| D | video-mux.yaml | 14 Video multiplexers allow to select between multiple input ports. Video
|
| /Linux-v5.15/sound/soc/codecs/ |
| D | tlv320aic31xx.h | 49 #define AIC31XX_CLKMUX AIC31XX_REG(0, 4) /* Clock clock Gen muxing, Multiplexers*/
62 #define AIC31XX_CLKOUTMUX AIC31XX_REG(0, 25) /* Clock setting register 9, Multiplexers */
|
| /Linux-v5.15/Documentation/devicetree/bindings/clock/ti/davinci/ |
| D | pll.txt | 5 an multiplexers for various clock signals.
|
| /Linux-v5.15/Documentation/devicetree/bindings/clock/ |
| D | ingenic,cgu.yaml | 11 typically includes a variety of PLLs, multiplexers, dividers & gates in order
|
| /Linux-v5.15/Documentation/devicetree/bindings/iio/adc/ |
| D | xilinx-xadc.txt | 43 multiplexers for simultaneous sampling.
|
| /Linux-v5.15/Documentation/devicetree/bindings/gpio/ |
| D | gpio-pca95xx.yaml | 13 Bindings for the family of I2C GPIO multiplexers/expanders: NXP PCA95xx,
|
| /Linux-v5.15/drivers/media/platform/ |
| D | Kconfig | 72 This driver provides support for N:1 video bus multiplexers.
|
| /Linux-v5.15/drivers/media/pci/bt8xx/ |
| D | bttv-cards.c | 2182 …Tetra : 4 Conexant Fusion 878A, no audio, video input set with analog multiplexers GPIO controlled…
2190 …/*Set the GPIO[18]->GPIO[21] as output pin.==> drive the video inputs through analog multiplexers*/
4554 * video multiplexers to provide up to 16 video inputs. These
4555 * multiplexers are controlled by the lower 8 GPIO pins of the
4556 * bt878. The multiplexers probably Pericom PI5V331Q or similar.
4591 /*Just set the right path in the analog multiplexers : channel 1 -> 4 ==> Analog Mux ==> MUX0*/ in picolo_tetra_muxsel()
|
| /Linux-v5.15/drivers/spi/ |
| D | Kconfig | 1007 This adds support for SPI multiplexers. Each SPI mux will be
|
| /Linux-v5.15/drivers/media/pci/cx18/ |
| D | cx18-av-core.c | 675 /* Set up analog front end multiplexers */ in set_input()
|
12
