| /Linux-v6.1/Documentation/pcmcia/ |
| D | driver-changes.rst | 27 Instead of win_req_t, drivers are now requested to fill out
34 Instead of io_req_t, drivers are now requested to fill out
49 Instead of the old pcmcia_request_irq() interface, drivers may now
58 Instead of the cs_error() callback or the CS_CHECK() macro, please use
63 Instead of pcmcia_get_{first,next}_tuple(), pcmcia_get_tuple_data() and
76 Instead of calling pcmcia_release_{configuration,io,irq,win}, all that's
116 PCMCIA card drivers. Instead, it is the job of the PCMCIA core to
156 directly (except for pcmcia_report_error(), just use cs_error() instead).
160 instead of {un,}register_pccard_driver
|
| /Linux-v6.1/Documentation/devicetree/bindings/mmc/ |
| D | cavium-mmc.txt | 26 - spi-max-frequency : use max-frequency instead
27 - cavium,bus-max-width : use bus-width instead
28 - power-gpios : use vmmc-supply instead
29 - cavium,octeon-6130-mmc-slot : use mmc-slot instead
|
| /Linux-v6.1/tools/memory-model/scripts/ |
| D | README | 36 provided instead for use by other scripts.
49 provided instead for use by other scripts.
60 provided instead for use by other scripts.
66 provided instead for use by other scripts.
|
| /Linux-v6.1/tools/testing/selftests/bpf/progs/ |
| D | core_reloc_types.h | 73 /* inlined anonymous struct/union instead of named structs in original */
205 /* b.b.b field is an array of integers instead of plain int */
231 /* middle b container is referenced through pointer instead of being embedded */
245 /* middle b container is an array of structs instead of plain struct */
504 int c; /* int instead of enum */
511 int *b __bpf_aligned; /* ptr instead of int */
521 int d; /* int instead of ptr */
637 bool u8_field; /* bool instead of uint8 */
1082 union a_struct___incompat { /* union instead of struct */
1086 struct a_union___incompat { /* struct instead of union */
[all …]
|
| /Linux-v6.1/Documentation/gpu/rfc/ |
| D | i915_vm_bind.rst | 60 The execbuf3 ioctl directly specifies the batch addresses instead of as
65 In VM_BIND mode, VA allocation is completely managed by the user instead of
68 be using the i915_vma active reference tracking. It will instead use dma-resv
109 rwsem instead, so that multiple page fault handlers can take the read side
119 instead.
154 check. Instead, the execbuf3 out fence should be used for end of batch check
199 Allows compute UMD to directly submit GPU jobs instead of through execbuf
220 VM_BIND allows any hints setting per mapping instead of per BO. Possible hints
226 VM_BIND allows cache/CLOS settings per mapping instead of per BO.
|
| /Linux-v6.1/include/drm/ |
| D | drm_gem_dma_helper.h | 166 * DRM_GEM_DMA_DRIVER_OPS_VMAP_WITH_DUMB_CREATE() instead.
183 * DRM_GEM_DMA_DRIVER_OPS_WITH_DUMB_CREATE() instead. Use
185 * on imported buffers should use DRM_GEM_DMA_DRIVER_OPS_VMAP instead.
204 * DRM_GEM_DMA_DRIVER_OPS_WITH_DUMB_CREATE() instead.
223 * DRM_GEM_DMA_DRIVER_OPS_VMAP_WITH_DUMB_CREATE() instead. Use
226 * instead.
|
| D | drm_crtc.h | 427 * points don't take a framebuffer object, but instead take directly a
431 * This entry point is deprecated, drivers should instead implement
453 * This entry point is deprecated, drivers should instead implement
473 * This entry point is deprecated, drivers should instead implement
568 * visible. This requirement has been lifted, and userspace is instead
677 * truly hardware/vendor specific state. Instead it is preferred to
682 * drm_atomic_crtc_set_property() instead.
697 * incomplete and hence likely inconsistent). Instead any such input
720 * drm_atomic_crtc_get_property() instead.
837 * instead.
[all …]
|
| D | drm_modeset_helper_vtables.h | 75 * facilitate transitions to atomic, but it is deprecated. Instead
90 * transitions to atomic, but it is deprecated. Instead @atomic_disable
105 * transitions to atomic, but it is deprecated. Instead @atomic_enable
170 * instead use the @atomic_check callback, but note that they're not
226 * the CRTC is suspended, but not restored. Such drivers should instead
238 * optimized fast-path instead of a full mode set operation with all the
287 * Atomic drivers should consider to use @atomic_disable instead of
523 * facilitate transitions to atomic, but it is deprecated. Instead
587 * instead use the @atomic_check callback. If @atomic_check is used,
616 * transitions to atomic, but it is deprecated. Instead @disable should
[all …]
|
| /Linux-v6.1/Documentation/filesystems/ |
| D | porting.rst | 35 Use FOO_I(inode) instead of &inode->u.foo_inode_i;
271 Use bdev_read_only(bdev) instead of is_read_only(kdev). The latter
297 is_read_only() is gone; use bdev_read_only() instead.
335 be used instead. It gets called whenever the inode is evicted, whether it has
462 argument; instead of passing IPERM_FLAG_RCU we add MAY_NOT_BLOCK into mask.
528 in your dentry operations instead.
534 vfs_readdir() is gone; switch to iterate_dir() instead
578 wrappers; instead of checking for ->write or ->read being NULL, look for
586 instead.
604 calling conventions for ->follow_link() have changed. Instead of returning
[all …]
|
| /Linux-v6.1/Documentation/filesystems/ext4/ |
| D | bigalloc.rst | 22 means that a block group addresses 32 gigabytes instead of 128 megabytes,
28 that block groups can be several gigabytes in size (instead of just
31 units of clusters instead of blocks” to the extent tree, though it is
|
| /Linux-v6.1/Documentation/devicetree/bindings/serial/ |
| D | snps-dw-apb-uart.yaml | 84 always be reported as active instead of being obtained from the modem
91 always be reported as active instead of being obtained from the modem
98 always be reported as active instead of being obtained from the modem
105 be reported as inactive instead of being obtained from the modem status
|
| /Linux-v6.1/drivers/firmware/arm_scmi/ |
| D | Kconfig | 94 primitives all over instead. If unsure say N.
115 with Legacy VirtIO backends and instead support only VirtIO Version 1
118 If you want instead to support also old Legacy VirtIO backends (like
135 primitives all over instead. If unsure say N.
|
| /Linux-v6.1/Documentation/userspace-api/media/cec/ |
| D | cec-ioc-g-mode.rst | 150 to handle most core messages instead of relying on the CEC
216 instead.
224 instead.
231 and this message has to be handled by a follower instead.
237 and this message has to be handled by a follower instead.
245 instead.
254 by a follower instead.
|
| /Linux-v6.1/include/linux/usb/ |
| D | quirks.h | 14 /* device can't resume correctly so reset it instead */
41 * calculation instead of the exponent variable used in the calculation.
55 * Device reports its bInterval as linear frames instead of the
|
| /Linux-v6.1/drivers/staging/media/imx/ |
| D | TODO | 7 instead the CSI subdev should call its neighbor's g_mbus_config op
21 removed, userspace should use the subdev-based userspace API instead.
50 pixel sampling mode. When the CSI bridge is instead integrated on an i.MX7,
|
| /Linux-v6.1/Documentation/block/ |
| D | biovecs.rst | 8 Instead, we have a new struct bvec_iter which represents a range of a biovec -
18 bi_size and bi_idx have been moved there; and instead of modifying bv_offset
32 instead of an integer (that corresponded to bi_idx); for a lot of code the
97 * Almost all usage of bi_idx is now incorrect and has been removed; instead,
101 I.e. instead of using bio_iovec_idx() (or bio->bi_iovec[bio->bi_idx]), you
|
| /Linux-v6.1/scripts/coccinelle/misc/ |
| D | flexible_array.cocci | 5 /// Flexible-array members should be used instead.
99 msg = "WARNING use flexible-array member instead (https://www.kernel.org/doc/html/latest/process/de…
106 msg = "WARNING use flexible-array member instead (https://www.kernel.org/doc/html/latest/process/de…
|
| /Linux-v6.1/drivers/gpu/drm/amd/display/ |
| D | TODO | 42 9. Attach plane and stream reources to state object instead of validate_context
46 * Use drm_display_info instead
60 doesn't slip in (i.e. if you start adding edid quirks to DC instead of
88 with like 3 levels of abstraction and using your own structures instead of the
|
| /Linux-v6.1/Documentation/process/ |
| D | deprecated.rst | 34 Use WARN() and WARN_ON() instead, and handle the "impossible"
70 Instead, the 2-factor form of the allocator should be used::
88 Instead, use the helper::
95 <#zero-length-and-one-element-arrays>`_ instead.
102 Instead, use the helpers::
148 instead use strscpy_pad().
168 exposure flaws in dmesg, proc, sysfs, etc. Instead of leaving these to
172 as it produces the more useful symbol name instead. For nearly everything
308 Instead, `flexible array members have incomplete type, and so the sizeof()
|
| /Linux-v6.1/include/uapi/linux/ |
| D | gpio.h | 307 * Use the latest version of the ABI, defined above, instead.
333 * Use &struct gpio_v2_line_info instead.
368 * Use &struct gpio_v2_line_info_changed instead.
410 * Use &struct gpio_v2_line_request instead.
432 * Use &struct gpio_v2_line_config instead.
447 * Use &struct gpio_v2_line_values instead.
473 * Use &struct gpio_v2_line_request instead.
495 * Use &struct gpio_v2_line_event instead.
521 * These ioctl()s are deprecated. Use the v2 equivalent instead.
|
| /Linux-v6.1/drivers/net/ethernet/realtek/ |
| D | Kconfig | 59 bool "Use PIO instead of MMIO"
63 This instructs the driver to use programmed I/O ports (PIO) instead
85 instead of an internal one. Disabling this option will save some
|
| /Linux-v6.1/include/dt-bindings/pinctrl/ |
| D | omap.h | 54 * Macros to allow using the absolute physical address instead of the
55 * padconf registers instead of the offset from padconf base.
72 * instead of the offset from padconf base.
|
| /Linux-v6.1/Documentation/scsi/ |
| D | ChangeLog.ncr53c8xx | 37 Use SCSI_NCR_IOMAPPED instead of NCR_IOMAPPED.
44 - Return value 1 (instead of 0) from the driver setup routine.
171 - Set for now MAX LUNS to 16 (instead of 8).
203 - Tiny misspelling fixed (ABORT instead of ABRT). Was fortunately
293 - Use of BITS_PER_LONG instead of (~0UL == 0xffffffffUL) has fixed
418 Use SDID instead as actual target number. Just have had to
442 - Prepare CCBs for SCSI commands that cannot be queued, instead of
452 the scripts to jump directly to the CCB on reselection instead
476 - Use FAST-5 instead of SLOW for slow scsi devices according to
484 . Programmed burst length set to 64 DWORDS (instead of 128).
|
| D | ChangeLog.sym53c8xx_2 | 8 equivalent containing sym or SYM instead.
36 since BIOS settings were trusted instead on first load.
141 - Use u_long instead of U32 for the IO base cookie. This is more
143 - Use MMIO per default for Power PC instead of some fake normal IO,
|
| /Linux-v6.1/Documentation/core-api/ |
| D | timekeeping.rst | 48 reference instead of UTC to avoid jumping on leap second updates.
156 Use ktime_get() or ktime_get_ts64() instead.
174 coarse-grained times can use the simple 'jiffies' instead, while
190 ktime_get()/ktime_get_ts64() instead for consistency.
|
