Searched full:identifies (Results 1 – 25 of 465) sorted by relevance
12345678910>>...19
| /Linux-v6.1/Documentation/ABI/testing/ |
| D | sysfs-platform-dell-privacy-wmi | 14 Identifies the local microphone can be muted by hardware, no applications
18 Identifies camera shutter controlled by hardware, which is a micromechanical
49 Identifies the local microphone can be muted by hardware, no applications
53 Identifies camera shutter controlled by hardware, which is a micromechanical
59 Identifies the privacy device is turned off
63 Identifies the privacy device is turned on,
|
| /Linux-v6.1/drivers/parisc/ |
| D | iosapic_private.h | 28 /* Entry Type 139 identifies an I/O SAPIC interrupt entry */
57 ** irq identifies PCI interrupt signal where
66 /* Source Bus ID identifies the bus where interrupt signal comes from */
71 ** identifies a segment of PCI buses (reserved in
77 ** Destination I/O SAPIC INTIN# identifies the INTIN n pin
83 ** Destination I/O SAPIC Address identifies the I/O SAPIC
|
| /Linux-v6.1/include/linux/ |
| D | pci-epf.h | 37 * @vendorid: identifies device manufacturer
38 * @deviceid: identifies a particular device
40 * @progif_code: identifies a specific register-level programming interface
41 * @subclass_code: identifies more specifically the function of the device
84 * @id_table: identifies EPF devices for probing
177 * @vector_ctrl: Identifies if the function is prohibited from sending a message
|
| /Linux-v6.1/Documentation/devicetree/bindings/interrupt-controller/ |
| D | marvell,sei.txt | 18 - interrupts: identifies the parent IRQ that will be triggered.
22 - interrupt-controller: identifies the node as an interrupt controller
24 - msi-controller: identifies the node as an MSI controller for the CPs
|
| D | al,alpine-msix.txt | 9 - interrupt-controller: identifies the node as an interrupt controller
10 - msi-controller: identifies the node as an PCI Message Signaled Interrupt
|
| D | marvell,odmi-controller.txt | 13 - interrupt,controller : Identifies the node as an interrupt controller.
15 - msi-controller : Identifies the node as an MSI controller.
|
| D | mediatek,cirq.txt | 17 - interrupt-controller : Identifies the node as an interrupt controller.
21 - mediatek,ext-irq-range: Identifies external irq number range in different
|
| D | marvell,armada-370-xp-mpic.txt | 6 - interrupt-controller: Identifies the node as an interrupt controller.
7 - msi-controller: Identifies the node as an PCI Message Signaled
|
| D | marvell,orion-intc.txt | 8 - interrupt-controller: identifies the node as an interrupt controller
32 - interrupt-controller: identifies the node as an interrupt controller
|
| D | open-pic.txt | 19 - interrupt-controller: The presence of this property identifies the node
42 - <1st-cell>: The interrupt-number that identifies the interrupt source.
|
| D | img,pdc-intc.txt | 16 - interrupt-controller: The presence of this property identifies the node
34 - <1st-cell>: The interrupt-number that identifies the interrupt source.
|
| /Linux-v6.1/Documentation/devicetree/bindings/powerpc/fsl/ |
| D | raideng.txt | 12 This identifies RAID Engine block. 1 in 1.0 represents
34 This identifies the job queue interface
52 This identifies job ring. Should contain either
|
| D | mpic.txt | 87 Identifies the interrupt source. The meaning
124 cell identifies the specific error
129 The interrupt-number cell identifies
135 The interrupt-number cell identifies
|
| /Linux-v6.1/Documentation/devicetree/bindings/riscv/ |
| D | cpus.yaml | 51 Identifies that the hart uses the RISC-V instruction set
52 and identifies the type of the hart.
56 Identifies the MMU address translation mode used on this
74 Identifies the specific RISC-V instruction set architecture
|
| /Linux-v6.1/net/tipc/ |
| D | name_distr.h | 55 * Reference field uniquely identifies port that published name sequence.
56 * Key field uniquely identifies publication, in the event a port has
59 * Note: There is no field that identifies the publishing node because it is
|
| /Linux-v6.1/include/uapi/linux/ |
| D | seg6_local.h | 90 * - SEG6_LOCAL_CNT_PACKETS: identifies a counter that counts the number of
94 * - SEG6_LOCAL_CNT_BYTES: identifies a counter that counts the total amount
99 * - SEG6_LOCAL_CNT_ERRORS: identifies a counter that counts the number of
|
| /Linux-v6.1/Documentation/networking/ |
| D | l2tp.rst | 157 CONN_ID Y Identifies the tunnel id to be destroyed.
165 CONN_ID Y Identifies the tunnel id to be modified.
174 CONN_ID N Identifies the tunnel id to be queried.
211 CONN_ID Y Identifies the parent tunnel id of the session
213 SESSION_ID Y Identifies the session id to be destroyed.
214 IFNAME N Identifies the session by interface name. If
225 CONN_ID Y Identifies the parent tunnel id of the session
227 SESSION_ID Y Identifies the session id to be modified.
228 IFNAME N Identifies the session by interface name. If
246 CONN_ID N Identifies the tunnel id to be queried.
[all …]
|
| /Linux-v6.1/drivers/s390/crypto/ |
| D | vfio_ap_private.h | 64 * @apm: identifies the AP adapters in the matrix
66 * @aqm: identifies the AP queues (domains) in the matrix
68 * @adm: identifies the AP control domains in the matrix
|
| /Linux-v6.1/drivers/media/platform/st/sti/delta/ |
| D | delta-mjpeg-fw.h | 74 /* identifies the horizontal decimation factor */
84 /* identifies the vertical decimation factor */
128 /* identifies the decoding mode */
|
| /Linux-v6.1/Documentation/devicetree/bindings/iio/temperature/ |
| D | adi,ltc2983.yaml | 68 description: Identifies the type of sensor connected to the device.
137 description: Identifies the sensor as a diode.
206 Identifies the number of wires used by the RTD. Setting this
348 description: Identifies the sensor as a direct adc.
368 description: Identifies the sensor as a rsense.
|
| /Linux-v6.1/drivers/media/platform/ti/davinci/ |
| D | vpif_capture.h | 79 /* Identifies video device for this channel */
85 /* Identifies channel */
|
| D | vpif_display.h | 93 struct video_device video_dev; /* Identifies video device for
102 enum vpif_channel_id channel_id;/* Identifies channel */
|
| /Linux-v6.1/drivers/net/wireless/ath/wil6210/ |
| D | fw.h | 61 /* identifies capabilities record */
87 /* identifies concurrency record */
108 /* identifies brd file record */
|
| /Linux-v6.1/drivers/gpu/drm/vmwgfx/ |
| D | vmwgfx_msg.c | 552 * @dev: Identifies the drm device.
554 * @file_priv: Identifies the caller.
829 * @dev_priv: Identifies the drm private device.
901 * @dev_priv: Identifies the drm private device.
983 * @dev: Identifies the drm device.
985 * @file_priv: Identifies the caller; unused.
1003 * @dev: Identifies the drm device.
1005 * @file_priv: Identifies the caller; unused.
1147 * @dev: Identifies the drm device.
1149 * @file_priv: Identifies the caller; unused.
|
| /Linux-v6.1/include/media/davinci/ |
| D | vpbe_display.h | 81 /* Identifies video device for this layer */
96 /* Identifies device object */
|
12345678910>>...19
