Searched full:identifies (Results 1 – 25 of 457) sorted by relevance
12345678910>>...19
| /Linux-v5.15/Documentation/ABI/testing/ |
| D | sysfs-platform-dell-privacy-wmi | 13 Identifies the local microphone can be muted by hardware, no applications
17 Identifies camera shutter controlled by hardware, which is a micromechanical
45 Identifies the privacy device is turned off and cannot send stream to OS applications
48 Identifies the privacy device is turned on ,audio or camera driver can get
|
| D | sysfs-class-cxl | 183 Identifies the CAIA Version the card implements.
190 Identifies the revision level of the PSL.
197 Identifies the revision level of the base image for devices
198 that support loadable PSLs. For FPGAs this field identifies
|
| /Linux-v5.15/drivers/parisc/ |
| D | iosapic_private.h | 28 /* Entry Type 139 identifies an I/O SAPIC interrupt entry */
57 ** irq identifies PCI interrupt signal where
66 /* Source Bus ID identifies the bus where interrupt signal comes from */
71 ** identifies a segment of PCI buses (reserved in
77 ** Destination I/O SAPIC INTIN# identifies the INTIN n pin
83 ** Destination I/O SAPIC Address identifies the I/O SAPIC
|
| /Linux-v5.15/include/linux/ |
| D | pci-epf.h | 37 * @vendorid: identifies device manufacturer
38 * @deviceid: identifies a particular device
40 * @progif_code: identifies a specific register-level programming interface
41 * @subclass_code: identifies more specifically the function of the device
84 * @id_table: identifies EPF devices for probing
177 * @vector_ctrl: Identifies if the function is prohibited from sending a message
|
| /Linux-v5.15/Documentation/devicetree/bindings/interrupt-controller/ |
| D | marvell,sei.txt | 18 - interrupts: identifies the parent IRQ that will be triggered.
22 - interrupt-controller: identifies the node as an interrupt controller
24 - msi-controller: identifies the node as an MSI controller for the CPs
|
| D | al,alpine-msix.txt | 9 - interrupt-controller: identifies the node as an interrupt controller
10 - msi-controller: identifies the node as an PCI Message Signaled Interrupt
|
| D | marvell,odmi-controller.txt | 13 - interrupt,controller : Identifies the node as an interrupt controller.
15 - msi-controller : Identifies the node as an MSI controller.
|
| D | mediatek,cirq.txt | 17 - interrupt-controller : Identifies the node as an interrupt controller.
21 - mediatek,ext-irq-range: Identifies external irq number range in different
|
| D | marvell,armada-370-xp-mpic.txt | 6 - interrupt-controller: Identifies the node as an interrupt controller.
7 - msi-controller: Identifies the node as an PCI Message Signaled
|
| D | marvell,orion-intc.txt | 8 - interrupt-controller: identifies the node as an interrupt controller
32 - interrupt-controller: identifies the node as an interrupt controller
|
| D | open-pic.txt | 19 - interrupt-controller: The presence of this property identifies the node
42 - <1st-cell>: The interrupt-number that identifies the interrupt source.
|
| D | img,pdc-intc.txt | 16 - interrupt-controller: The presence of this property identifies the node
34 - <1st-cell>: The interrupt-number that identifies the interrupt source.
|
| /Linux-v5.15/Documentation/devicetree/bindings/riscv/ |
| D | cpus.yaml | 46 Identifies that the hart uses the RISC-V instruction set
47 and identifies the type of the hart.
51 Identifies the MMU address translation mode used on this
64 Identifies the specific RISC-V instruction set architecture
|
| /Linux-v5.15/Documentation/devicetree/bindings/powerpc/fsl/ |
| D | raideng.txt | 12 This identifies RAID Engine block. 1 in 1.0 represents
34 This identifies the job queue interface
52 This identifies job ring. Should contain either
|
| D | mpic.txt | 87 Identifies the interrupt source. The meaning
124 cell identifies the specific error
129 The interrupt-number cell identifies
135 The interrupt-number cell identifies
|
| /Linux-v5.15/include/uapi/linux/ |
| D | seg6_local.h | 89 * - SEG6_LOCAL_CNT_PACKETS: identifies a counter that counts the number of
93 * - SEG6_LOCAL_CNT_BYTES: identifies a counter that counts the total amount
98 * - SEG6_LOCAL_CNT_ERRORS: identifies a counter that counts the number of
|
| /Linux-v5.15/net/tipc/ |
| D | name_distr.h | 55 * Reference field uniquely identifies port that published name sequence.
56 * Key field uniquely identifies publication, in the event a port has
59 * Note: There is no field that identifies the publishing node because it is
|
| /Linux-v5.15/drivers/s390/crypto/ |
| D | vfio_ap_private.h | 58 * @apm identifies the AP adapters in the matrix
60 * @aqm identifies the AP queues (domains) in the matrix
62 * @adm identifies the AP control domains in the matrix
|
| /Linux-v5.15/Documentation/networking/ |
| D | l2tp.rst | 157 CONN_ID Y Identifies the tunnel id to be destroyed.
165 CONN_ID Y Identifies the tunnel id to be modified.
174 CONN_ID N Identifies the tunnel id to be queried.
211 CONN_ID Y Identifies the parent tunnel id of the session
213 SESSION_ID Y Identifies the session id to be destroyed.
214 IFNAME N Identifies the session by interface name. If
225 CONN_ID Y Identifies the parent tunnel id of the session
227 SESSION_ID Y Identifies the session id to be modified.
228 IFNAME N Identifies the session by interface name. If
246 CONN_ID N Identifies the tunnel id to be queried.
[all …]
|
| /Linux-v5.15/drivers/media/platform/sti/delta/ |
| D | delta-mjpeg-fw.h | 74 /* identifies the horizontal decimation factor */
84 /* identifies the vertical decimation factor */
128 /* identifies the decoding mode */
|
| /Linux-v5.15/Documentation/devicetree/bindings/iio/temperature/ |
| D | adi,ltc2983.yaml | 68 description: Identifies the type of sensor connected to the device.
137 description: Identifies the sensor as a diode.
206 Identifies the number of wires used by the RTD. Setting this
348 description: Identifies the sensor as a direct adc.
368 description: Identifies the sensor as a rsense.
|
| /Linux-v5.15/drivers/media/platform/davinci/ |
| D | vpif_capture.h | 79 /* Identifies video device for this channel */
85 /* Identifies channel */
|
| /Linux-v5.15/drivers/net/wireless/ath/wil6210/ |
| D | fw.h | 61 /* identifies capabilities record */
87 /* identifies concurrency record */
108 /* identifies brd file record */
|
| /Linux-v5.15/include/media/davinci/ |
| D | vpbe_display.h | 81 /* Identifies video device for this layer */
96 /* Identifies device object */
|
| /Linux-v5.15/drivers/gpu/drm/vmwgfx/ |
| D | vmwgfx_msg.c | 552 * @dev: Identifies the drm device.
554 * @file_priv: Identifies the caller.
829 * @dev_priv: Identifies the drm private device.
901 * @dev_priv: Identifies the drm private device.
983 * @dev: Identifies the drm device.
985 * @file_priv: Identifies the caller; unused.
1003 * @dev: Identifies the drm device.
1005 * @file_priv: Identifies the caller; unused.
1146 * @dev: Identifies the drm device.
1148 * @file_priv: Identifies the caller; unused.
|
12345678910>>...19
