Searched full:identically (Results 1 – 25 of 61) sorted by relevance
123
/Linux-v6.1/drivers/iommu/arm/arm-smmu/ |
D | arm-smmu-nvidia.c | 16 * Two of them are used together and must be programmed identically for 28 * be programmed identically and takes care of invoking the memory controller
|
/Linux-v6.1/arch/sparc/include/asm/ |
D | ide.h | 29 /* On sparc, I/O ports and MMIO registers are accessed identically. */
|
/Linux-v6.1/Documentation/driver-api/media/drivers/ |
D | cpia2_devel.rst | 29 The two chipsets operate almost identically. The core is an 8051 processor,
|
/Linux-v6.1/drivers/scsi/lpfc/ |
D | lpfc_disc.h | 266 * waiting, and the ADISC list count is identically 0, then we are done. For 273 * identically 0, then we are done. We have now completed discovery / RSCN
|
/Linux-v6.1/drivers/pinctrl/nomadik/ |
D | pinctrl-nomadik.h | 126 * array, and be numbered identically to the GPIO controller's
|
D | pinctrl-abx500.h | 143 * array, and be numbered identically to the GPIO controller's
|
/Linux-v6.1/Documentation/ABI/testing/ |
D | sysfs-bus-cxl | 27 identically named field in the Identify Memory Device Output 37 identically named field in the Identify Memory Device Output
|
/Linux-v6.1/drivers/gpu/drm/panfrost/ |
D | panfrost_device.h | 69 * handled identically, as only values > 1 need special handling.
|
/Linux-v6.1/drivers/pwm/ |
D | pwm-pxa.c | 153 * supported identically.
|
/Linux-v6.1/drivers/pinctrl/tegra/ |
D | pinctrl-tegra.h | 179 * array, and be numbered identically to the GPIO controller's
|
/Linux-v6.1/Documentation/userspace-api/media/v4l/ |
D | dev-subdev.rst | 57 behave identically as when issued on V4L2 device nodes, with the 69 :ref:`event`. The API behaves identically as when used on V4L2 device
|
/Linux-v6.1/drivers/net/mdio/ |
D | mdio-bitbang.c | 129 lower 16 bits of the 21 bit address. This transfer is done identically to a
|
/Linux-v6.1/Documentation/devicetree/bindings/iommu/ |
D | arm,smmu.yaml | 63 and may program multiple ARM MMU-500s identically with the memory
|
/Linux-v6.1/Documentation/driver-api/driver-model/ |
D | driver.rst | 271 macro that works identically to the DEVICE_ATTR_RW and DEVICE_ATTR_RO
|
/Linux-v6.1/lib/ |
D | test_user_copy.c | 77 * And we verify that check_nonzero_user() acts identically to in test_check_nonzero_user()
|
/Linux-v6.1/Documentation/driver-api/media/ |
D | v4l2-subdev.rst | 347 behave identically, with the only exception that they deal only with 357 behave identically, with the only exception that they deal only with
|
/Linux-v6.1/fs/ntfs3/lib/ |
D | decompress_common.c | 277 * identically to other internal (non-leaf) in make_huffman_decode_table()
|
/Linux-v6.1/Documentation/xtensa/ |
D | mmu.rst | 6 identically to MMUv2 fixed memory mapping. Depending on
|
/Linux-v6.1/drivers/pinctrl/spear/ |
D | pinctrl-spear.h | 139 * and be numbered identically to the GPIO controller's *numbering.
|
/Linux-v6.1/drivers/crypto/caam/ |
D | dpseci.c | 192 * Rx queues identically.
|
/Linux-v6.1/drivers/edac/ |
D | i3000_edac.c | 288 * If the channels aren't populated identically then in i3000_is_interleaved()
|
/Linux-v6.1/drivers/gpu/drm/amd/amdkfd/ |
D | kfd_flat_memory.c | 243 * In GPUVM mode, the Shared/Private apertures are specified identically
|
/Linux-v6.1/arch/x86/math-emu/ |
D | reg_round.S | 69 | There are a few rare cases where the results are not set identically to |
|
/Linux-v6.1/include/linux/ |
D | swap.h | 182 * from setup, they're handled identically.
|
/Linux-v6.1/kernel/ |
D | panic.c | 506 * It just happens that oops_enter() and oops_exit() are identically
|
123