Searched full:ibb (Results 1 – 18 of 18) sorted by relevance
| /Linux-v6.1/Documentation/devicetree/bindings/regulator/ |
| D | qcom-labibb-regulator.yaml | 7 title: Qualcomm's LAB(LCD AMOLED Boost)/IBB(Inverting Buck Boost) Regulator
13 LAB can be used as a positive boost power supply and IBB can be used as a
19 const: qcom,pmi8998-lab-ibb
47 ibb:
62 Short-circuit and over-current interrupts for ibb.
84 compatible = "qcom,pmi8998-lab-ibb";
92 ibb {
|
| /Linux-v6.1/arch/arm64/boot/dts/qcom/ |
| D | pmi8998.dtsi | 30 compatible = "qcom,pmi8998-lab-ibb";
32 ibb: ibb { label
|
| D | sdm845-lg-judyln.dts | 25 ibb-supply = <&ibb>;
|
| D | msm8998-sony-xperia-yoshino-lilac.dts | 17 &ibb {
|
| D | sdm845-sony-xperia-tama-akatsuki.dts | 15 /* For the future: WLED + LAB/IBB/OLEDB are not used on Akatsuki */
|
| D | msm8998-sony-xperia-yoshino-poplar.dts | 17 &ibb {
|
| D | msm8998-sony-xperia-yoshino-maple.dts | 29 &ibb {
|
| D | sdm845-xiaomi-beryllium.dts | 229 vddneg-supply = <&ibb>;
276 &ibb {
|
| D | sdm845-xiaomi-polaris.dts | 389 vddneg-supply = <&ibb>;
442 &ibb {
|
| D | sm8250-sony-xperia-edo.dtsi | 248 * ibb: 800000-5400000
|
| D | msm8998-sony-xperia-yoshino.dtsi | 270 &ibb {
|
| /Linux-v6.1/drivers/regulator/ |
| D | qcom-labibb-regulator.c | 170 * of the LAB and IBB regulators will be forced (regulators will be
173 * As last, if the writes to shut down the LAB/IBB regulators fail
334 /* IRQ polarities - LAB: trigger-low, IBB: trigger-high */ in qcom_labibb_set_ocp()
381 * This function checks the STATUS1 register on both LAB and IBB regulators
454 * and IBB when a short-circuit event is detected, so we have to in qcom_labibb_sc_recovery_worker()
526 * The LAB and IBB regulators will be automatically disabled by the
634 /* IBB discharge resistor values in KOhms */
751 {"ibb", QCOM_IBB_TYPE, PMI8998_IBB_REG_BASE, &pmi8998_ibb_desc},
756 { .compatible = "qcom,pmi8998-lab-ibb", .data = &pmi8998_labibb_data},
855 /* IBB Limits: 0-1550mA */ in qcom_labibb_regulator_probe()
[all …]
|
| D | Kconfig | 1518 tristate "QCOM LAB/IBB regulator support"
1521 This driver supports Qualcomm's LAB/IBB regulators present on the
1522 Qualcomm's PMIC chip pmi8998. QCOM LAB and IBB are SPMI
1524 boost regulator and IBB can be used as a negative boost regulator
|
| /Linux-v6.1/Documentation/devicetree/bindings/display/panel/ |
| D | ebbg,ft8719.yaml | 62 vddneg-supply = <&ibb>;
|
| D | novatek,nt36672a.yaml | 75 vddneg-supply = <&ibb>;
|
| D | novatek,nt35950.yaml | 81 avee-supply = <&ibb>;
|
| /Linux-v6.1/drivers/dma/ |
| D | mv_xor_v2.c | 670 * (OBB/IBB) requests to the maximal value. in mv_xor_v2_descq_init()
|
| /Linux-v6.1/drivers/i2c/busses/ |
| D | i2c-imx.c | 1291 "<%s> STATUS: ICF=%d, IAAS=%d, IBB=%d, IAL=%d, SRW=%d, IIF=%d, RXAK=%d\n", in i2c_imx_xfer_common()
|
