Searched full:hooked (Results 1 – 25 of 157) sorted by relevance
1234567
/Linux-v6.1/drivers/staging/iio/meter/ |
D | Kconfig | 22 Say Y here if you have ADE7854/58/68/78 hooked to an I2C bus. 32 Say Y here if you have ADE7854/58/68/78 hooked to a SPI bus.
|
/Linux-v6.1/Documentation/devicetree/bindings/media/ |
D | cec-gpio.txt | 4 is hooked up to a pull-up GPIO line and - optionally - the HPD line is 5 hooked up to another GPIO line.
|
/Linux-v6.1/Documentation/userspace-api/media/cec/ |
D | cec-ioc-adap-g-phys-addr.rst | 66 has address 0.0.0.0. Every device that is hooked up to an input of the 67 TV has address a.0.0.0 (where 'a' is ≥ 1), devices hooked up to those in
|
/Linux-v6.1/drivers/input/misc/ |
D | stpmic1_onkey.c | 17 * @irq_falling: irq that we are hooked on to 18 * @irq_rising: irq that we are hooked on to
|
D | Kconfig | 61 Say Y here if you have AD7142/AD7147 hooked to an I2C bus. 71 Say Y here if you have AD7142/AD7147 hooked to a SPI bus. 127 acceleration sensor hooked to an I2C bus. 718 Say Y here if you have ADXL345/6 hooked to an I2C bus. 728 Say Y here if you have ADXL345/6 hooked to a SPI bus.
|
/Linux-v6.1/Documentation/devicetree/bindings/power/ |
D | rockchip-io-domain.yaml | 18 If the regulator hooked up to a pin like SDMMC0_VDD is 3.3V then 19 bit 7 of GRF_IO_VSEL needs to be 0. If the regulator hooked up to 24 hooked up to the pins.
|
/Linux-v6.1/Documentation/devicetree/bindings/interrupt-controller/ |
D | fsl,ls-scfg-msi.txt | 17 is hooked to a parent interrupt controller: e.g: ARM GIC for ARM-based
|
/Linux-v6.1/Documentation/devicetree/bindings/display/ |
D | dp-aux-bus.yaml | 14 are hooked up to them. This is the DP AUX bus. Over the DP AUX bus
|
/Linux-v6.1/Documentation/devicetree/bindings/display/panel/ |
D | panel-edp.yaml | 108 needed if HPD hooked up, either through a GPIO in the panel node or 109 hooked up directly to the eDP controller.
|
/Linux-v6.1/Documentation/admin-guide/LSM/ |
D | index.rst | 6 various security checks to be hooked by new kernel extensions. The name
|
/Linux-v6.1/drivers/media/pci/zoran/ |
D | videocodec.c | 190 zrdev_dbg(zr, "videocodec: hooked in as first element\n"); in videocodec_register() 195 zrdev_dbg(zr, "videocodec: hooked in after '%s'\n", in videocodec_register()
|
/Linux-v6.1/arch/arm/boot/dts/ |
D | rk3288-veyron-sdmmc.dtsi | 34 * Builtin CD line is hooked to ground to prevent JTAG at boot
|
D | rk3288-evb.dtsi | 166 * NOTE: vcc_sd isn't hooked up on v1.0 boards where power comes from 229 disable-wp; /* wp not hooked up */
|
D | sun6i-a31-colombus.dts | 64 /* The lcd panel i2c interface is hooked up via gpios */
|
D | sun5i-a13-utoo-p66.dts | 62 /* The lcd panel i2c interface is hooked up via gpios */
|
/Linux-v6.1/net/ipv4/netfilter/ |
D | iptable_raw.c | 3 * 'raw' table, which is the very first hooked in at PRE_ROUTING and LOCAL_OUT .
|
/Linux-v6.1/include/drm/display/ |
D | drm_dp_aux_bus.h | 21 * be hooked up there.
|
/Linux-v6.1/arch/arm64/boot/dts/qcom/ |
D | sc7280-chrome-common.dtsi | 65 * Chrome designs always boot from SPI flash hooked up to the qspi.
|
D | sc7280-herobrine-villager.dtsi | 113 * - If a pin is not hooked up on Qcard, it gets no name.
|
/Linux-v6.1/arch/arc/mm/ |
D | highmem.c | 35 * - Both fixmap/pkmap use a dedicated page table each, hooked up to swapper PGD
|
/Linux-v6.1/Documentation/sound/soc/ |
D | jack.rst | 69 These are all hooked together by the machine driver depending on the
|
/Linux-v6.1/sound/pci/hda/ |
D | Makefile | 61 # otherwise the codec patches won't be hooked before the PCI probe
|
/Linux-v6.1/arch/arc/include/asm/ |
D | smp.h | 37 * Takes @cpu and @hwirq to which the arch-common ISR is hooked up
|
/Linux-v6.1/arch/powerpc/include/asm/ |
D | xics.h | 89 /* ICS instance, hooked up to chip_data of an irq */
|
/Linux-v6.1/drivers/media/platform/mediatek/vcodec/ |
D | mtk_vcodec_drv.h | 249 * @dec_if: hooked decoder driver interface 250 * @enc_if: hooked encoder driver interface
|
1234567