| /Linux-v6.1/sound/soc/intel/catpt/ |
| D | ipc.c | 150 struct catpt_notify_glitch glitch; in catpt_dsp_notify_stream() local
168 memcpy_fromio(&glitch, catpt_inbox_addr(cdev), sizeof(glitch)); in catpt_dsp_notify_stream()
169 trace_catpt_ipc_payload((u8 *)&glitch, sizeof(glitch)); in catpt_dsp_notify_stream()
171 dev_warn(cdev->dev, "glitch %d at pos: 0x%08llx, wp: 0x%08x\n", in catpt_dsp_notify_stream()
172 glitch.type, glitch.presentation_pos, in catpt_dsp_notify_stream()
173 glitch.write_pos); in catpt_dsp_notify_stream()
|
| /Linux-v6.1/drivers/pinctrl/ |
| D | pinctrl-at91.h | 18 #define PIO_IFER 0x20 /* Glitch Input Filter Enable */
19 #define PIO_IFDR 0x24 /* Glitch Input Filter Disable */
20 #define PIO_IFSR 0x28 /* Glitch Input Filter Status */
|
| /Linux-v6.1/drivers/clk/qcom/ |
| D | clk-rcg.h | 99 * struct clk_dyn_rcg - root clock generator with glitch free mux
101 * @mux_sel_bit: bit to switch glitch free mux
104 * @bank_reg: register to XOR @mux_sel_bit into to switch glitch free mux
|
| /Linux-v6.1/arch/arm64/boot/dts/amlogic/ |
| D | meson-gxbb.dtsi | 743 * VPU_0 and VPU_1 muxed to a single clock by a glitch
745 * Same for VAPB but with a final gate after the glitch free mux.
749 <&clkc CLKID_VPU>, /* Glitch free mux */
752 <&clkc CLKID_VAPB_SEL>; /* Glitch free mux */
|
| D | meson-gxl.dtsi | 812 * VPU_0 and VPU_1 muxed to a single clock by a glitch
814 * Same for VAPB but with a final gate after the glitch free mux.
818 <&clkc CLKID_VPU>, /* Glitch free mux */
821 <&clkc CLKID_VAPB_SEL>; /* Glitch free mux */
|
| /Linux-v6.1/drivers/rtc/ |
| D | rtc-mxc_v2.c | 16 #define SRTC_LPPDR_INIT 0x41736166 /* init for glitch detect */
34 #define SRTC_LPPDR 0x18 /* LP Power Supply Glitch Detector Reg */
313 /* initialize glitch detect */ in mxc_rtc_probe()
|
| D | rtc-dm355evm.c | 22 * The only real glitch is the inability to read or write all four
|
| D | rtc-max6916.c | 128 /*Enable oscillator,disable oscillator stop flag, glitch filter*/ in max6916_probe()
|
| /Linux-v6.1/arch/arm/mach-s3c/ |
| D | pm-gpio.c | 108 * { OUT => SFN } Change CON first, so new data will not glitch
109 * { OUT => IN } Change CON first, so new data will not glitch
111 * { SFN => OUT } Change DAT first, so new data will not glitch [1]
|
| D | pm.h | 92 * that we do not glitch the state of the pins from that the bootloader's
|
| /Linux-v6.1/drivers/pinctrl/nomadik/ |
| D | pinctrl-nomadik.c | 378 bool glitch) in __nmk_gpio_set_mode_safe() argument
383 if (glitch && nmk_chip->set_ioforce) { in __nmk_gpio_set_mode_safe()
395 if (glitch && nmk_chip->set_ioforce) { in __nmk_gpio_set_mode_safe()
1530 bool glitch; in nmk_pmx_set() local
1562 glitch = ((g->altsetting & NMK_GPIO_ALT_C) == NMK_GPIO_ALT_C); in nmk_pmx_set()
1564 if (glitch) { in nmk_pmx_set()
1604 (g->altsetting & NMK_GPIO_ALT_C), glitch); in nmk_pmx_set()
1624 if (glitch) { in nmk_pmx_set()
1656 /* There is no glitch when converting any pin to GPIO */ in nmk_gpio_request_enable()
1770 /* No glitch when going to GPIO mode */ in nmk_pin_config_set()
|
| /Linux-v6.1/Documentation/devicetree/bindings/phy/ |
| D | qcom,usb-hsic-phy.txt | 38 Definition: List of pinctrl settings to apply to keep HSIC pins in a glitch
|
| /Linux-v6.1/Documentation/devicetree/bindings/clock/ |
| D | qcom,aoncc-sm8250.yaml | 31 - description: Glitch Free Mux register clock
|
| D | qcom,audiocc-sm8250.yaml | 31 - description: Glitch Free Mux register clock
|
| /Linux-v6.1/include/linux/pinctrl/ |
| D | pinctrl-state.h | 19 * glitch the pins. In those cases you can add an "init" pinctrl
|
| /Linux-v6.1/Documentation/devicetree/bindings/leds/ |
| D | common.yaml | 65 default-state property is set the to same value, then no glitch should be
68 glitch.
|
| /Linux-v6.1/Documentation/ABI/testing/ |
| D | sysfs-class-mei | 90 The ME FW writes Glitch Detection HW (TRC)
|
| /Linux-v6.1/include/dt-bindings/pinctrl/ |
| D | dra.h | 30 /* Certain pins need virtual mode, but note: they may glitch */
|
| /Linux-v6.1/drivers/hwmon/pmbus/ |
| D | delta-ahe50dc-fan.c | 23 * system's power outputs experience a glitch. in ahe50dc_fan_write_byte()
|
| /Linux-v6.1/drivers/net/can/flexcan/ |
| D | flexcan.h | 22 * SOC Version IP-Version Glitch- [TR]WRN_INT IRQ Err Memory err RTR rece- FD Mode MB
|
| /Linux-v6.1/drivers/gpio/ |
| D | gpio-ts4900.c | 67 * prevents a glitch that can occur on the IO line. in ts4900_gpio_direction_output()
|
| /Linux-v6.1/Documentation/driver-api/gpio/ |
| D | intro.rst | 56 input de-glitch/debounce logic, sometimes with software controls.
|
| /Linux-v6.1/drivers/pwm/ |
| D | pwm-iqs620a.c | 11 * and may result in a glitch during the period in which the change is made.
|
| /Linux-v6.1/Documentation/admin-guide/gpio/ |
| D | sysfs.rst | 77 initializing the value as low. To ensure glitch free
|
| /Linux-v6.1/drivers/iio/chemical/ |
| D | sps30_i2c.c | 143 * Power-on-reset causes sensor to produce some glitch on i2c bus and in sps30_i2c_reset()
|
