Searched full:flagged (Results 1 – 25 of 183) sorted by relevance
12345678
| /Linux-v6.6/Documentation/devicetree/bindings/serio/ |
| D | ps2-gpio.yaml | 18 the gpio used for the data signal - this should be flagged as
26 the gpio used for the clock signal - this should be flagged as
|
| /Linux-v6.6/include/uapi/linux/ |
| D | neighbour.h | 80 * flagged entries explicitly are (which is also consistent with the routing
87 * NTF_EXT_MANAGED flagged neigbor entries are managed by the kernel on behalf
91 * NTF_EXT_LOCKED flagged bridge FDB entries are entries generated by the
|
| D | bsg.h | 30 __u64 request_tag; /* [i] {SCSI: task tag (only if flagged)} */
|
| D | dlm.h | 51 * -EAGAIN if request would block and is flagged DLM_LKF_NOQUEUE
|
| /Linux-v6.6/Documentation/devicetree/bindings/i2c/ |
| D | i2c-gpio.yaml | 22 gpio used for the sda signal, this should be flagged as
30 gpio used for the scl signal, this should be flagged as
|
| /Linux-v6.6/Documentation/devicetree/bindings/input/ |
| D | atmel,maxtouch.yaml | 42 (active low). The line must be flagged with
49 (active low). The line must be flagged with
|
| /Linux-v6.6/drivers/power/supply/ |
| D | max8903_charger.c | 91 * library as the line should be flagged GPIO_ACTIVE_LOW in the device in max8903_dcin()
150 * library as the line should be flagged GPIO_ACTIVE_LOW in the device in max8903_usbin()
206 * library as the line should be flagged GPIO_ACTIVE_LOW in the device in max8903_fault()
|
| /Linux-v6.6/Documentation/devicetree/bindings/gnss/ |
| D | mediatek.yaml | 30 If the line is active low it should be flagged with GPIO_ACTIVE_LOW.
|
| D | brcm,bcm4751.yaml | 44 description: An optional active low reset line, should be flagged with
|
| D | sirfstar.yaml | 46 description: An optional active low reset line, should be flagged with
|
| /Linux-v6.6/drivers/net/ethernet/toshiba/ |
| D | spider_net.h | 151 /* we rely on flagged descriptor interrupts */
323 /* We rely on flagged descriptor interrupts */
|
| /Linux-v6.6/Documentation/devicetree/bindings/iio/light/ |
| D | capella,cm3605.yaml | 29 ASET line (drive low to activate the ALS, should be flagged
|
| /Linux-v6.6/drivers/clk/davinci/ |
| D | pll-da830.c | 27 * NB: Technically, the clocks flagged as SYSCLK_FIXED_DIV are "fixed ratio",
|
| /Linux-v6.6/Documentation/devicetree/bindings/nvmem/ |
| D | u-boot,env.yaml | 37 - description: Two redundant blocks with active one flagged
|
| /Linux-v6.6/Documentation/networking/ |
| D | rxrpc.rst | 244 (#) When receiving data or messages for a call, MSG_EOR is flagged by recvmsg
315 for the next taker. MSG_TRUNC will never be flagged.
319 flagged.
616 pick up. MSG_MORE will be flagged by recvmsg() if there's more reply data
625 buffer instead, and MSG_EOR will be flagged to indicate the end of that
724 be delivered with MSG_MORE flagged.
752 MSG_EOR will be flagged to indicate that this is the final message for
|
| /Linux-v6.6/fs/xfs/ |
| D | xfs_health.c | 71 * However, we must be careful -- when FSCOUNTERS are flagged in xfs_health_unmount()
78 * there were filesystem problems, FSCOUNTERS was flagged, and in xfs_health_unmount()
|
| /Linux-v6.6/Documentation/devicetree/bindings/soc/qcom/ |
| D | qcom,smsm.yaml | 55 node. Nodes can either be flagged as an interrupt-controller to denote a
|
| /Linux-v6.6/Documentation/userspace-api/media/v4l/ |
| D | pixfmt-v4l2-mplane.rst | 35 compressed data flagged with ``V4L2_FMT_FLAG_COMPRESSED`` at
|
| /Linux-v6.6/Documentation/filesystems/ |
| D | automount-support.rst | 59 If a vfsmount was already flagged for expiry, and if its usage count is 1
|
| /Linux-v6.6/drivers/regulator/ |
| D | irq_helpers.c | 218 * If any of the flagged regulators is enabled we do in regulator_notifier_isr()
321 * @common_errs: Errors which can be flagged by this IRQ for all rdevs.
|
| /Linux-v6.6/drivers/clk/qcom/ |
| D | krait-cc.c | 128 /* clk-krait ignore any rate change if mux is not flagged as enabled */ in krait_add_div()
212 /* clk-krait ignore any rate change if mux is not flagged as enabled */ in krait_add_sec_mux()
|
| /Linux-v6.6/drivers/gpu/drm/nouveau/nvkm/engine/fifo/ |
| D | runl.c | 74 /* Look for channel groups flagged for RC. */ in nvkm_runl_rc()
100 /* Look for engines that are still on flagged channel groups - reset them. */ in nvkm_runl_rc()
|
| /Linux-v6.6/Documentation/block/ |
| D | writeback_cache_control.rst | 27 storage before the flagged bio starts. In addition the REQ_PREFLUSH flag can be
|
| /Linux-v6.6/arch/arm/boot/dts/intel/ixp/ |
| D | intel-ixp42x-dlink-dsm-g600.dts | 47 /* CHECKME: flagged as active low in the old board file */
|
| /Linux-v6.6/drivers/video/backlight/ |
| D | bd6107.c | 146 * the line should be flagged as active low so this will assert in bd6107_probe()
|
12345678
