Home
last modified time | relevance | path

Searched full:flagged (Results 1 – 25 of 147) sorted by relevance

123456

/Linux-v5.15/Documentation/devicetree/bindings/i2c/
Di2c-gpio.yaml22 gpio used for the sda signal, this should be flagged as
30 gpio used for the scl signal, this should be flagged as
/Linux-v5.15/Documentation/devicetree/bindings/input/
Datmel,maxtouch.yaml39 (active low). The line must be flagged with
46 (active low). The line must be flagged with
/Linux-v5.15/drivers/power/supply/
Dmax8903_charger.c92 * library as the line should be flagged GPIO_ACTIVE_LOW in the device in max8903_dcin()
151 * library as the line should be flagged GPIO_ACTIVE_LOW in the device in max8903_usbin()
207 * library as the line should be flagged GPIO_ACTIVE_LOW in the device in max8903_fault()
/Linux-v5.15/Documentation/devicetree/bindings/iio/light/
Dcapella,cm3605.yaml29 ASET line (drive low to activate the ALS, should be flagged
/Linux-v5.15/drivers/net/ethernet/toshiba/
Dspider_net.h152 /* we rely on flagged descriptor interrupts */
324 /* We rely on flagged descriptor interrupts */
/Linux-v5.15/drivers/clk/davinci/
Dpll-da830.c27 * NB: Technically, the clocks flagged as SYSCLK_FIXED_DIV are "fixed ratio",
Dpll-da850.c43 * NB: Technically, the clocks flagged as SYSCLK_FIXED_DIV are "fixed ratio",
/Linux-v5.15/Documentation/networking/
Drxrpc.rst244 (#) When receiving data or messages for a call, MSG_EOR is flagged by recvmsg
315 for the next taker. MSG_TRUNC will never be flagged.
319 flagged.
616 pick up. MSG_MORE will be flagged by recvmsg() if there's more reply data
625 buffer instead, and MSG_EOR will be flagged to indicate the end of that
724 be delivered with MSG_MORE flagged.
752 MSG_EOR will be flagged to indicate that this is the final message for
/Linux-v5.15/fs/xfs/
Dxfs_health.c71 * However, we must be careful -- when FSCOUNTERS are flagged in xfs_health_unmount()
78 * there were filesystem problems, FSCOUNTERS was flagged, and in xfs_health_unmount()
/Linux-v5.15/Documentation/devicetree/bindings/soc/qcom/
Dqcom,smsm.txt44 Nodes can either be flagged as an interrupt-controller to denote a remote
/Linux-v5.15/include/uapi/linux/
Dbsg.h30 __u64 request_tag; /* [i] {SCSI: task tag (only if flagged)} */
Ddlm.h51 * -EAGAIN if request would block and is flagged DLM_LKF_NOQUEUE
/Linux-v5.15/Documentation/devicetree/bindings/net/wireless/
Dbrcm,bcm4329-fmac.yaml69 this shall be flagged as active low.
/Linux-v5.15/drivers/regulator/
Dirq_helpers.c218 * If any of the flagged regulators is enabled we do in regulator_notifier_isr()
321 * @common_errs: Errors which can be flagged by this IRQ for all rdevs.
/Linux-v5.15/Documentation/userspace-api/media/v4l/
Dpixfmt-v4l2-mplane.rst35 compressed data flagged with ``V4L2_FMT_FLAG_COMPRESSED`` at
/Linux-v5.15/Documentation/filesystems/
Dautomount-support.rst59 If a vfsmount was already flagged for expiry, and if its usage count is 1
Dfiemap.rst97 block size of the file system. With the exception of extents flagged as
/Linux-v5.15/arch/arm/boot/dts/
Dintel-ixp42x-dlink-dsm-g600.dts47 /* CHECKME: flagged as active low in the old board file */
/Linux-v5.15/Documentation/block/
Dwriteback_cache_control.rst27 storage before the flagged bio starts. In addition the REQ_PREFLUSH flag can be
/Linux-v5.15/fs/
Dbad_inode.c221 * This tests whether an inode has been flagged as bad. The test uses
/Linux-v5.15/drivers/video/backlight/
Dbd6107.c147 * the line should be flagged as active low so this will assert in bd6107_probe()
/Linux-v5.15/net/netfilter/ipvs/
Dip_vs_app.c380 * Fix seq stuff if flagged as so. in app_tcp_pkt_out()
457 * Fix seq stuff if flagged as so. in app_tcp_pkt_in()
/Linux-v5.15/include/linux/
Ddlm.h116 * -EAGAIN if request would block and is flagged DLM_LKF_NOQUEUE
/Linux-v5.15/drivers/soundwire/
Dsysfs_slave_dpn.c23 * flagged on a mismatch.
/Linux-v5.15/Documentation/driver-api/dmaengine/
Dpxa_dma.rst121 When a transfer flagged as "DMA_PREP_INTERRUPT" is finished, the dma irq

123456