Home
last modified time | relevance | path

Searched full:flagged (Results 1 – 25 of 137) sorted by relevance

123456

/Linux-v5.10/Documentation/devicetree/bindings/i2c/
Di2c-gpio.yaml22 gpio used for the sda signal, this should be flagged as
30 gpio used for the scl signal, this should be flagged as
/Linux-v5.10/Documentation/devicetree/bindings/iio/light/
Dcm3605.txt14 to activate the ALS, should be flagged GPIO_ACTIVE_LOW)
/Linux-v5.10/drivers/net/ethernet/toshiba/
Dspider_net.h152 /* we rely on flagged descriptor interrupts */
324 /* We rely on flagged descriptor interrupts */
/Linux-v5.10/drivers/clk/davinci/
Dpll-da830.c27 * NB: Technically, the clocks flagged as SYSCLK_FIXED_DIV are "fixed ratio",
Dpll-da850.c43 * NB: Technically, the clocks flagged as SYSCLK_FIXED_DIV are "fixed ratio",
/Linux-v5.10/Documentation/networking/
Drxrpc.rst244 (#) When receiving data or messages for a call, MSG_EOR is flagged by recvmsg
315 for the next taker. MSG_TRUNC will never be flagged.
319 flagged.
616 pick up. MSG_MORE will be flagged by recvmsg() if there's more reply data
625 buffer instead, and MSG_EOR will be flagged to indicate the end of that
724 be delivered with MSG_MORE flagged.
752 MSG_EOR will be flagged to indicate that this is the final message for
/Linux-v5.10/fs/xfs/
Dxfs_health.c73 * However, we must be careful -- when FSCOUNTERS are flagged in xfs_health_unmount()
80 * there were filesystem problems, FSCOUNTERS was flagged, and in xfs_health_unmount()
/Linux-v5.10/Documentation/devicetree/bindings/soc/qcom/
Dqcom,smsm.txt44 Nodes can either be flagged as an interrupt-controller to denote a remote
/Linux-v5.10/include/uapi/linux/
Dbsg.h30 __u64 request_tag; /* [i] {SCSI: task tag (only if flagged)} */
Ddlm.h51 * -EAGAIN if request would block and is flagged DLM_LKF_NOQUEUE
/Linux-v5.10/Documentation/filesystems/
Dautomount-support.rst59 If a vfsmount was already flagged for expiry, and if its usage count is 1
Dfiemap.rst97 block size of the file system. With the exception of extents flagged as
/Linux-v5.10/Documentation/userspace-api/media/v4l/
Dpixfmt-v4l2-mplane.rst35 compressed data flagged with ``V4L2_FMT_FLAG_COMPRESSED`` at
/Linux-v5.10/Documentation/block/
Dwriteback_cache_control.rst27 storage before the flagged bio starts. In addition the REQ_PREFLUSH flag can be
/Linux-v5.10/fs/
Dbad_inode.c213 * This tests whether an inode has been flagged as bad. The test uses
/Linux-v5.10/drivers/video/backlight/
Dbd6107.c147 * the line should be flagged as active low so this will assert in bd6107_probe()
/Linux-v5.10/net/netfilter/ipvs/
Dip_vs_app.c380 * Fix seq stuff if flagged as so. in app_tcp_pkt_out()
457 * Fix seq stuff if flagged as so. in app_tcp_pkt_in()
/Linux-v5.10/include/linux/
Ddlm.h116 * -EAGAIN if request would block and is flagged DLM_LKF_NOQUEUE
/Linux-v5.10/drivers/soundwire/
Dsysfs_slave_dpn.c23 * flagged on a mismatch.
/Linux-v5.10/drivers/regulator/
Dfixed.c204 * The signal will be inverted by the GPIO core if flagged so in the in reg_fixed_voltage_probe()
/Linux-v5.10/Documentation/driver-api/dmaengine/
Dpxa_dma.rst121 When a transfer flagged as "DMA_PREP_INTERRUPT" is finished, the dma irq
/Linux-v5.10/arch/powerpc/oprofile/cell/
Dvma_map.c39 * map. For those addresses the flagged value will be sent on to in vma_map_lookup()
/Linux-v5.10/drivers/s390/crypto/
Dvfio_ap_ops.c424 * - If @data contains both an apid and apqi value, then @data will be flagged
427 * - If @data contains only an apid value, @data will be flagged as
430 * - If @data contains only an apqi value, @data will be flagged as
/Linux-v5.10/drivers/i2c/algos/
Di2c-algo-bit.c607 * We print a warning when we are not flagged to support atomic transfers but
618 dev_warn(&i2c_adap->dev, "not flagged for atomic transfers\n"); in bit_xfer_atomic()
/Linux-v5.10/drivers/firmware/efi/
Dcapsule-loader.c180 /* Return error while NO_FURTHER_WRITE_ACTION is flagged */ in efi_capsule_write()

123456