Searched full:externally (Results 1 – 25 of 201) sorted by relevance
123456789
/Linux-v5.10/Documentation/devicetree/bindings/regulator/ |
D | max8973-regulator.txt | 15 -maxim,externally-enable: boolean, externally control the regulator output 18 then externally enable control will be considered.
|
D | tps65090.txt | 18 If DCDCs are externally controlled then this property should be there. 20 If DCDCs are externally controlled and if it is from GPIO then GPIO 21 number should be provided. If it is externally controlled and no GPIO
|
/Linux-v5.10/Documentation/admin-guide/ |
D | tainted-kernels.rst | 43 a warning occurred (``W``), and an externally-built module was loaded (``O``). 63 * Externally-built ('out-of-tree') module was loaded (#12) 97 12 _/O 4096 externally-built ("out-of-tree") module was loaded 150 12) ``O`` if an externally-built ("out-of-tree") module has been loaded.
|
/Linux-v5.10/tools/testing/selftests/net/forwarding/ |
D | bridge_vlan_aware.sh | 117 # Test that externally learned FDB entries can roam, but not age out 138 log_test "Externally learned FDB entry - ageing & roaming"
|
/Linux-v5.10/Documentation/devicetree/bindings/power/reset/ |
D | mt6323-poweroff.txt | 3 The power controller which could be found on PMIC is responsible for externally
|
D | ltc2952-poweroff.txt | 3 This chip is used to externally trigger a system shut down. Once the trigger has
|
/Linux-v5.10/sound/aoa/soundbus/i2sbus/ |
D | control.c | 38 /* this is serialised externally */ 76 /* this is serialised externally */ in i2sbus_control_remove_dev()
|
/Linux-v5.10/Documentation/ABI/testing/ |
D | sysfs-driver-fsi-master-gpio | 9 where the FSI bus is driven externally (for example, by
|
D | sysfs-bus-iio-light-tsl2583 | 19 This property is the known externally illuminance (in lux).
|
/Linux-v5.10/Documentation/devicetree/bindings/i2c/ |
D | nxp,pca9541.txt | 9 The following required properties are defined externally:
|
D | i2c-mux-ltc4306.txt | 9 The following required properties are defined externally:
|
D | i2c-mux-pca954x.txt | 20 The following required properties are defined externally:
|
/Linux-v5.10/include/uapi/linux/ |
D | kdev_t.h | 8 from the kernel sources. These must be the externally visible ones.
|
/Linux-v5.10/drivers/gpu/drm/xen/ |
D | xen_drm_front_cfg.h | 30 /* set if dumb buffers are allocated externally on backend side */
|
/Linux-v5.10/include/linux/rtc/ |
D | m48t59.h | 55 /* ioaddr mapped externally */
|
/Linux-v5.10/arch/xtensa/include/asm/ |
D | dma.h | 20 * might be emulated externally.
|
/Linux-v5.10/arch/arm/mach-davinci/include/mach/ |
D | pm.h | 43 * clock is generated externally, the SLEEPCOUNT value can be very
|
/Linux-v5.10/include/sound/ |
D | madera-pdata.h | 27 * @dmic_ref: Indicates how the MICBIAS pins have been externally
|
/Linux-v5.10/tools/memory-model/ |
D | README | 11 by the externally provided "herd7" simulator, which exhaustively explores 14 In addition, the "klitmus7" tool (also externally provided) may be used
|
/Linux-v5.10/Documentation/devicetree/bindings/bus/ |
D | simple-pm-bus.yaml | 19 on-SoC or externally) to function.
|
/Linux-v5.10/Documentation/devicetree/bindings/power/supply/ |
D | ti,bq24735.txt | 27 - ti,external-control : Indicates that the charger is configured externally
|
/Linux-v5.10/drivers/media/dvb-frontends/ |
D | dib0070.h | 23 /* tuner pins controlled externally */
|
/Linux-v5.10/Documentation/devicetree/bindings/iio/imu/ |
D | bosch,bmi160.yaml | 13 Inertial Measurement Unit with Accelerometer, Gyroscope and externally
|
/Linux-v5.10/Documentation/devicetree/bindings/interconnect/ |
D | fsl,imx8m-noc.yaml | 20 The buses are based on externally licensed IPs such as ARM NIC-301 and
|
/Linux-v5.10/arch/mips/include/asm/mach-au1x00/ |
D | gpio-au1300.h | 19 * The only implementation so far is in the Au1300, which has 75 externally
|
123456789