Searched full:expressed (Results 1 – 25 of 325) sorted by relevance
12345678910>>...13
| /Linux-v6.1/Documentation/userspace-api/media/v4l/ |
| D | selection-api-configuration.rst | 33 corner at position ``(0,0)``. The rectangle's coordinates are expressed
51 coordinates are expressed in pixels. The rectangle's top/left corner
57 coordinates are also expressed in the same coordinate system as the
91 All coordinates are expressed in pixels. The top/left corner is always
97 by the ``V4L2_SEL_TGT_CROP``. Its coordinates are expressed in the
109 target. The rectangle's coordinates are expressed in pixels. The
|
| /Linux-v6.1/Documentation/ABI/testing/ |
| D | sysfs-driver-hid-picolcd | 24 Reading/Writing: It is expressed in ms and permitted range is
33 Reading: returns list of available refresh rates (expressed in Hz),
36 Writing: accepts new refresh rate expressed in integer Hz
|
| D | sysfs-platform-dell-laptop | 55 The timeouts are expressed in seconds, minutes, hours and
61 is assumed to be expressed in seconds.
68 expressed in a different unit than the one used when the timeout
|
| D | sysfs-bus-iio-health-afe440x | 20 The values are expressed in 24-bit twos complement.
30 stages. The values are expressed in 5-bit sign-magnitude.
|
| D | sysfs-block-bcache | 56 to the sequential cutoff). Expressed as bytes in human
85 after this delay, expressed as an integer number of seconds.
|
| /Linux-v6.1/drivers/gpu/drm/amd/display/include/ |
| D | i2caux_interface.h | 54 /* expressed in milliseconds
65 /* expressed in milliseconds
|
| /Linux-v6.1/fs/ocfs2/ |
| D | ocfs2_lockid.h | 16 * name[7-22] --> block number, expressed in hex as 16 chars
17 * name[23-30] --> i_generation, expressed in hex 8 chars
|
| /Linux-v6.1/drivers/staging/media/atomisp/pci/isp/kernels/xnr/xnr_3.0/ |
| D | ia_css_xnr3_param.h | 39 /* XNR3 alpha (1/sigma) parameters on the ISP, expressed as a base (0) value
50 /* XNR3 coring parameters on the ISP, expressed as a base (0) value
|
| /Linux-v6.1/Documentation/hwmon/ |
| D | lm93.rst | 176 #PROCHOT 1 & 2, and #VRDHOT 1 & 2. The bindings are expressed as a bitmask
193 temperature offsets. The base temperature is expressed in degrees C in the
194 sysfs files temp<n>_auto_base. The offsets are expressed in cumulative
269 This limit is expressed in degrees C in the sysfs files temp<n>_auto_boost.
272 the boost function is disabled. This temperature is also expressed in degrees
|
| /Linux-v6.1/drivers/mfd/ |
| D | atmel-smc.c | 83 * @ncycles: value (expressed in MCK clk cycles) to assign to this Txx
125 * @ncycles: value (expressed in MCK clk cycles) to assign to this xx_SETUP
164 * @ncycles: value (expressed in MCK clk cycles) to assign to this xx_PULSE
203 * @ncycles: value (expressed in MCK clk cycles) to assign to this xx_CYCLE
|
| /Linux-v6.1/Documentation/devicetree/bindings/regulator/ |
| D | pwm-regulator.yaml | 65 pwm-dutycycle-range contains values expressed in
74 Duty cycle values are expressed in pwm-dutycycle-unit.
|
| /Linux-v6.1/drivers/usb/gadget/function/ |
| D | u_audio.h | 17 * sound/usb/endpoint.c. Value is expressed in per-mil deviation.
23 * Value is expressed in per-mil deviation.
|
| /Linux-v6.1/Documentation/devicetree/bindings/opp/ |
| D | opp-v2-base.yaml | 48 Frequency in Hz, expressed as a 64-bit big-endian integer. This is a
128 Peak bandwidth in kilobytes per second, expressed as an array of
137 Average bandwidth in kilobytes per second, expressed as an array
|
| /Linux-v6.1/Documentation/devicetree/bindings/sound/ |
| D | cirrus,cs35l41.yaml | 52 Boost inductor value, expressed in nH. Valid
62 nearest integer and expressed in uF.
|
| /Linux-v6.1/Documentation/devicetree/bindings/display/panel/ |
| D | panel-common.yaml | 27 property is expressed in millimeters and rounded to the closest unit.
32 property is expressed in millimeters and rounded to the closest unit.
|
| /Linux-v6.1/Documentation/devicetree/bindings/rtc/ |
| D | nxp,pcf8523.txt | 9 expressed in femto Farad (fF). Valid values are 7000 and 12500.
|
| /Linux-v6.1/drivers/xen/xen-pciback/ |
| D | Makefile | 3 # N.B. The below cannot be expressed with a single line using
|
| /Linux-v6.1/Documentation/admin-guide/device-mapper/ |
| D | switch.rst | 102 Expressed in hexadecimal (WITHOUT any prefix like 0x).
106 Expressed in hexadecimal (WITHOUT any prefix like 0x).
|
| /Linux-v6.1/arch/parisc/math-emu/ |
| D | README | 8 Required Disclaimer: Hewlett-Packard makes no implied or expressed
|
| /Linux-v6.1/include/linux/ |
| D | pwm.h | 201 * This functions converts the absolute duty cycle stored in @state (expressed
204 * For example if you want to get the duty_cycle expressed in percent, call:
223 * @scale: scale in which @duty_cycle is expressed
225 * This functions converts a relative into an absolute duty cycle (expressed
|
| /Linux-v6.1/drivers/net/ |
| D | LICENSE.SRC | 10 and all warranties, expressed or implied, concerning the enclosed software.
|
| /Linux-v6.1/Documentation/power/ |
| D | energy-model.rst | 23 The power values might be expressed in micro-Watts or in an 'abstract scale'.
28 powercap power values expressed in an 'abstract scale' might cause issues.
35 Important thing to keep in mind is that when the power values are expressed in
|
| /Linux-v6.1/include/linux/platform_data/ |
| D | i2c-davinci.h | 15 /* All frequencies are expressed in kHz */
|
| /Linux-v6.1/Documentation/devicetree/bindings/leds/ |
| D | leds-powernv.txt | 8 Each location code of FRU/Enclosure must be expressed in the
|
| /Linux-v6.1/drivers/media/i2c/ |
| D | aptina-pll.c | 102 * limits. (5) can be expressed as in aptina_pll_calculate()
112 * Similarly, (4) can be expressed as in aptina_pll_calculate()
|
12345678910>>...13
