Searched full:exclusively (Results 1 – 25 of 190) sorted by relevance
12345678
| /Linux-v5.10/fs/nfs/ |
| D | io.c | 17 /* Call with exclusively locked inode->i_rwsem */
97 /* Call with exclusively locked inode->i_rwsem */
|
| /Linux-v5.10/Documentation/devicetree/bindings/interrupt-controller/ |
| D | ti,pruss-intc.yaml | 18 interrupts (0, 1) are fed exclusively to the internal PRU cores, with the
25 (host_intr0 through host_intr7) are connected exclusively to the Arm interrupt
|
| /Linux-v5.10/fs/ceph/ |
| D | io.c | 21 /* Call with exclusively locked inode->i_rwsem */
106 /* Call with exclusively locked inode->i_rwsem */
|
| /Linux-v5.10/Documentation/core-api/ |
| D | assoc_array.rst | 199 The caller should lock exclusively against other modifiers of the array.
219 The caller should lock exclusively against other modifiers of the array.
235 The caller should lock exclusively against other modifiers of the array.
249 The caller should lock exclusively against other modifiers and accessors
277 lock exclusively against other modifiers of the array.
|
| /Linux-v5.10/arch/arm/include/asm/ |
| D | spinlock.h | 136 * just write zero since the lock is exclusively held.
197 * - Exclusively load the lock value.
|
| /Linux-v5.10/drivers/hwtracing/stm/ |
| D | Kconfig | 21 exclusively until the MIPI SyS-T support was added. Use this
|
| /Linux-v5.10/drivers/staging/qlge/ |
| D | TODO | 4 ql_build_rx_skb(). That function is now used exclusively to handle packets
|
| /Linux-v5.10/Documentation/devicetree/bindings/soc/ti/ |
| D | sci-pm-domain.txt | 27 exclusively controlled by
|
| /Linux-v5.10/arch/mips/include/asm/sibyte/ |
| D | sb1250_defs.h | 120 /* Bit mask for revisions of chip exclusively before the named revision. */
124 /* Bit mask for revisions of chip exclusively after the named revision. */
|
| /Linux-v5.10/arch/arc/include/asm/ |
| D | spinlock.h | 84 * zero means writer holds the lock exclusively, deny Reader. in arch_read_lock()
307 * zero means writer holds the lock exclusively, deny Reader. in arch_read_trylock()
|
| /Linux-v5.10/Documentation/arm64/ |
| D | perf.rst | 60 exclusively rely on the PMU's hardware exception filtering - therefore we
|
| /Linux-v5.10/Documentation/devicetree/bindings/mips/lantiq/ |
| D | rcu.txt | 8 uses one or multiple register exclusively, but for some registers some
|
| /Linux-v5.10/arch/powerpc/platforms/85xx/ |
| D | p1023_rdb.c | 63 * Note: Accessing exclusively i2c devices. in mpc85xx_rdb_setup_arch()
|
| /Linux-v5.10/arch/parisc/include/asm/ |
| D | spinlock.h | 76 * zero means writer holds the lock exclusively, deny Reader. in arch_read_trylock()
|
| /Linux-v5.10/arch/x86/platform/efi/ |
| D | efi_32.c | 64 * handler exclusively and to duplicate a memory mapping in low memory space,
|
| /Linux-v5.10/Documentation/userspace-api/media/v4l/ |
| D | format.rst | 38 assigns a logical stream (video data, VBI data etc.) exclusively to one
|
| /Linux-v5.10/include/uapi/linux/ |
| D | ppdev.h | 62 /* Register device exclusively (must be before PPCLAIM). */
|
| D | uhid.h | 149 /* Obsolete! Kernel uses UHID_OUTPUT exclusively now. */
|
| D | dccp.h | 205 /* ^-- Up to here reserved exclusively for qpolicy parameters */
|
| /Linux-v5.10/include/linux/ |
| D | ww_mutex.h | 198 * Lock the w/w mutex exclusively for this task.
229 * Lock the w/w mutex exclusively for this task.
|
| /Linux-v5.10/arch/mips/ |
| D | Kconfig.debug | 73 Instead, the built-in command line will be used exclusively.
|
| /Linux-v5.10/arch/arm/mach-s3c/ |
| D | gpio-cfg-helpers.h | 18 /* As a note, all gpio configuration functions are entered exclusively, either
|
| /Linux-v5.10/drivers/spi/ |
| D | spi-dw-pci.c | 186 * exclusively used by SCU to communicate with MSIC.
|
| /Linux-v5.10/drivers/clocksource/ |
| D | timer-digicolor.c | 160 * don't map exclusively in digicolor_timer_init()
|
| /Linux-v5.10/Documentation/networking/ |
| D | statistics.rst | 149 :c:type:`struct rtnl_link_stats64 <rtnl_link_stats64>` exclusively
|
12345678
