Searched full:ees (Results 1 – 22 of 22) sorted by relevance
| /Linux-v6.6/arch/arm64/boot/dts/freescale/ |
| D | imx8mm-emtop-baseboard.dts | 12 compatible = "ees,imx8mm-emtop-baseboard", "ees,imx8mm-emtop-som",
|
| D | imx8mm-emtop-som.dtsi | 16 compatible = "ees,imx8mm-emtop-som", "fsl,imx8mm";
|
| /Linux-v6.6/Documentation/devicetree/bindings/dma/ |
| D | qcom,bam-dma.yaml | 68 qcom,num-ees:
|
| /Linux-v6.6/drivers/net/ipa/ |
| D | ipa_main.c | 44 * controlled by) other "execution environments" (EEs), such as a modem.
66 * endpoints is used to carry traffic between two EEs. Specifically, the main
|
| D | gsi.c | 50 * (EEs), which are independent operating environments that use the IPA for
56 * describe transfers to or from other EEs through the IPA. A transfer
334 /* General GSI interrupts are reported to all EEs; if they occur in gsi_irq_enable()
|
| /Linux-v6.6/arch/arm64/boot/dts/qcom/ |
| D | msm8994.dtsi | 523 qcom,num-ees = <4>;
658 qcom,num-ees = <4>;
|
| D | msm8953.dtsi | 1288 qcom,num-ees = <4>;
1392 qcom,num-ees = <4>;
|
| D | sdm630.dtsi | 1666 qcom,num-ees = <4>;
1788 qcom,num-ees = <4>;
|
| D | msm8998.dtsi | 2235 qcom,num-ees = <4>;
2490 qcom,num-ees = <4>;
|
| D | msm8916.dtsi | 1897 qcom,num-ees = <1>;
|
| D | msm8996.dtsi | 3432 qcom,num-ees = <2>;
|
| D | sm8150.dtsi | 2105 qcom,num-ees = <2>;
|
| D | sdm845.dtsi | 5238 qcom,num-ees = <2>;
|
| D | sm8250.dtsi | 2251 qcom,num-ees = <2>;
|
| /Linux-v6.6/drivers/block/drbd/ |
| D | drbd_main.c | 1515 * that we do not reuse our own buffer pages (EEs) to early, therefore
2173 drbd_err(device, "%d EEs in active list found!\n", rr); in drbd_release_all_peer_reqs()
2177 drbd_err(device, "%d EEs in sync list found!\n", rr); in drbd_release_all_peer_reqs()
2181 drbd_err(device, "%d EEs in read list found!\n", rr); in drbd_release_all_peer_reqs()
2185 drbd_err(device, "%d EEs in done list found!\n", rr); in drbd_release_all_peer_reqs()
2189 drbd_err(device, "%d EEs in net list found!\n", rr); in drbd_release_all_peer_reqs()
|
| D | drbd_receiver.c | 198 /* The EEs are always appended to the end of the list. Since in reclaim_finished_net_peer_reqs()
|
| /Linux-v6.6/drivers/dma/qcom/ |
| D | bam_dma.c | 1289 ret = of_property_read_u32(pdev->dev.of_node, "qcom,num-ees", in bam_dma_probe()
1292 dev_err(bdev->dev, "num-ees unspecified in dt\n"); in bam_dma_probe()
|
| /Linux-v6.6/Documentation/accel/qaic/ |
| D | aic100.rst | 189 | Channel name | IDs | EEs | Purpose |
|
| /Linux-v6.6/Documentation/devicetree/bindings/arm/ |
| D | fsl.yaml | 931 - const: ees,imx8mm-emtop-baseboard # i.MX8MM Emtop SoM on i.MX8M Mini Baseboard V1
932 - const: ees,imx8mm-emtop-som # i.MX8MM Emtop SOM-IMX8MMLPD4 module
|
| /Linux-v6.6/Documentation/devicetree/bindings/ |
| D | vendor-prefixes.yaml | 393 "^ees,.*":
|
| /Linux-v6.6/drivers/spmi/ |
| D | spmi-pmic-arb.c | 1054 * In order to allow multiple EEs to write to a single PPID in arbiter in pmic_arb_read_apid_map_v5()
|
| /Linux-v6.6/arch/arm/boot/dts/qcom/ |
| D | qcom-msm8974.dtsi | 1481 qcom,num-ees = <1>;
|
