| /Linux-v5.15/Documentation/devicetree/bindings/display/ |
| D | brcm,bcm2835-dsi0.yaml | 21 - brcm,bcm2711-dsi1
23 - brcm,bcm2835-dsi1
65 dsi1: dsi@7e700000 {
66 compatible = "brcm,bcm2835-dsi1";
|
| D | ste,mcde.yaml | 146 dsi1: dsi@a0352000 {
|
| D | mipi-dsi-bus.txt | 223 dsi1-host {
|
| /Linux-v5.15/Documentation/devicetree/bindings/clock/ |
| D | brcm,bcm2835-cprman.txt | 28 - DSI1 byte clock
29 - DSI1 DDR2 clock
30 - DSI1 DDR clock
|
| /Linux-v5.15/Documentation/devicetree/bindings/display/msm/ |
| D | mdp5.txt | 64 Port 1 -> MDP_INTF1 (DSI1)
69 Port 0 -> MDP_INTF1 (DSI1)
72 Port 0 -> MDP_INTF1 (DSI1)
|
| D | mdp4.txt | 34 Port 1 -> DSI1 Cmd/Video
|
| D | dpu-sdm845.yaml | 114 description: DPU_INTF1 (DSI1)
|
| D | dpu-sc7180.yaml | 125 description: DPU_INTF1 (DSI1)
|
| /Linux-v5.15/arch/arm/boot/dts/ |
| D | bcm283x.dtsi | 97 <&dsi1 0>, <&dsi1 1>, <&dsi1 2>;
437 dsi1: dsi@7e700000 { label
438 compatible = "brcm,bcm2835-dsi1";
|
| D | bcm2835-rpi.dtsi | 79 &dsi1 {
|
| /Linux-v5.15/drivers/gpu/drm/bridge/ |
| D | lontium-lt9611uxc.c | 45 struct mipi_dsi_device *dsi1; member
359 if (lt9611uxc->dsi1) { in lt9611uxc_bridge_detach()
360 mipi_dsi_detach(lt9611uxc->dsi1); in lt9611uxc_bridge_detach()
361 mipi_dsi_device_unregister(lt9611uxc->dsi1); in lt9611uxc_bridge_detach()
387 lt9611uxc->dsi1 = lt9611uxc_attach_dsi(lt9611uxc, lt9611uxc->dsi1_node); in lt9611uxc_bridge_attach()
388 if (IS_ERR(lt9611uxc->dsi1)) { in lt9611uxc_bridge_attach()
389 ret = PTR_ERR(lt9611uxc->dsi1); in lt9611uxc_bridge_attach()
|
| D | lontium-lt9611.c | 41 struct mipi_dsi_device *dsi1; member
796 if (lt9611->dsi1) { in lt9611_bridge_detach()
797 mipi_dsi_detach(lt9611->dsi1); in lt9611_bridge_detach()
798 mipi_dsi_device_unregister(lt9611->dsi1); in lt9611_bridge_detach()
848 lt9611->dsi1 = lt9611_attach_dsi(lt9611, lt9611->dsi1_node); in lt9611_bridge_attach()
849 if (IS_ERR(lt9611->dsi1)) { in lt9611_bridge_attach()
850 ret = PTR_ERR(lt9611->dsi1); in lt9611_bridge_attach()
874 else if (lt9611_mode->intfs > 1 && !lt9611->dsi1) in lt9611_bridge_mode_valid()
|
| /Linux-v5.15/drivers/gpu/drm/panel/ |
| D | panel-truly-nt35597.c | 535 struct device_node *dsi1; in truly_nt35597_probe() local
566 dsi1 = of_graph_get_remote_node(dsi->dev.of_node, 1, -1); in truly_nt35597_probe()
567 if (!dsi1) { in truly_nt35597_probe()
572 dsi1_host = of_find_mipi_dsi_host_by_node(dsi1); in truly_nt35597_probe()
573 of_node_put(dsi1); in truly_nt35597_probe()
|
| /Linux-v5.15/arch/arm64/boot/dts/qcom/ |
| D | sdm660.dtsi | 156 dsi1: dsi@c996000 { label
161 /* DSI1 shares the OPP table with DSI0 */
|
| D | sdm845-mtp.dts | 410 &dsi1 {
416 /* DSI1 is slave, so use DSI0 clocks */
|
| /Linux-v5.15/drivers/gpu/drm/vc4/ |
| D | vc4_dsi.c | 7 * DOC: VC4 DSI0/DSI1 module
9 * BCM2835 contains two DSI modules, DSI0 and DSI1. DSI0 is a
10 * single-lane DSI controller, while DSI1 is a more modern 4-lane DSI
13 * Most Raspberry Pi boards expose DSI1 as their "DISPLAY" connector,
14 * while the compute module brings both DSI0 and DSI1 out.
16 * This driver has been tested for DSI1 video-mode display only
497 /* Whether we're on bcm2835's DSI0 or DSI1. */
1350 { .compatible = "brcm,bcm2711-dsi1", &bcm2711_dsi1_variant },
1352 { .compatible = "brcm,bcm2835-dsi1", &bcm2835_dsi1_variant },
1535 /* DSI1 on BCM2835/6/7 has a broken AXI slave that doesn't respond to in vc4_dsi_bind()
|
| /Linux-v5.15/Documentation/devicetree/bindings/display/panel/ |
| D | raspberrypi,7inch-touchscreen.yaml | 41 dsi1: dsi {
|
| D | sharp,lq101r1sx01.yaml | 76 dsi1: dsi@fd922a00 {
|
| /Linux-v5.15/Documentation/devicetree/bindings/interrupt-controller/ |
| D | brcm,bcm2835-armctrl-ic.txt | 91 12: DSI1
|
| /Linux-v5.15/Documentation/gpu/ |
| D | vc4.rst | 43 :doc: VC4 DSI0/DSI1 module
|
| /Linux-v5.15/include/drm/ |
| D | i915_mei_hdcp_interface.h | 61 * @MEI_TRANSCODER_DSI1: Index for DSI1 Transcoder
|
| /Linux-v5.15/drivers/gpu/drm/msm/disp/mdp4/ |
| D | mdp4_kms.c | 265 /* only DSI1 supported for now */ in mdp4_modeset_init_intf()
362 * DSI path: RGB1 -> DMA_P -> DSI1 -> DSI Panel in modeset_init()
|
| /Linux-v5.15/drivers/soc/bcm/ |
| D | raspberrypi-power.c | 214 rpi_init_power_domain(rpi_domains, RPI_POWER_DOMAIN_DSI1, "DSI1"); in rpi_power_probe()
|
| /Linux-v5.15/drivers/video/fbdev/omap2/omapfb/dss/ |
| D | dpi.c | 84 return dss_pll_find("dsi1"); in dpi_get_pll()
94 return dss_pll_find("dsi1"); in dpi_get_pll()
|
| /Linux-v5.15/drivers/gpu/drm/msm/disp/dpu1/ |
| D | dpu_kms.c | 482 * - Single DSI host (dsi0 or dsi1) in _dpu_kms_initialize_dsi()
484 * - Bonded DSI0 and DSI1 hosts in _dpu_kms_initialize_dsi()
486 * TODO: Support swapping DSI0 and DSI1 in the bonded setup. in _dpu_kms_initialize_dsi()
|
