Searched full:determined (Results 1 – 25 of 889) sorted by relevance
12345678910>>...36
| /Linux-v5.4/drivers/firmware/efi/ |
| D | cper-arm.c | 40 "Generic error (type cannot be determined)",
41 "Generic read (type of instruction or data request cannot be determined)",
42 "Generic write (type of instruction of data request cannot be determined)",
50 "Generic error (type cannot be determined)",
51 "Generic read (type of instruction or data request cannot be determined)",
52 "Generic write (type of instruction of data request cannot be determined)",
64 "Generic error (type cannot be determined)",
65 "Generic read (type of instruction or data request cannot be determined)",
66 "Generic write (type of instruction of data request cannot be determined)",
|
| /Linux-v5.4/Documentation/filesystems/nfs/ |
| D | nfsroot.txt | 59 The default address is determined by the `ip' parameter
104 Default: Determined using autoconfiguration.
117 Default: Determined using autoconfiguration.
122 Default: Determined using autoconfiguration.
128 Default: Determined using autoconfiguration.
143 Otherwise the device is determined using
176 Default: None if not using autoconfiguration; determined
186 Default: None if not using autoconfiguration; determined
|
| /Linux-v5.4/Documentation/devicetree/bindings/sound/ |
| D | cs42l56.txt | 19 register, not the actual frequency. The frequency is determined by the following.
40 0 = Adapt to Volume Mode. Voltage level determined by the sum of the relevant volume settings.
43 3 = Adapted to Signal; Voltage level is dynamically determined by the output signal.
|
| /Linux-v5.4/Documentation/ABI/testing/ |
| D | dell-smbios-wmi | 22 2) After you've determined the minimum size of the calling
27 determined above and allocated.
|
| /Linux-v5.4/Documentation/x86/ |
| D | amd-memory-encryption.rst | 42 Support for SME and SEV can be determined through the CPUID instruction. The
70 Linux relies on BIOS to set this bit if BIOS has determined that the reduction
79 The CPU supports SME (determined through CPUID instruction).
|
| /Linux-v5.4/Documentation/media/uapi/v4l/ |
| D | vidioc-g-fbuf.rst | 49 output device) and can be determined with the
67 implemented on the TV card all other parameters are determined by the
302 - Use chroma-keying. The chroma-key color is determined by the
321 determined by the ``global_alpha`` field of struct
335 determined by the ``chromakey`` field of struct
|
| D | tuner.rst | 42 determined by the current video input. Drivers must support both ioctls
75 is more than one at all. The modulator is solely determined by the
|
| /Linux-v5.4/arch/arm/include/asm/ |
| D | fncpy.h | 39 * The size of the function to be copied can't be determined from C:
40 * this must be determined by other means, such as adding assmbler directives
|
| /Linux-v5.4/arch/mips/include/asm/sn/ |
| D | intr.h | 70 * INT_PEND0 bits determined by hardware:
91 * INT_PEND0 again, bits determined by hardware / hardcoded:
|
| /Linux-v5.4/drivers/net/can/mscan/ |
| D | mpc5xxx_can.c | 140 * gets determined based on the 'sys' clock, if that fails the in mpc512x_can_get_clock()
243 /* return the determined clock source rate */ in mpc512x_can_get_clock()
248 /* clock source rate could not get determined */ in mpc512x_can_get_clock()
253 /* clock source rate could not get determined */ in mpc512x_can_get_clock()
258 /* clock source rate could not get determined */ in mpc512x_can_get_clock()
|
| /Linux-v5.4/tools/power/acpi/ |
| D | Makefile.config | 11 #$(info Determined 'srctree' to be $(srctree))
20 #$(info Determined 'OUTPUT' to be $(OUTPUT))
|
| /Linux-v5.4/Documentation/power/ |
| D | swsusp-and-swap-files.rst | 16 In principle the location of a swap file's header may be determined with the
43 and <swap_file_offset> is the offset of the swap header determined by the
|
| /Linux-v5.4/arch/mips/include/asm/octeon/ |
| D | cvmx-wqe.h | 145 * Set if the hardware determined that the packet is a
150 * St if the hardware determined that the packet is a
298 * set if the hardware determined that the packet is
303 * set if the hardware determined that the packet is
308 * set if the hardware determined that the packet is a
313 * set if the hardware determined that the packet is a
|
| /Linux-v5.4/drivers/staging/vc04_services/interface/vchi/ |
| D | vchi_cfg.h | 13 /* Really determined by the message driver, and should be available from a run-time call. */
24 /* Really determined by the message driver, and should be available from a run-time call. */
162 * the peer asks for more than this, VCHI will fail and assert. The number is determined
|
| /Linux-v5.4/Documentation/ABI/obsolete/ |
| D | sysfs-driver-hid-roccat-savu | 11 Which profile to write is determined by the profile number
35 Which profile to write is determined by the profile number
|
| D | sysfs-driver-hid-roccat-konepure | 49 Which profile to write is determined by the profile number
65 Which profile to write is determined by the profile number
|
| /Linux-v5.4/drivers/clk/imgtec/ |
| D | Kconfig | 9 fixed rate clocks whose rate is determined by reading a platform
|
| /Linux-v5.4/Documentation/devicetree/bindings/power/reset/ |
| D | msm-poweroff.txt | 5 between poweroff and restart is determined by unique power manager IC
|
| /Linux-v5.4/Documentation/devicetree/bindings/arm/msm/ |
| D | ssbi.txt | 14 "pmic-arbiter". The type chosen is determined by the attached
|
| /Linux-v5.4/Documentation/driver-api/ |
| D | device_link.rst | 148 probing) or never. Consequently it cannot be determined whether to defer
224 Ordering of these devices during suspend/resume is determined by the
225 dpm_list. During shutdown it is determined by the devices_kset. With
273 * The initial state of a device link is automatically determined by
|
| /Linux-v5.4/Documentation/devicetree/bindings/auxdisplay/ |
| D | img-ascii-lcd.txt | 16 The layout of the registers & properties of the display are determined
|
| /Linux-v5.4/Documentation/devicetree/bindings/rtc/ |
| D | stmp3xxx-rtc.txt | 11 - stmp,crystal-freq: override crystal frequency as determined from fuse bits.
|
| /Linux-v5.4/Documentation/devicetree/bindings/watchdog/ |
| D | gpio-wdt.txt | 12 the opposite level disables the WDT. Active level is determined
|
| D | arm,sp805.txt | 23 default timeout is determined by the driver
|
| /Linux-v5.4/Documentation/devicetree/bindings/net/ |
| D | brcm,amac.txt | 19 The MAC address will be determined using the optional properties
|
12345678910>>...36
