Searched full:depending (Results 1 – 25 of 2152) sorted by relevance
12345678910>>...87
| /Linux-v5.15/Documentation/hwmon/ |
| D | gsc-hwmon.rst | 21 The voltage inputs are scaled either internally or by the driver depending
33 either internally or by the driver depending on the GSC version and firmware.
44 PWM value will be scalled depending on 6 temperature boundaries.
|
| D | adm1275.rst | 103 inX_label "vin1" or "vout1" depending on chip variant and
118 curr1_lcrit Critical minimum current. Depending on the chip
122 curr1_crit Critical maximum current. Depending on the chip
|
| D | nct6775.rst | 97 PCH, and SMBUS. Depending on the chip type, 2 to 6 of the temperature sources
108 either 1 degC or 0.5 degC, depending on the temperature source and
111 value. Alarms are only supported for temp1 to temp6, depending on the chip type.
245 There are up to seven data points depending on the chip type. Subsequent data
|
| /Linux-v5.15/drivers/mtd/spi-nor/ |
| D | Kconfig | 17 Many flash memories support erasing small (4096 B) sectors. Depending
37 Depending on the flash chip this either clears the block protection
54 If the software write protection will be disabled depending on
|
| /Linux-v5.15/include/linux/ |
| D | dma-buf-map.h | 16 * Depending on the location of the buffer, users may have to access it with
94 * the buffer memory. Depending on the location of the memory, the provided
186 * Depending on the state of struct dma_buf_map.is_iomem, tests if the
203 * Depending on the state of struct dma_buf_map.is_iomem, tests if the
239 * memory. Depending on the buffer's location, the helper picks the correct
255 * Increments the address stored in a dma-buf mapping. Depending on the
|
| D | pm_runtime.h | 293 * Invoke the "idle check" callback of @dev and, depending on its return value,
294 * set up autosuspend of @dev or suspend it (depending on whether or not
315 * Set up autosuspend of @dev or suspend it (depending on whether or not
447 * equal to 0, invoke the "idle check" callback of @dev and, depending on its
448 * return value, set up autosuspend of @dev or suspend it (depending on whether
481 * equal to 0, set up autosuspend of @dev or suspend it synchronously (depending
|
| /Linux-v5.15/Documentation/driver-api/thermal/ |
| D | nouveau_thermal.rst | 41 Some of these thresholds may not be used by Nouveau depending
79 * 2; The fan is driven automatically depending on the temperature.
87 depending on your hardware.
|
| /Linux-v5.15/include/uapi/linux/ |
| D | falloc.h | 22 * smaller depending on the filesystem and/or the configuration of the
53 * boundaries, but this boundary may be larger or smaller depending on
71 * depending on the filesystem and/or the configuration of the filesystem
|
| /Linux-v5.15/Documentation/PCI/endpoint/function/binding/ |
| D | pci-test.rst | 22 msi_interrupts Should be 1 to 32 depending on the number of MSI interrupts
24 msix_interrupts Should be 1 to 2048 depending on the number of MSI-X
|
| /Linux-v5.15/drivers/net/ethernet/neterion/ |
| D | Kconfig | 26 Neterion. So, the adapters might be labeled as either one, depending
42 labeled as either one, depending on its age.
|
| /Linux-v5.15/Documentation/ABI/testing/ |
| D | sysfs-bus-iio-adc-hi8435 | 18 Depending on in_voltageY_sensing_mode the low voltage threshold
37 Depending on in_voltageY_sensing_mode the high voltage threshold
|
| /Linux-v5.15/Documentation/sound/soc/ |
| D | clocking.rst | 18 their speed can be altered by software (depending on the system use and to save
39 it is best to configure BCLK to the lowest possible speed (depending on your
|
| D | pops-clicks.rst | 12 depending on the audio usage and this can subsequently cause a small pop or
39 playback in that components are powered in a sequence depending upon stream
|
| D | dai.rst | 30 usually varies depending on the sample rate and the master system clock
53 receive the audio data. Bit clock usually varies depending on sample rate
|
| D | jack.rst | 41 These represent a DAPM pin to update depending on some of the status
69 These are all hooked together by the machine driver depending on the
|
| /Linux-v5.15/Documentation/devicetree/bindings/interconnect/ |
| D | interconnect.txt | 15 depending on the use case. Interconnect providers can also be interconnect
42 multiple paths from different providers depending on use case and the
|
| /Linux-v5.15/security/selinux/ss/ |
| D | conditional.h | 42 * depending on the current value of the conditional expression. This
53 * two lists of rules to enable/disable depending on the value of the
|
| /Linux-v5.15/arch/arm/include/asm/ |
| D | kasan_def.h | 68 * The KASAN_SHADOW_OFFSET is provided in a Kconfig option depending
71 * the shadow offset depending on this.
|
| /Linux-v5.15/drivers/staging/media/av7110/ |
| D | Kconfig | 31 or /lib/firmware (depending on configuration of firmware hotplug).
92 or /lib/firmware (depending on configuration of firmware hotplug).
|
| /Linux-v5.15/Documentation/netlabel/ |
| D | lsm_interface.rst | 26 low-level packet label depending on the NetLabel build time and run time
43 Depending on the exact configuration, translation between the network packet
|
| /Linux-v5.15/Documentation/misc-devices/ |
| D | apds990x.rst | 26 might vary quite much depending the spectrum of the light source.
68 to saturate much before that. Real max value varies depending
|
| /Linux-v5.15/Documentation/admin-guide/media/ |
| D | saa7134.rst | 52 Depending on the card you might have to pass ``card=<nr>`` as insmod option.
82 default might not work for you depending on which version you have.
|
| /Linux-v5.15/Documentation/devicetree/bindings/regulator/ |
| D | palmas-pmic.txt | 35 For ti,palmas-pmic - smps12, smps123, smps3 depending on OTP,
36 smps45, smps457, smps7 depending on variant, smps6, smps[8-9],
|
| /Linux-v5.15/Documentation/sound/hd-audio/ |
| D | realtek-pc-beep.rst | 42 When zero, mix 1Ah (possibly with amplification, depending on L and R bits)
47 When one, mix 1Ah (possibly with amplification, depending on L and R bits)
97 generator and external PCBEEP pin, depending on if the beep generator is
|
| /Linux-v5.15/arch/arm/mach-s3c/ |
| D | map-s3c64xx.h | 19 * These may be used by SROM, NAND or CF depending on settings
57 (depending on SoC POP version) */
|
12345678910>>...87
