Searched full:denotes (Results 1 – 25 of 155) sorted by relevance
1234567
/Linux-v6.6/include/linux/ |
D | crc32.h | 25 * requiring only crc1, crc2, and len2. Note: If seq_full denotes 52 * requiring only crc1, crc2, and len2. Note: If seq_full denotes
|
/Linux-v6.6/Documentation/devicetree/bindings/net/ |
D | fsl-tsec-phy.txt | 70 - rx-stash-len : Denotes the number of bytes of a received buffer to stash 72 - rx-stash-idx : Denotes the index of the first byte from the received
|
D | ti,dp83867.yaml | 103 This denotes the fact that the board has RX_DV/RX_CTRL pin strapped in 111 This denotes which SGMII configuration is used (4 or 6-wire modes).
|
/Linux-v6.6/Documentation/userspace-api/media/v4l/ |
D | vidioc-enum-frameintervals.rst | 96 In the structs below, *IN* denotes a value that has to be filled in by 97 the application, *OUT* denotes values that the driver fills in. The
|
D | vidioc-enum-framesizes.rst | 86 In the structs below, *IN* denotes a value that has to be filled in by 87 the application, *OUT* denotes values that the driver fills in. The
|
D | pixfmt-yuv-luma.rst | 17 - Y'\ :sub:`x`\ [9:2] denotes bits 9 to 2 of the Y' value for pixel at column 19 - `0` denotes padding bits set to 0.
|
/Linux-v6.6/arch/powerpc/kernel/ |
D | pci_of_scan.c | 52 * 00 denotes Configuration Space 53 * 01 denotes I/O Space 54 * 10 denotes 32-bit-address Memory Space 55 * 11 denotes 64-bit-address Memory Space
|
/Linux-v6.6/Documentation/ABI/testing/ |
D | sysfs-devices-supplier | 6 links where this device is the consumer. <supplier> denotes the
|
D | sysfs-devices-consumer | 6 links where this device is the supplier. <consumer> denotes the
|
D | sysfs-driver-hid-logitech-lg4ff | 19 contains an abstract item "native" which always denotes the
|
/Linux-v6.6/include/dt-bindings/interconnect/ |
D | qcom,icc.h | 10 * The AMC bucket denotes constraints that are applied to hardware when
|
/Linux-v6.6/Documentation/devicetree/bindings/interrupt-controller/ |
D | aspeed,ast2400-i2c-ic.txt | 12 - interrupt-controller : denotes that the controller receives and fires
|
/Linux-v6.6/Documentation/devicetree/bindings/phy/ |
D | brcm,sr-pcie-phy.txt | 8 - #phy-cells: Must be 1, denotes the PHY index
|
/Linux-v6.6/Documentation/devicetree/bindings/sound/ |
D | serial-midi.yaml | 14 Generic MIDI interface using a serial device. This denotes that a serial device is
|
/Linux-v6.6/arch/powerpc/boot/dts/ |
D | holly.dts | 147 | 01 denotes I/O space 148 | 02 denotes 32-bit memory space
|
/Linux-v6.6/net/dccp/ccids/ |
D | Kconfig | 18 CCID-3 denotes TCP-Friendly Rate Control (TFRC), an equation-based
|
/Linux-v6.6/arch/arm64/boot/dts/qcom/ |
D | qrb5165-rb5-vision-mezzanine.dts | 20 /* The port index denotes CSIPHY id i.e. csiphy2 */
|
/Linux-v6.6/Documentation/admin-guide/sysctl/ |
D | fs.rst | 77 The value in ``file-max`` denotes the maximum number of file- 124 This denotes the maximum number of mounts that may exist 131 This denotes the maximum number of file-handles a process can
|
/Linux-v6.6/Documentation/arch/x86/ |
D | elf_auxvec.rst | 48 AT_MINSIGSTKSZ denotes the minimum stack size required by the kernel to
|
/Linux-v6.6/fs/verity/ |
D | Kconfig | 9 # Note that CRYPTO_SHA256 denotes the generic C implementation, but
|
/Linux-v6.6/include/linux/extcon/ |
D | extcon-adc-jack.h | 19 * denotes the last adc_jack_cond element among the array)
|
/Linux-v6.6/Documentation/devicetree/bindings/dma/ |
D | nvidia,tegra210-adma.yaml | 50 The first cell denotes the receive/transmit request number and
|
/Linux-v6.6/include/uapi/linux/ |
D | igmp.h | 113 #define IGMP_TIMER_SCALE 10 /* denotes that the igmphdr->timer field */
|
/Linux-v6.6/Documentation/devicetree/bindings/mmc/ |
D | mmc-controller.yaml | 127 When specified, denotes that 1.8V card voltage is not supported 342 subnode describes. A value of 0 denotes the memory SD
|
/Linux-v6.6/Documentation/devicetree/bindings/leds/ |
D | leds-lp50xx.yaml | 66 This property denotes the LED module number(s) that is used on the
|
1234567