| /Linux-v6.1/drivers/pinctrl/sunxi/ |
| D | pinctrl-sun4i-a10.c | 601 SUNXI_FUNCTION(0x3, "csi1")), /* MCLK */
735 SUNXI_FUNCTION(0x3, "csi1"), /* PCK */
741 SUNXI_FUNCTION(0x3, "csi1"), /* CK */
747 SUNXI_FUNCTION(0x3, "csi1"), /* HSYNC */
753 SUNXI_FUNCTION(0x3, "csi1"), /* VSYNC */
759 SUNXI_FUNCTION(0x3, "csi1"), /* D0 */
766 SUNXI_FUNCTION(0x3, "csi1"), /* D1 */
773 SUNXI_FUNCTION(0x3, "csi1"), /* D2 */
780 SUNXI_FUNCTION(0x3, "csi1"), /* D3 */
787 SUNXI_FUNCTION(0x3, "csi1"), /* D4 */
[all …]
|
| /Linux-v6.1/Documentation/devicetree/bindings/media/ |
| D | allwinner,sun4i-a10-csi.yaml | 20 - const: allwinner,sun4i-a10-csi1
23 - const: allwinner,sun7i-a20-csi1
24 - const: allwinner,sun4i-a10-csi1
|
| D | qcom,msm8916-camss.yaml | 37 - const: csi1
191 "csi1",
|
| D | qcom,msm8996-camss.yaml | 38 - const: csi1
275 "csi1",
|
| D | qcom,sdm660-camss.yaml | 38 - const: csi1
287 "csi1",
|
| D | qcom,sdm845-camss.yaml | 31 - const: csi1
267 "csi1",
|
| D | ti,omap3isp.txt | 35 CSI1 -- CSIb on 3430
|
| D | allwinner,sun6i-a31-csi.yaml | 104 csi1: csi@1cb4000 {
|
| D | video-interfaces.yaml | 91 - 2 # MIPI CSI1
|
| /Linux-v6.1/Documentation/devicetree/bindings/soc/imx/ |
| D | fsl,imx8mp-media-blk-ctrl.yaml | 36 - const: mipi-csi1
104 power-domain-names = "bus", "mipi-dsi1", "mipi-csi1", "lcdif1", "isi",
|
| /Linux-v6.1/Documentation/admin-guide/media/ |
| D | imx.rst | 154 two video multiplexers. Both CSI0 and CSI1 can receive any virtual
158 by a video mux), virtual channels 1 and 2 are hard-wired to IPU1-CSI1
160 IPU2-CSI1 (again selected by a video mux).
173 other mux sits in front of IPU1-CSI1, and again has five sink pads to
179 channel 0 (two sink pads). The other mux sits in front of IPU2-CSI1 to
427 routed as follows: vc0 to the IPU1 CSI0 mux, vc1 directly to IPU1 CSI1,
428 vc2 directly to IPU2 CSI0, and vc3 to the IPU2 CSI1 mux. The OV5640 is
|
| /Linux-v6.1/arch/arm/boot/dts/ |
| D | sun4i-a10.dtsi | 626 csi1: csi@1c1d000 { label
627 compatible = "allwinner,sun4i-a10-csi1";
683 csi1_8bits_pg_pins: csi1-8bits-pg-pins {
687 function = "csi1";
691 csi1_24bits_ph_pins: csi1-24bits-ph-pins {
698 function = "csi1";
702 csi1_clk_pg_pin: csi1-clk-pg-pin {
704 function = "csi1";
|
| D | sun7i-a20.dtsi | 733 csi1: csi@1c1d000 { label
734 compatible = "allwinner,sun7i-a20-csi1",
735 "allwinner,sun4i-a10-csi1";
818 csi1_8bits_pg_pins: csi1-8bits-pg-pins {
822 function = "csi1";
826 csi1_24bits_ph_pins: csi1-24bits-ph-pins {
833 function = "csi1";
837 csi1_clk_pg_pin: csi1-clk-pg-pin {
839 function = "csi1";
|
| D | sun8i-v3s.dtsi | 361 csi1_8bit_pins: csi1-8bit-pins {
369 csi1_mclk_pin: csi1-mclk-pin {
609 csi1: camera@1cb4000 { label
|
| D | sun8i-s3-pinecube.dts | 61 &csi1 {
|
| D | sun7i-a20-olinuxino-lime2.dts | 246 regulator-name = "vddio-csi1";
|
| /Linux-v6.1/drivers/media/platform/ti/omap3isp/ |
| D | ispccp2.c | 115 /* Reset the CSI1/CCP2B and wait for reset to complete */ in ccp2_reset()
205 * Returns -EIO if strobe is chosen in CSI1 mode, or 0 on success.
282 * and configure CSI1/CCP2 logical channel
430 * CSI1/CCP2 memory input.
857 /* Enable CSI1/CCP2 interface */ in ccp2_s_stream()
891 /* Disable CSI1/CCP2 interface */ in ccp2_s_stream()
1136 * On the OMAP34xx the CSI1 receiver is operated in the CSIb IO in omap3isp_ccp2_init()
|
| D | omap3isp.h | 92 * ISP_CCP2_MODE_MIPI - MIPI-CSI1 mode
|
| /Linux-v6.1/drivers/media/platform/qcom/camss/ |
| D | camss.c | 82 "csi1", "csi1_phy", "csi1_pix", "csi1_rdi" },
100 "csi1", "csi1_pix", "csi1_rdi" },
189 "csi1", "csi1_phy", "csi1_pix", "csi1_rdi" },
241 "csi1", "csi1_pix", "csi1_rdi",
356 "csi1", "csi1_phy", "csi1_pix", "csi1_rdi",
417 "csi1", "csi1_pix", "csi1_rdi",
569 "vfe1_cphy_rx", "csi1",
631 "vfe1_src", "csi1",
|
| /Linux-v6.1/drivers/interconnect/imx/ |
| D | imx8mn.c | 45 DEFINE_BUS_MASTER("CSI1", IMX8MN_ICM_CSI1, IMX8MN_ICN_MIPI),
|
| D | imx8mq.c | 59 DEFINE_BUS_MASTER("CSI1", IMX8MQ_ICM_CSI1, IMX8MQ_ICN_DISPLAY),
|
| /Linux-v6.1/drivers/soc/sunxi/ |
| D | sunxi_mbus.c | 32 "allwinner,sun4i-a10-csi1",
|
| /Linux-v6.1/Documentation/devicetree/bindings/display/imx/ |
| D | fsl-imx-drm.txt | 40 Ports 0 and 1 should correspond to CSI0 and CSI1,
|
| /Linux-v6.1/include/media/ |
| D | v4l2-mediabus.h | 155 * Interface version 1 (MIPI CSI1) or Standard
|
| /Linux-v6.1/drivers/media/platform/sunxi/sun4i-csi/ |
| D | sun4i_csi.c | 290 { .compatible = "allwinner,sun4i-a10-csi1", .data = &sun4i_a10_csi1_traits },
|
