| /Linux-v6.6/include/uapi/linux/ |
| D | dm-log-userspace.h | 50 * DM_ULOG_CTR corresponds to (found in dm-dirty-log.h):
75 * DM_ULOG_DTR corresponds to (found in dm-dirty-log.h):
94 * DM_ULOG_PRESUSPEND corresponds to (found in dm-dirty-log.h):
113 * DM_ULOG_POSTSUSPEND corresponds to (found in dm-dirty-log.h):
132 * DM_ULOG_RESUME corresponds to (found in dm-dirty-log.h):
151 * DM_ULOG_GET_REGION_SIZE corresponds to (found in dm-dirty-log.h):
169 * DM_ULOG_IS_CLEAN corresponds to (found in dm-dirty-log.h):
187 * DM_ULOG_IN_SYNC corresponds to (found in dm-dirty-log.h):
202 * DM_ULOG_FLUSH corresponds to (found in dm-dirty-log.h):
226 * DM_ULOG_MARK_REGION corresponds to (found in dm-dirty-log.h):
[all …]
|
| D | lp.h | 73 #define LPCHAR 0x0601 /* corresponds to LP_INIT_CHAR */
74 #define LPTIME 0x0602 /* corresponds to LP_INIT_TIME */
80 #define LPWAIT 0x0608 /* corresponds to LP_INIT_WAIT */
|
| /Linux-v6.6/drivers/hid/intel-ish-hid/ipc/ |
| D | hw-ish-regs.h | 46 /* bit corresponds HOST2ISH interrupt in PISR and PIMR registers */
50 /* bit corresponds ISH2HOST interrupt in PISR and PIMR registers */
53 /* bit corresponds ISH2HOST interrupt in PISR and PIMR registers */
57 /* bit corresponds ISH2HOST busy clear interrupt in PIMR register */
63 /* bit corresponds ISH2HOST busy clear interrupt in IPC_BUSY_CLR register */
66 /* bit corresponds busy bit in doorbell registers */
81 /* bit corresponds host ready bit in Host Status Register (HOST_COMM) */
100 * bit corresponds host ready bit in both status registers
126 /* bit corresponds host ready bit in ISH FW Status Register */
191 /* bit corresponds host ready bit in Host Status Register (HOST_COMM) */
|
| /Linux-v6.6/Documentation/userspace-api/media/v4l/ |
| D | ext-ctrls-colorimetry.rst | 67 color primaries, index value c equal to 0 corresponds to the Green
68 primary, c equal to 1 corresponds to Blue primary and c equal to 2
69 corresponds to the Red color primary.
75 color primaries, index value c equal to 0 corresponds to the Green
76 primary, c equal to 1 corresponds to Blue primary and c equal to 2
77 corresponds to Red color primary.
|
| D | ext-ctrls-dv.rst | 29 bitmasks, one bit for each pad. Bit 0 corresponds to pad 0, bit 1 to pad
44 hotplug pin as seen by the transmitter. Each bit corresponds to an
54 Each bit corresponds to an output pad on the transmitter. If an
62 at least the first block (= 128 bytes). Each bit corresponds to an
130 corresponds to an input pad on the receiver. If an input pad
|
| /Linux-v6.6/sound/soc/amd/ps/ |
| D | acp63.h | 58 /* ACP63_PDM_MODE_DEVS corresponds to platform devices count for ACP PDM configuration */
62 * ACP63_SDW0_MODE_DEVS corresponds to platform devices count for
68 * ACP63_SDW0_SDW1_MODE_DEVS corresponds to platform devices count for SW0 + SW1 SoundWire manager
74 * ACP63_SDW0_PDM_MODE_DEVS corresponds to platform devices count for SW0 manager
80 * ACP63_SDW0_SDW1_PDM_MODE_DEVS corresponds to platform devices count for
91 /* ACP63_PDM_DEV_CONFIG corresponds to platform device configuration for ACP PDM controller */
94 /* ACP63_SDW_DEV_CONFIG corresponds to platform device configuration for SDW manager instances */
98 * ACP63_SDW_PDM_DEV_CONFIG corresponds to platform device configuration for ACP PDM + SoundWire
|
| /Linux-v6.6/Documentation/hwmon/ |
| D | ibmpowernv.rst | 44 sub-group. In POWER9, this attribute corresponds to
57 sub-group. In POWER9, this attribute corresponds to
68 sub-group. In POWER9, this attribute corresponds to
79 sub-group. In POWER9, this attribute corresponds to
|
| /Linux-v6.6/Documentation/ABI/testing/ |
| D | sysfs-class-intel_pmt | 45 (RO) The size of telemetry region in bytes that corresponds to
53 (RO) The offset of telemetry region in bytes that corresponds to
91 (RO) The length of the result buffer in bytes that corresponds
99 (RO) The offset of the buffer in bytes that corresponds
|
| D | debugfs-wilco-ec | 33 // Corresponds with sending type 0x00f0 with
38 // Corresponds with MBOX = [00, 00, 31, 32, 2f, 32, 31, 38, ...]
|
| /Linux-v6.6/arch/powerpc/perf/ |
| D | hv-gpci.c | 147 * ret value as 'H_PARAMETER' corresponds to 'GEN_BUF_TOO_SMALL', in systeminfo_gpci_request()
171 * hcall also populates 'cv_element_size' corresponds to individual in systeminfo_gpci_request()
203 * Pass the counter request value 0xD0 corresponds to request in processor_bus_topology_show()
219 * ret value as 'H_PARAMETER' corresponds to 'GEN_BUF_TOO_SMALL', which in processor_bus_topology_show()
271 * Pass the counter request value 0x90 corresponds to request in processor_config_show()
287 * ret value as 'H_PARAMETER' corresponds to 'GEN_BUF_TOO_SMALL', which in processor_config_show()
339 * Pass the counter request 0xA0 corresponds to request in affinity_domain_via_virtual_processor_show()
355 * ret value as 'H_PARAMETER' corresponds to 'GEN_BUF_TOO_SMALL', which in affinity_domain_via_virtual_processor_show()
409 * Pass the counter request 0xB0 corresponds to request in affinity_domain_via_domain_show()
425 * ret value as 'H_PARAMETER' corresponds to 'GEN_BUF_TOO_SMALL', which in affinity_domain_via_domain_show()
[all …]
|
| /Linux-v6.6/drivers/net/ethernet/chelsio/cxgb3/ |
| D | firmware_exports.h | 98 /* FW_TUNNEL_NUM corresponds to the number of supported TUNNEL Queues. These
109 /* FW_CTRL_NUM corresponds to the number of supported CTRL Queues. These queues
119 /* FW_OFLD_NUM corresponds to the number of supported OFFLOAD Queues. These
144 /* FW_WRC_NUM corresponds to the number of Work Request Context that supported
|
| /Linux-v6.6/drivers/parisc/ |
| D | iosapic_private.h | 58 ** 0x0 corresponds to INT_A#,
59 ** 0x1 corresponds to INT_B#,
60 ** 0x2 corresponds to INT_C#
61 ** 0x3 corresponds to INT_D#
|
| /Linux-v6.6/Documentation/devicetree/bindings/mmc/ |
| D | sdhci.txt | 8 property corresponds to the bits in the sdhci capability register. If the bit
12 property corresponds to the bits in the sdhci capability register. If the
|
| /Linux-v6.6/arch/arm/boot/dts/ti/omap/ |
| D | dra76x-mmc-iodelay.dtsi | 129 /* Corresponds to MMC1_DDR_MANUAL1 in datamanual */
152 /* Corresponds to MMC1_SDR104_MANUAL1 in datamanual */
169 /* Corresponds to MMC2_HS200_MANUAL1 in datamanual */
194 /* Corresponds to MMC3_MANUAL1 in datamanual */
217 /* Corresponds to MMC3_MANUAL2 in datamanual */
240 /* Corresponds to MMC4_MANUAL1 in datamanual */
263 /* Corresponds to MMC4_DS_MANUAL1 in datamanual */
|
| D | dra74x-mmc-iodelay.dtsi | 302 /* Corresponds to MMC1_DDR_MANUAL1 in datamanual */
325 /* Corresponds to MMC1_DDR_MANUAL1 in datamanual */
348 /* Corresponds to MMC1_SDR104_MANUAL1 in datamanual */
365 /* Corresponds to MMC1_SDR104_MANUAL1 in datamanual */
382 /* Corresponds to MMC2_HS200_MANUAL1 in datamanual */
407 /* Corresponds to MMC2_HS200_MANUAL1 in datamanual */
467 /* Corresponds to MMC2_DDR_1V8_MANUAL1 in datamanual */
502 /* Corresponds to MMC3_MANUAL1 in datamanual */
525 /* Corresponds to MMC3_MANUAL1 in datamanual */
548 /* Corresponds to MMC4_DS_MANUAL1 in datamanual */
[all …]
|
| /Linux-v6.6/include/dt-bindings/regulator/ |
| D | qcom,rpmh-regulator.h | 16 * allowed. This mode corresponds to PFM for SMPS
27 * corresponds to PWM for SMPS and BOB type
|
| /Linux-v6.6/Documentation/devicetree/bindings/powerpc/ |
| D | ibm,powerpc-cpu-features.txt | 55 Value corresponds to the "Power ISA Version" multiplied by 1000.
56 For example, <3000> corresponds to Version 3.0, <2070> to Version 2.07.
157 This property also exists if an HFSCR bit corresponds with this feature.
170 This property also exists if an FSCR bit corresponds with this feature.
|
| /Linux-v6.6/Documentation/virt/acrn/ |
| D | cpuid.rst | 21 Note that this value in ebx, ecx and edx corresponds to the string
22 "ACRNACRNACRN". The value in eax corresponds to the maximum cpuid function
|
| /Linux-v6.6/Documentation/admin-guide/pm/ |
| D | intel_epb.rst | 26 a value of 0 corresponds to a hint preference for highest performance
27 and a value of 15 corresponds to the maximum energy savings.
|
| /Linux-v6.6/Documentation/devicetree/bindings/serial/ |
| D | rs485.yaml | 23 milliseconds. It corresponds to the delay before sending data.
27 It corresponds to the delay after sending data and actual release
|
| /Linux-v6.6/drivers/hwmon/ |
| D | hwmon-vid.c | 32 * This corresponds to an arbitrary VRM code of 24 in the functions below.
40 * This corresponds to an arbitrary VRM code of 25 in the functions below.
49 * The 13 specification corresponds to the Intel Pentium M series. There
54 * The 14 specification corresponds to Intel Core series. There
59 * The 110 (VRM 11) specification corresponds to Intel Conroe based series.
|
| /Linux-v6.6/drivers/media/usb/em28xx/ |
| D | em28xx.h | 336 * On devices with AC97, it corresponds to the AC97 mixer "Video" control.
338 * Only for devices with AC97. Corresponds to AC97 mixer "Line In".
343 * Only for devices with AC97. Corresponds to AC97 mixer "Phone".
345 * Only for devices with AC97. Corresponds to AC97 mixer "Mic".
347 * Only for devices with AC97. Corresponds to AC97 mixer "CD".
349 * Only for devices with AC97. Corresponds to AC97 mixer "Aux".
351 * Only for devices with AC97. Corresponds to AC97 mixer "PCM out".
|
| /Linux-v6.6/Documentation/devicetree/bindings/iio/adc/ |
| D | ti,am3359-adc.yaml | 35 ti,adc-channels. The value corresponds to the number of ADC clock cycles
44 ti,adc-channels. The value corresponds to the number of ADC clock cycles
|
| /Linux-v6.6/security/selinux/ss/ |
| D | conditional.h | 54 * expression (the true list corresponds to if and the false list corresponds
|
| /Linux-v6.6/Documentation/devicetree/bindings/pwm/ |
| D | microchip,corepwm.yaml | 48 Each bit of "microchip,sync-update-mask" corresponds to a PWM channel & represents
62 Each bit corresponds to a PWM channel & represents whether DAC mode is enabled
|
