Searched full:circuitry (Results 1 – 25 of 69) sorted by relevance
123
/Linux-v5.15/Documentation/devicetree/bindings/usb/ |
D | usb251xb.txt | 51 silicon along with all associated circuitry including a permanently 55 silicon along with all associated circuitry including a permanently 59 silicon along with all associated circuitry excluding a permanently 63 silicon along with all associated circuitry excluding a permanently
|
/Linux-v5.15/Documentation/networking/device_drivers/hamradio/ |
D | baycom.rst | 67 detect circuitry. 131 busy. This is the task of the DCD circuitry/software. The driver may either 138 as it is much faster than most hardware squelch circuitry. The 145 DCD circuitry is recommended.
|
/Linux-v5.15/Documentation/devicetree/bindings/clock/ |
D | st,nomadik.txt | 16 board has its own circuitry for providing this oscillator 19 if the board has its own circuitry for providing this
|
/Linux-v5.15/Documentation/hwmon/ |
D | lochnagar.rst | 12 Lochnagar 2 features built-in Current Monitor circuitry that allows for the 15 hardware modifications or external circuitry to operate.
|
D | da9055.rst | 17 resolution and track and hold circuitry combined with an analogue input
|
D | smsc47m1.rst | 57 contain monitoring and PWM control circuitry for two fans.
|
D | da9052.rst | 18 resolution and track and hold circuitry combined with an analogue input
|
D | lm85.rst | 130 Both have special circuitry to compensate for PWM interactions with the 132 speed of a two wire fan, but the input conditioning circuitry is different
|
/Linux-v5.15/Documentation/devicetree/bindings/iio/adc/ |
D | st,stm32-adc.yaml | 48 - "adc" clock: for the analog circuitry, common to all ADCs. 59 Allow to specify desired max clock rate used by analog circuitry. 80 analog circuitry on stm32mp1.
|
D | ti,adc12138.yaml | 13 13 bit ADCs with 1, 2 or 8 inputs and self calibrating circuitry to
|
/Linux-v5.15/drivers/gpu/drm/amd/pm/inc/ |
D | smu_v11_0_7_pptable.h | 32 …O 0x8 // This cap indicates whether board supports the BACO circuitry. 33 …O 0x10 // This cap indicates whether board supports the MACO circuitry.
|
/Linux-v5.15/Documentation/devicetree/bindings/sound/ |
D | tas5720.txt | 16 - dvdd-supply : phandle to a 3.3-V supply for the digital circuitry
|
/Linux-v5.15/drivers/comedi/drivers/ |
D | ni_at_a2150.c | 235 /* clear fifo and reset triggering circuitry */ in a2150_cancel() 479 /* clear fifo and reset triggering circuitry */ in a2150_ai_cmd() 585 /* clear fifo and reset triggering circuitry */ in a2150_ai_rinsn() 631 /* clear fifo and reset triggering circuitry */ in a2150_ai_rinsn() 741 /* reset and sync adc clock circuitry */ in a2150_attach()
|
/Linux-v5.15/Documentation/devicetree/bindings/iio/frequency/ |
D | adf4371.yaml | 41 measured by the digital lock detect circuitry.
|
/Linux-v5.15/Documentation/devicetree/bindings/media/ |
D | cec-gpio.txt | 8 5V lines it is 5.3V. So you may need some sort of level conversion circuitry
|
/Linux-v5.15/Documentation/devicetree/bindings/input/ |
D | cap11xx.txt | 24 microchip,sensor-gain: Defines the gain of the sensor circuitry. This
|
/Linux-v5.15/Documentation/ABI/testing/ |
D | sysfs-bus-iio-temperature-max31856 | 19 Overvoltage or Undervoltage Input Fault. The internal circuitry
|
/Linux-v5.15/Documentation/devicetree/bindings/regulator/ |
D | vctrl.txt | 19 circuitry which shuts down the regulator when the
|
/Linux-v5.15/arch/m68k/mac/ |
D | macboing.c | 112 * because of the AT&T DSP3210 hardware circuitry and the 16-bit Singer in mac_init_asc() 113 * codec circuitry in the AVs. The Audio Waveform Amplifier and in mac_init_asc()
|
/Linux-v5.15/drivers/gpu/drm/ |
D | drm_panel.c | 102 * integrated circuitry via a command bus. 179 * the integrated circuitry via any command bus after this call.
|
/Linux-v5.15/Documentation/devicetree/bindings/display/bridge/ |
D | thine,thc63lvd1024.yaml | 74 digital circuitry.
|
/Linux-v5.15/Documentation/devicetree/bindings/iio/dac/ |
D | adi,ad5758.yaml | 28 In this mode, the AD5758 circuitry senses the output voltage and
|
/Linux-v5.15/drivers/net/ethernet/chelsio/cxgb/ |
D | pm3393.c | 702 * DRESETB - Digital circuitry in pm3393_mac_reset() 703 * PL4_ARESETB - PL4 analog circuitry in pm3393_mac_reset() 704 * XAUI_ARESETB - XAUI bus analog circuitry in pm3393_mac_reset() 768 /* Has the XAUI MABC PLL circuitry stablized? */ in pm3393_mac_reset()
|
/Linux-v5.15/arch/x86/boot/ |
D | a20.c | 83 is useful when dealing with the KBC or other slow external circuitry. */
|
/Linux-v5.15/Documentation/admin-guide/ |
D | hw_random.rst | 65 bits the RNG circuitry will enter a low power state. Intel will
|
123