Searched full:capacitor (Results 1 – 25 of 44) sorted by relevance
12
/Linux-v5.10/Documentation/devicetree/bindings/iio/proximity/ |
D | as3935.txt | 15 - ams,tuning-capacitor-pf: Calibration tuning capacitor stepping 32 ams,tuning-capacitor-pf = <80>;
|
/Linux-v5.10/Documentation/devicetree/bindings/sound/ |
D | qcom,msm8916-wcd-analog.txt | 50 - qcom,micbias1-ext-cap: boolean, present if micbias1 has external capacitor 52 - qcom,micbias2-ext-cap: boolean, present if micbias2 has external capacitor
|
D | ti,tas5086.txt | 16 split-capacitor charge period. The hardware chip
|
/Linux-v5.10/drivers/media/tuners/ |
D | mt2060_priv.h | 55 V1CSE : LO1 VCO Automatic Capacitor Select Enable ( ? ) 56 V1CS : LO1 Capacitor Selection Value ( ? )
|
/Linux-v5.10/drivers/iio/proximity/ |
D | as3935.c | 379 "ams,tuning-capacitor-pf", &st->tune_cap); in as3935_probe() 382 dev_warn(dev, "no tuning-capacitor-pf set, defaulting to %d", in as3935_probe() 387 dev_err(dev, "wrong tuning-capacitor-pf setting of %d\n", in as3935_probe()
|
/Linux-v5.10/include/linux/regulator/ |
D | tps62360.h | 19 * @en_discharge: Enable discharge the output capacitor via internal
|
/Linux-v5.10/Documentation/devicetree/bindings/mmc/ |
D | sdhci-atmel.txt | 21 and a capacitor (see "SDMMC I/O Calibration" chapter).
|
/Linux-v5.10/Documentation/devicetree/bindings/power/supply/ |
D | qcom,coincell-charger.txt | 3 The hardware block controls charging for a coincell or capacitor that is
|
D | bq25980.yaml | 18 switched capacitor architecture.
|
/Linux-v5.10/Documentation/devicetree/bindings/clock/ |
D | ti,cdce925.txt | 25 - xtal-load-pf: Crystal load-capacitor value to fine-tune performance on a
|
/Linux-v5.10/Documentation/hwmon/ |
D | bel-pfe.rst | 92 in2_input Hold up capacitor voltage
|
/Linux-v5.10/sound/soc/codecs/ |
D | inno_rk3036.c | 356 /* set a big current for capacitor charging. */ in rk3036_codec_set_bias_level() 364 /* set a big current for capacitor discharging. */ in rk3036_codec_set_bias_level()
|
/Linux-v5.10/include/linux/iio/frequency/ |
D | ad9523.h | 135 * @cpole1: PLL2 loop filter Cpole capacitor value.
|
/Linux-v5.10/include/linux/mfd/arizona/ |
D | pdata.h | 60 unsigned int ext_cap:1; /** External capacitor fitted */
|
/Linux-v5.10/drivers/scsi/mvsas/ |
D | mv_sas.h | 258 /* 4 bits, FFE Capacitor Select (value range 0~F) */ 285 * BIT 0~3 : FFE Capacitor select(value range 0~F)
|
/Linux-v5.10/include/linux/mfd/wm8994/ |
D | pdata.h | 195 /* Configure WM1811 jack detection for use with external capacitor */
|
/Linux-v5.10/Documentation/userspace-api/media/v4l/ |
D | ext-ctrls-flash.rst | 179 Enable or disable charging of the xenon flash capacitor.
|
D | ext-ctrls-fm-tx.rst | 176 This selects the value of antenna tuning capacitor manually or
|
/Linux-v5.10/arch/arm/mach-omap1/ |
D | board-palmtt.c | 217 .vref_delay_usecs = 100, /* internal, no capacitor */
|
D | board-palmz71.c | 184 .vref_delay_usecs = 100, /* internal, no capacitor */
|
D | board-innovator.c | 219 .vref_delay_usecs = 100, /* internal, no capacitor */
|
/Linux-v5.10/Documentation/admin-guide/media/ |
D | si4713.rst | 127 antenna_capacitor - This selects the value of antenna tuning capacitor
|
/Linux-v5.10/drivers/regulator/ |
D | stm32-vrefbuf.c | 58 * Vrefbuf startup time depends on external capacitor: wait here for in stm32_vrefbuf_enable()
|
/Linux-v5.10/drivers/staging/fbtft/ |
D | fb_ili9320.c | 96 /* Dis-charge capacitor power voltage */ in init_display()
|
/Linux-v5.10/drivers/media/radio/wl128x/ |
D | fmdrv_tx.c | 349 /* Get the TX tuning capacitor value.*/
|
12