Searched full:cage (Results 1 – 14 of 14) sorted by relevance
| /Linux-v5.15/arch/arm/boot/dts/ |
| D | armada-385-turris-omnia.dts | 150 * eth2 is connected via a multiplexor to both the SFP cage and to
151 * ethernet-phy@1. The multiplexor switches the signal to SFP cage when
|
| /Linux-v5.15/Documentation/devicetree/bindings/net/ |
| D | ethernet-phy.yaml | 163 Specifies a reference to a node representing a SFP cage.
|
| D | ethernet-controller.yaml | 136 Specifies a reference to a node representing a SFP cage.
|
| /Linux-v5.15/drivers/net/phy/ |
| D | Kconfig | 59 tristate "SFP cage support"
|
| D | phy_device.c | 1289 * @bus: sfp bus representing cage being attached
1306 * @bus: sfp bus representing cage being attached
1321 * phy_sfp_probe - probe for a SFP cage attached to this PHY device
|
| /Linux-v5.15/Documentation/networking/ |
| D | sfp-phylink.rst | 282 For information describing the SFP cage in DT, please see the binding
|
| /Linux-v5.15/drivers/net/ethernet/intel/ice/ |
| D | ice_common.c | 230 * Node type cage can be used to determine if cage is present. If AQC
231 * returns error (ENOENT), then no cage present. If no cage present, then
258 * Returns true if media cage is present, else false. If no cage, then
263 /* Node type cage can be used to determine if cage is present. If AQC in ice_is_media_cage_present()
264 * returns error (ENOENT), then no cage present. If no cage present then in ice_is_media_cage_present()
|
| /Linux-v5.15/drivers/net/ethernet/intel/igb/ |
| D | e1000_82575.c | 501 /* Turn I2C interface ON and power on sfp cage */ in igb_set_sfp_media_type_82575()
905 /* restore previous sfp cage power state */ in igb_get_phy_id_82575()
1598 /* allow time for SFP cage time to power up phy */ in igb_setup_copper_link_82575()
1673 /* power on the sfp cage if present and turn on I2C */ in igb_setup_serdes_link_82575()
|
| /Linux-v5.15/drivers/hwmon/ |
| D | intel-m10-bmc-hwmon.c | 378 * When the QSFP is unplugged from cage, driver will get 0xdeadbeef in do_sensor_read()
|
| /Linux-v5.15/drivers/bus/ |
| D | moxtet.c | 33 { "sfp", -1, 0, "MOX D (SFP cage)" },
|
| /Linux-v5.15/drivers/gpio/ |
| D | Kconfig | 1629 bus. For example the Mox module with SFP cage needs this driver
|
| /Linux-v5.15/drivers/scsi/ |
| D | Kconfig | 182 manage devices. If you have a disk cage, the chances are that
|
| /Linux-v5.15/drivers/net/ethernet/intel/ixgbe/ |
| D | ixgbe_x550.c | 1691 * internal PHY directly to an SFP cage, without autonegotiation.
|
| D | ixgbe_common.c | 3299 * the SFP+ cage is full. in ixgbe_check_mac_link_generic()
|
