| /Linux-v5.15/drivers/soc/bcm/brcmstb/pm/ |
| D | aon_defs.h | 3 * Always ON (AON) register interface between bootloader and Linux
28 * Modification of this bit reserved for bootloader only.
34 * Modification of this bit reserved for bootloader only.
65 * Bootloader utilizes a custom parameter block left in DRAM for handling S3
69 /* scratch memory for bootloader */
92 * providing a large DRAM buffer to the bootloader
|
| /Linux-v5.15/arch/m68k/include/asm/ |
| D | bootstd.h | 2 /* bootstd.h: Bootloader system call interface
10 #define NR_BSC 21 /* last used bootloader system call */
12 #define __BN_reset 0 /* reset and start the bootloader */
14 #define __BN_exec 2 /* executes a bootloader image */
15 #define __BN_exit 3 /* terminates a bootloader image */
26 #define __BN_getbenv 14 /* get a bootloader envvar */
27 #define __BN_setbenv 15 /* get a bootloader envvar */
35 * We use similar macros to call into the bootloader as for uClinux
|
| /Linux-v5.15/Documentation/devicetree/bindings/power/reset/ |
| D | reboot-mode.yaml | 15 or ram. Then the bootloader can read it and take different
19 the bootloader what to do when the system reboots, and should be named
25 …- bootloader: Android fastboot mode, it's a mode to re-flash partitions on the Android based devic…
26 - loader: A bootloader mode, it's a mode used to download image on Rockchip platform,
46 mode-bootloader = <2>;
|
| /Linux-v5.15/arch/arm/mach-omap1/ |
| D | Kconfig | 35 Pin multiplexing support for OMAP boards. If your bootloader
48 bool "Warn about pins the bootloader didn't set up"
119 need a PalmOS compatible bootloader; check out
128 you'll need a PalmOS compatible bootloader; check out
137 need a PalmOS compatible bootloader (Garux); check out
147 you'll need a SX1 compatible bootloader; check out
|
| /Linux-v5.15/arch/alpha/boot/ |
| D | Makefile | 14 tools/bootpzh bootloader bootpheader bootpzheader
90 $(obj)/tools/lxboot: $(obj)/bootloader $(OBJSTRIP) FORCE
93 $(obj)/tools/bootlx: $(obj)/bootloader $(OBJSTRIP) FORCE
111 $(obj)/bootloader: $(obj)/bootloader.lds $(OBJ_bootlx) $(LIBS_Y) FORCE
114 $(obj)/bootpheader: $(obj)/bootloader.lds $(OBJ_bootph) $(LIBS_Y) FORCE
117 $(obj)/bootpzheader: $(obj)/bootloader.lds $(OBJ_bootpzh) $(LIBS_Y) FORCE
|
| /Linux-v5.15/drivers/platform/x86/intel/wmi/ |
| D | sbl-fw-update.c | 3 * Slim Bootloader(SBL) firmware update signaling driver
5 * Slim Bootloader is a small, open-source, non UEFI compliant, boot firmware
116 dev_info(&wdev->dev, "Slim Bootloader signaling driver attached\n"); in intel_wmi_sbl_fw_update_probe()
122 dev_info(&wdev->dev, "Slim Bootloader signaling driver removed\n"); in intel_wmi_sbl_fw_update_remove()
143 MODULE_DESCRIPTION("Slim Bootloader firmware update signaling driver");
|
| /Linux-v5.15/drivers/media/pci/saa7164/ |
| D | saa7164-fw.c | 261 "%s() Unknown bootloader flags 0x%x\n", in saa7164_downloadfirmware()
323 "%s() Unknown bootloader flags 0x%x\n", in saa7164_downloadfirmware()
434 /* Retrieve bootloader if reqd */ in saa7164_downloadfirmware()
436 /* Second bootloader in the firmware file */ in saa7164_downloadfirmware()
445 /* Get bootloader (if reqd) and firmware header */ in saa7164_downloadfirmware()
455 dprintk(DBGLVL_FW, "Onboard BootLoader:\n"); in saa7164_downloadfirmware()
468 dprintk(DBGLVL_FW, "BootLoader version in rom %d.%d.%d.%d\n", in saa7164_downloadfirmware()
474 dprintk(DBGLVL_FW, "BootLoader version in file %d.%d.%d.%d\n", in saa7164_downloadfirmware()
511 /* Get ready to upload the bootloader */ in saa7164_downloadfirmware()
519 dprintk(DBGLVL_FW, "bootloader d/l starts.\n"); in saa7164_downloadfirmware()
[all …]
|
| /Linux-v5.15/Documentation/devicetree/bindings/input/touchscreen/ |
| D | cypress,cy8ctma340.yaml | 67 bootloader-key:
68 description: the 8-byte bootloader key that is required to switch
69 the chip from bootloader mode (default mode) to application mode
117 - bootloader-key
139 bootloader-key = /bits/ 8 <0x00 0x01 0x02 0x03 0x04 0x05 0x06 0x07>;
|
| /Linux-v5.15/arch/arm/boot/dts/ |
| D | at91-sama5d27_som1.dtsi | 55 bootloader@40000 {
56 label = "bootloader";
61 label = "bootloader env redundant";
66 label = "bootloader env";
|
| D | bcm2711-rpi.dtsi | 7 /* Will be filled by the bootloader */
58 * RPi4's co-processor will copy the board's bootloader configuration
63 compatible = "raspberrypi,bootloader-config", "nvmem-rmem";
|
| D | armada-xp-crs305-1g-4s.dtsi | 10 * Note: this Device Tree assumes that the bootloader has remapped the
14 * boards were delivered with an older version of the bootloader that
16 * situation, you should either update your bootloader (preferred
|
| /Linux-v5.15/arch/mips/cavium-octeon/ |
| D | octeon_boot.h | 24 /* similar to bootloader's linux_app_boot_info but without global data */
63 /* If not to copy a lot of bootloader's structures
67 /* hardcoded in bootloader */
|
| /Linux-v5.15/Documentation/devicetree/bindings/remoteproc/ |
| D | st-rproc.txt | 6 Co-processors can be controlled from the bootloader or the primary OS. If
7 the bootloader starts a co-processor, the primary OS must detect its state
18 - clock-frequency Clock frequency to set co-processor at if the bootloader
|
| /Linux-v5.15/arch/powerpc/boot/dts/ |
| D | mpc8349emitxgp.dts | 34 timebase-frequency = <0>; // from bootloader
35 bus-frequency = <0>; // from bootloader
36 clock-frequency = <0>; // from bootloader
52 bus-frequency = <0>; // from bootloader
189 clock-frequency = <0>; // from bootloader
199 clock-frequency = <0>; // from bootloader
|
| D | tqm5200.dts | 29 timebase-frequency = <0>; // from bootloader
30 bus-frequency = <0>; // from bootloader
31 clock-frequency = <0>; // from bootloader
46 bus-frequency = <0>; // from bootloader
47 system-frequency = <0>; // from bootloader
|
| D | charon.dts | 32 timebase-frequency = <0>; // from bootloader
33 bus-frequency = <0>; // from bootloader
34 clock-frequency = <0>; // from bootloader
49 bus-frequency = <0>; // from bootloader
50 system-frequency = <0>; // from bootloader
|
| /Linux-v5.15/arch/arm/mach-s3c/ |
| D | sleep-s3c24xx.S | 22 * S3C24XX_DEBUG_RESUME is dangerous if your bootloader does not
29 /* sleep magic, to allow the bootloader to check for an valid
38 * resume code entry for bootloader to call
|
| /Linux-v5.15/Documentation/x86/x86_64/ |
| D | uefi.rst | 10 the needed bootloader support and associated tools for x86_64 platforms
15 2. Booting Linux kernel on UEFI x86_64 platform requires bootloader
37 elilo bootloader with x86_64 support, elilo configuration file,
|
| /Linux-v5.15/arch/mips/include/asm/octeon/ |
| D | cvmx-sysinfo.h | 29 * This module provides system/board information obtained by the bootloader.
71 /* exception base address, as set by bootloader */
107 /* configuration flags from bootloader */
116 * by the bootloader.
|
| D | cvmx-bootmem.h | 52 * which is used to maintain the free memory list. Since the bootloader is
60 * bootloader, so this structure should not be changed
150 * passed to the application by the bootloader at a specific
176 * to the application by the bootloader, and assign it a name in the
191 * that was passed to the application by the bootloader, and assign it
211 * free list that was passed to the application by the bootloader, and
|
| /Linux-v5.15/drivers/memory/ |
| D | Kconfig | 119 Enables verbose debugging mostly to decode the bootloader provided
120 timings. To preserve the bootloader provided timings, the reset
124 NOTE: In addition to matching the register setup with the bootloader
126 bootloader or else the GPMC timings won't be identical with the
127 bootloader timings.
|
| /Linux-v5.15/drivers/hid/ |
| D | hid-picolcd.h | 41 #define REPORT_VERSION 0xf1 /* LCD: IN[2],OUT[1] Bootloader: IN[2],OUT[1] */
42 #define REPORT_BL_ERASE_MEMORY 0xf2 /* Bootloader: IN[36],OUT[4] */
43 #define REPORT_BL_READ_MEMORY 0xf3 /* Bootloader: IN[36],OUT[4] */
44 #define REPORT_BL_WRITE_MEMORY 0xf4 /* Bootloader: IN[36],OUT[36] */
45 #define REPORT_DEVID 0xf5 /* LCD: IN[5], OUT[1] Bootloader: IN[5],OUT[1] */
48 #define REPORT_EXIT_FLASHER 0xff /* Bootloader: OUT[2] */
|
| /Linux-v5.15/arch/mips/loongson64/ |
| D | reset.c | 74 char *str, *ptr, *bootloader = "kexec"; in loongson_kexec_prepare() local
85 if (!strncmp(bootloader, (char *)image->segment[i].buf, in loongson_kexec_prepare()
86 strlen(bootloader))) { in loongson_kexec_prepare()
89 * of parameters (as bootloader does). in loongson_kexec_prepare()
|
| /Linux-v5.15/Documentation/translations/zh_CN/arm/ |
| D | Booting | 97 bootloader 必须创建和初始化内核标签列表。一个有效的标签列表以
106 bootloader 必须传递一个系统内存的位置和最小值，以及根文件系统位置。
125 bootloader 必须以 64bit 地址对齐的形式加载一个设备树映像(dtb)到系统
131 bootloader 必须传递一个系统内存的位置和最小值，以及根文件系统位置。
|
| /Linux-v5.15/arch/mips/netlogic/common/ |
| D | smpboot.S | 99 * In case of RMIboot bootloader which is used on XLR boards, the CPUs
100 * be already woken up and waiting in bootloader code.
101 * This will get them out of the bootloader code and into linux. Needed
102 * because the bootloader area will be taken and initialized by linux.
|
