| /Linux-v6.6/drivers/bluetooth/ |
| D | Kconfig | 3 menu "Bluetooth device drivers"
31 Bluetooth HCI USB driver.
32 This driver is required if you want to use Bluetooth devices with
35 Say Y here to compile support for Bluetooth USB devices into the
39 bool "Enable USB autosuspend for Bluetooth USB devices by default"
42 Say Y here to enable USB autosuspend for Bluetooth USB devices by
49 bool "Enable USB poll_sync for Bluetooth USB devices by default"
56 Say Y here to enable USB poll_sync for Bluetooth USB devices by
66 download support for Broadcom Bluetooth controllers.
77 support and chip initialization for MediaTek Bluetooth
[all …]
|
| D | btsdio.c | 4 * Generic Bluetooth SDIO driver
23 #include <net/bluetooth/bluetooth.h>
24 #include <net/bluetooth/hci_core.h>
29 /* Generic Bluetooth Type-A SDIO device */
32 /* Generic Bluetooth Type-B SDIO device */
35 /* Generic Bluetooth AMP controller */
61 #define REG_MD_STAT 0x20 /* Bluetooth Mode Status */
62 #define REG_MD_SET 0x20 /* Bluetooth Mode Set */
291 * UART connection for Bluetooth, ignore the BT SDIO interface. in btsdio_probe()
380 MODULE_DESCRIPTION("Generic Bluetooth SDIO driver ver " VERSION);
|
| D | btmrvl_drv.h | 3 * Marvell Bluetooth driver: global definitions & declarations
11 #include <net/bluetooth/bluetooth.h>
106 /* Vendor specific Bluetooth commands */
123 /* Vendor specific Bluetooth events */
130 /* Bluetooth Power States */
|
| D | hci_nokia.c | 3 * Bluetooth HCI UART H4 driver with Nokia Extensions AKA Nokia H4+
24 #include <net/bluetooth/bluetooth.h>
25 #include <net/bluetooth/hci_core.h>
307 * is disabled until bluetooth adapter is ready to avoid in nokia_send_negotiation()
341 dev_err(dev, "Unsupported bluetooth device!"); in nokia_setup_fw()
448 dev_dbg(dev, "bcm2048 has invalid bluetooth address!"); in nokia_setup()
722 btdev->wakeup_bt = devm_gpiod_get(dev, "bluetooth-wakeup", in nokia_bluetooth_serdev_probe()
752 dev_err(dev, "could not register bluetooth uart: %d", err); in nokia_bluetooth_serdev_probe()
790 { .compatible = "nokia,h4p-bluetooth", },
800 .name = "nokia-bluetooth",
[all …]
|
| /Linux-v6.6/net/bluetooth/ |
| D | Kconfig | 3 # Bluetooth subsystem configuration
7 tristate "Bluetooth subsystem support"
20 Bluetooth is low-cost, low-power, short-range wireless technology.
22 technologies like IrDA. Bluetooth operates in personal area range
24 Bluetooth can be found at <https://www.bluetooth.com/>.
26 Linux Bluetooth subsystem consist of several layers:
27 Bluetooth Core
35 BNEP Module (Bluetooth Network Encapsulation Protocol)
39 Say Y here to compile Bluetooth support into the kernel or say M to
40 compile it as module (bluetooth).
[all …]
|
| D | Makefile | 3 # Makefile for the Linux Bluetooth subsystem.
6 obj-$(CONFIG_BT) += bluetooth.o
15 bluetooth-y := af_bluetooth.o hci_core.o hci_conn.o hci_event.o mgmt.o \
20 bluetooth-$(CONFIG_DEV_COREDUMP) += coredump.o
22 bluetooth-$(CONFIG_BT_BREDR) += sco.o
23 bluetooth-$(CONFIG_BT_LE) += iso.o
24 bluetooth-$(CONFIG_BT_HS) += a2mp.o amp.o
25 bluetooth-$(CONFIG_BT_LEDS) += leds.o
26 bluetooth-$(CONFIG_BT_MSFTEXT) += msft.o
27 bluetooth-$(CONFIG_BT_AOSPEXT) += aosp.o
[all …]
|
| D | hci_sysfs.c | 2 /* Bluetooth HCI driver model support. */
6 #include <net/bluetooth/bluetooth.h>
7 #include <net/bluetooth/hci_core.h>
10 .name = "bluetooth",
|
| D | lib.c | 2 BlueZ - Bluetooth protocol stack for Linux
25 /* Bluetooth kernel library. */
27 #define pr_fmt(fmt) "Bluetooth: " fmt
31 #include <net/bluetooth/bluetooth.h>
44 /* Bluetooth error codes to Unix errno mapping */
138 /* Unix errno to Bluetooth error codes mapping */
|
| D | leds.c | 6 #include <net/bluetooth/bluetooth.h>
7 #include <net/bluetooth/hci_core.h>
94 led_trigger_register_simple("bluetooth-power", &bt_power_led_trigger); in bt_leds_init()
|
| /Linux-v6.6/Documentation/devicetree/bindings/net/bluetooth/ |
| D | brcm,bcm4377-bluetooth.yaml | 4 $id: http://devicetree.org/schemas/net/bluetooth/brcm,bcm4377-bluetooth.yaml#
7 title: Broadcom BCM4377 family PCIe Bluetooth Chips
13 This binding describes Broadcom BCM4377 family PCIe-attached bluetooth chips
18 - $ref: bluetooth-controller.yaml#
32 description: Board type of the Bluetooth chip. This is used to decouple
33 the overall system board from the Bluetooth module and used to construct
41 description: A per-device calibration blob for the Bluetooth radio. This
44 This blob is used if the chip stepping of the Bluetooth module does not
49 description: A per-device calibration blob for the Bluetooth radio. This
52 This blob is used if the chip stepping of the Bluetooth module supports
[all …]
|
| D | nxp,88w8987-bt.yaml | 4 $id: http://devicetree.org/schemas/net/bluetooth/nxp,88w8987-bt.yaml#
7 title: NXP Bluetooth chips
10 This binding describes UART-attached NXP bluetooth chips. These chips
11 are dual-radio chips supporting WiFi and Bluetooth. The bluetooth
42 bluetooth {
|
| D | bluetooth-controller.yaml | 4 $id: http://devicetree.org/schemas/net/bluetooth/bluetooth-controller.yaml#
7 title: Bluetooth Controller Common Properties
16 pattern: "^bluetooth(@.*)?$"
22 Specifies the BD address that was uniquely assigned to the Bluetooth
|
| D | qualcomm-bluetooth.yaml | 4 $id: http://devicetree.org/schemas/net/bluetooth/qualcomm-bluetooth.yaml#
7 title: Qualcomm Bluetooth Chips
14 This binding describes Qualcomm UART-attached bluetooth chips.
104 - $ref: bluetooth-controller.yaml#
189 bluetooth {
199 bluetooth {
212 bluetooth {
|
| /Linux-v6.6/Documentation/devicetree/bindings/net/ |
| D | nokia-bluetooth.txt | 1 Nokia Bluetooth Chips
4 Nokia phones often come with UART connected bluetooth chips from different
7 Bluetooth standard. In addition to the H4 protocol it specifies two more
13 - compatible: should contain "nokia,h4p-bluetooth" as well as one of the following:
15 * "ti,wl1271-bluetooth-nokia"
17 - bluetooth-wakeup-gpios: GPIO specifier, used to wakeup the BT module (active high)
41 bluetooth {
42 compatible = "ti,wl1271-bluetooth-nokia", "nokia,h4p-bluetooth";
46 bluetooth-wakeup-gpios = <&gpio2 5 GPIO_ACTIVE_HIGH>; /* gpio37 */
|
| D | mediatek-bluetooth.txt | 1 MediaTek SoC built-in Bluetooth Devices
11 "mediatek,mt7622-bluetooth": for MT7622 SoC
29 bluetooth {
30 compatible = "mediatek,mt7622-bluetooth";
37 MediaTek UART based Bluetooth Devices
50 "mediatek,mt7663u-bluetooth": for MT7663U device
51 "mediatek,mt7668u-bluetooth": for MT7668U device
107 bluetooth {
108 compatible = "mediatek,mt7663u-bluetooth";
|
| D | ti,bluetooth.yaml | 4 $id: http://devicetree.org/schemas/net/ti,bluetooth.yaml#
7 title: Texas Instruments Bluetooth Chips
14 attached TI Bluetooth devices. The following chips are included in this
17 * TI CC256x Bluetooth devices
20 TI WiLink devices have a UART interface for providing Bluetooth, FM radio,
84 bluetooth {
|
| D | marvell-bluetooth.yaml | 4 $id: http://devicetree.org/schemas/net/marvell-bluetooth.yaml#
7 title: Marvell Bluetooth chips
11 attached Marvell Bluetooth devices.
46 bluetooth {
|
| D | marvell-bt-8xxx.txt | 1 Marvell 8897/8997 (sd8897/sd8997) bluetooth devices (SDIO or USB based)
20 - marvell,wakeup-pin: It represents wakeup pin number of the bluetooth chip.
32 bluetooth chip can wakeup host platform under certain
53 btmrvl: bluetooth@2 {
|
| D | realtek-bluetooth.yaml | 4 $id: http://devicetree.org/schemas/net/realtek-bluetooth.yaml#
7 title: RTL8723BS/RTL8723CS/RTL8821CS/RTL8822CS Bluetooth
60 bluetooth {
|
| D | broadcom-bluetooth.yaml | 4 $id: http://devicetree.org/schemas/net/broadcom-bluetooth.yaml#
7 title: Broadcom Bluetooth Chips
13 This binding describes Broadcom UART-attached bluetooth chips.
149 bluetooth {
|
| /Linux-v6.6/drivers/platform/x86/ |
| D | toshiba_bluetooth.c | 3 * Toshiba Bluetooth Enable Driver
26 MODULE_DESCRIPTION("Toshiba Laptop ACPI Bluetooth Enable Driver");
78 pr_err("ACPI call to query Bluetooth presence failed\n"); in toshiba_bluetooth_present()
83 pr_info("Bluetooth device not present\n"); in toshiba_bluetooth_present()
97 pr_err("Could not get Bluetooth device status\n"); in toshiba_bluetooth_status()
110 pr_err("Could not attach USB Bluetooth device\n"); in toshiba_bluetooth_enable()
116 pr_err("Could not power ON Bluetooth device\n"); in toshiba_bluetooth_enable()
129 pr_err("Could not power OFF Bluetooth device\n"); in toshiba_bluetooth_disable()
135 pr_err("Could not detach USB Bluetooth device\n"); in toshiba_bluetooth_disable()
149 pr_err("Could not sync bluetooth device status\n"); in toshiba_bluetooth_sync_status()
[all …]
|
| /Linux-v6.6/arch/arm64/boot/dts/amlogic/ |
| D | meson-gxl-s905x-khadas-vim.dts | 196 "Bluetooth PCM DOUT", "Bluetooth PCM DIN",
197 "Bluetooth PCM SYNC", "Bluetooth PCM CLK",
198 "Bluetooth UART TX", "Bluetooth UART RX",
199 "Bluetooth UART CTS", "Bluetooth UART RTS",
200 "WIFI 32K", "Bluetooth Enable",
201 "Bluetooth WAKE HOST",
|
| D | meson-gxbb-nanopi-k2.dts | 283 "Bluetooth PCM DOUT", "Bluetooth PCM DIN",
284 "Bluetooth PCM SYNC", "Bluetooth PCM CLK",
285 "Bluetooth UART TX", "Bluetooth UART RX",
286 "Bluetooth UART CTS", "Bluetooth UART RTS",
287 "", "", "", "WIFI 32K", "Bluetooth Enable",
288 "Bluetooth WAKE HOST", "",
385 /* Bluetooth on AP6212 */
392 bluetooth {
|
| /Linux-v6.6/net/bluetooth/bnep/ |
| D | Kconfig | 7 BNEP (Bluetooth Network Encapsulation Protocol) is Ethernet
8 emulation layer on top of Bluetooth. BNEP is required for
9 Bluetooth PAN (Personal Area Network).
|
| /Linux-v6.6/Documentation/devicetree/bindings/soc/qcom/ |
| D | qcom,wcnss.yaml | 42 bluetooth:
46 - $ref: /schemas/net/bluetooth/bluetooth-controller.yaml#
117 bluetooth {
|
