Searched full:automatic (Results 1 – 25 of 760) sorted by relevance
12345678910>>...31
| /Linux-v5.10/include/uapi/linux/ |
| D | remoteproc_cdev.h | 21 * 0 : disable automatic shutdown
22 * other : enable automatic shutdown
27 * The RPROC_GET_SHUTDOWN_ON_RELEASE ioctl gets information about whether the automatic shutdown of
32 * 0 : automatic shutdown disable
33 * other : automatic shutdown enable
|
| /Linux-v5.10/Documentation/userspace-api/media/v4l/ |
| D | ext-ctrls-camera.rst | 29 Enables automatic adjustments of the exposure time and/or iris
41 - Automatic exposure time, automatic iris aperture.
64 Determines the automatic exposure compensation, it is effective only
152 Enables continuous automatic focus adjustments. The effect of manual
162 Aborts automatic focusing started with ``V4L2_CID_AUTO_FOCUS_START``
170 The automatic focus status. This is a read-only control.
183 - Automatic focus is not active.
185 - Automatic focusing is in progress.
189 - Automatic focus has failed, the driver will not transition from
211 - Normal distance range, limited for best automatic focus
[all …]
|
| D | ext-ctrls-rf-tuner.rst | 40 automatic mode bandwidth configuration is performed by the driver.
50 Enables/disables LNA automatic gain control (AGC)
53 Enables/disables mixer automatic gain control (AGC)
56 Enables/disables IF automatic gain control (AGC)
|
| D | control.rst | 109 Automatic white balance (cameras).
135 Automatic gain/exposure control.
163 Enables automatic hue control by the device. The effect of setting
164 ``V4L2_CID_HUE`` while automatic hue control is enabled is
183 Chroma automatic gain control.
252 Enable Automatic Brightness.
|
| /Linux-v5.10/Documentation/sound/designs/ |
| D | powersave.rst | 5 AC97 and HD-audio drivers have the automatic power-saving mode.
9 With the automatic power-saving, the driver turns off the codec power
15 The time-out for automatic power-off can be specified via ``power_save``
17 the time-out value in seconds. 0 means to disable the automatic
27 automatic power-save mode with 10 seconds, write to
|
| /Linux-v5.10/Documentation/hwmon/ |
| D | dell-smm-hwmon.rst | 38 pwm1_enable WO Enable or disable automatic BIOS fan
46 Disabling automatic BIOS fan control
53 There is experimental support for disabling automatic BIOS fan
56 (writing ``2`` enables automatic BIOS control again). Even if you have
58 automatic fan control at the same time and, notwithstanding the name,
59 ``pwm1_enable`` sets automatic control for all fans.
62 enabling and disabling automatic BIOS fan control are not whitelisted
|
| D | adt7470.rst | 40 automatic fan pwm control to set the fan speed. The driver will not read the
51 determining an optimal configuration for the automatic PWM control.
93 order for the automatic pwm algorithm to run. This was the case for earlier
|
| D | lm63.rst | 81 PWM modes: manual and automatic. Automatic mode is not fully implemented yet
87 but will return 'old' values. Values in the automatic fan control lookup table
|
| D | it87.rst | 303 The fan speed control features are limited to manual PWM mode. Automatic
315 Automatic fan speed control (old interface)
318 The driver supports the old interface to automatic fan speed control
332 the one of trip point N. The automatic control mode is less flexible
336 Trip points must be set properly before switching to automatic fan speed
338 actually switching to automatic control mode.
|
| D | max31785.rst | 58 2: Automatic PWM (tach-feedback RPM fan-control)
59 3: Automatic closed-loop (temp-feedback fan-control)
|
| /Linux-v5.10/drivers/watchdog/ |
| D | ibmasr.c | 2 * IBM Automatic Server Restart driver.
365 { "IBM Automatic Server Restart - eserver xSeries 220", ASMTYPE_TOPAZ },
366 { "IBM Automatic Server Restart - Machine Type 8673", ASMTYPE_PEARL },
367 { "IBM Automatic Server Restart - Machine Type 8480", ASMTYPE_JASPER },
368 { "IBM Automatic Server Restart - Machine Type 8482", ASMTYPE_JUNIPER },
369 { "IBM Automatic Server Restart - Machine Type 8648", ASMTYPE_SPRUCE },
420 MODULE_DESCRIPTION("IBM Automatic Server Restart driver");
|
| /Linux-v5.10/drivers/staging/unisys/Documentation/ABI/ |
| D | sysfs-platform-visorchipset | 8 s-Par's automatic installation progress screen when an error
17 Description: used to set the value of the progress bar on the s-Par automatic
27 s-Par's automatic installation progress screen. Setting this
|
| /Linux-v5.10/net/8021q/ |
| D | Kconfig | 28 automatic propagation of registered VLANs to switches.
38 automatic propagation of registered VLANs to switches; it
|
| /Linux-v5.10/sound/soc/ |
| D | soc-devres.c | 63 * Register a component with automatic unregistration when the device is
99 * Register a card with automatic unregistration when the device is
136 * Register a dmaengine based PCM device with automatic unregistration when the
|
| /Linux-v5.10/include/net/nfc/ |
| D | digital.h | 112 * @tg_listen_mdaa: If supported, put the device in automatic listen mode with
113 * mode detection and automatic anti-collision. In this mode, the device
121 * @tg_listen_md: If supported, put the device in automatic listen mode with
122 * mode detection but without automatic anti-collision. In this mode, the
|
| /Linux-v5.10/arch/arm/mach-omap2/ |
| D | clkt2xxx_dpll.c | 24 * Enable DPLL automatic idle control. The DPLL will enter low-power
41 * Disable DPLL automatic idle control. No return value.
|
| /Linux-v5.10/drivers/net/wireless/broadcom/b43legacy/ |
| D | phy.h | 27 B43legacy_ANTENNA_AUTO1, /* Automatic, starting with antenna 1 */
28 B43legacy_ANTENNA_AUTO0, /* Automatic, starting with antenna 0 */
114 #define B43legacy_PHY_ANTDWELL_AUTODIV1 0x0100 /* Automatic RX diversity start antenna */
130 #define B43legacy_PHY_ANTWRSETT_ARXDIV 0x2000 /* Automatic RX diversity enabled */
|
| /Linux-v5.10/security/ |
| D | inode.c | 100 * file is to be removed (no automatic cleanup happens if your module
193 * to be removed (no automatic cleanup happens if your module is unloaded,
221 * to be removed (no automatic cleanup happens if your module is unloaded,
253 * to be removed (no automatic cleanup happens if your module is unloaded,
292 * removed. No automatic cleanup of files will happen when a module is
|
| /Linux-v5.10/Documentation/devicetree/bindings/sound/ |
| D | cs35l33.txt | 76 automatic updating is enabled.
84 allowed to increase to a higher voltage when using VPhg automatic
89 - cirrus,vp-hg-va : VA calculation reference for automatic VPhg tracking
|
| /Linux-v5.10/drivers/net/wireless/intersil/orinoco/ |
| D | hw.h | 30 int orinoco_get_bitratemode(int bitrate, int automatic);
31 void orinoco_get_ratemode_cfg(int ratemode, int *bitrate, int *automatic);
|
| /Linux-v5.10/drivers/i2c/busses/ |
| D | i2c-img-scb.c | 29 * - Automatic mode. A bus address, and whether to read/write is
38 * Use of automatic mode and the FIFO can make much more efficient use
44 * the bus), MODE_ATOMIC must be used since automatic mode is normally
54 * received in automatic mode.
58 * not needed in automatic mode, becase those atomic mode commands are
65 * In this way normal automatic mode operation isn't impacted by
392 * To avoid slave event interrupts in automatic mode, use a timer to
545 /* Drain data from the FIFO into the buffer (automatic mode) */
566 /* Fill the FIFO with data from the buffer (automatic mode) */
587 /* Start a read transaction in automatic mode */
[all …]
|
| /Linux-v5.10/Documentation/driver-api/rapidio/ |
| D | rapidio.rst | 133 When automatic start of enumeration/discovery is used a user has to ensure
201 4.2 Automatic Start of Enumeration and Discovery
204 Automatic enumeration/discovery start method is applicable only to built-in
205 enumeration/discovery RapidIO configuration selection. To enable automatic
216 When automatic enumeration/discovery start is selected, basic method's
220 Depending on RapidIO network size and configuration this automatic
|
| /Linux-v5.10/Documentation/dev-tools/ |
| D | kmemleak.rst | 51 start the automatic memory scanning thread (default)
53 stop the automatic memory scanning thread
55 set the automatic memory scanning period in seconds
56 (default 600, 0 to stop the automatic scanning)
|
| /Linux-v5.10/Documentation/filesystems/ |
| D | automount-support.rst | 39 Automatic Mountpoint Expiry
42 Automatic expiration of mountpoints is easy, provided you've mounted the
|
| /Linux-v5.10/drivers/media/dvb-frontends/ |
| D | tda1004x.h | 23 TDA10046_AGC_IFO_AUTO_NEG, /* IF AGC only, automatic, negative */
24 TDA10046_AGC_IFO_AUTO_POS, /* IF AGC only, automatic, positive */
|
12345678910>>...31
