Searched full:assuming (Results 1 – 25 of 936) sorted by relevance
12345678910>>...38
| /Linux-v6.1/Documentation/firmware-guide/acpi/ |
| D | gpio-properties.rst | 75 assuming non-active (Polarity = !Pull Bias)
76 Down Low as low, assuming active
77 Down High as low, assuming non-active
78 Up Low as high, assuming non-active
79 Up High as high, assuming active
319 Be aware that gpiod_get_index() in cases 1 and 2, assuming that there
|
| /Linux-v6.1/include/linux/ |
| D | numa.h | 33 pr_info_once("Unknown online node for memory at 0x%llx, assuming node 0\n", in memory_add_physaddr_to_nid()
41 pr_info_once("Unknown target node for memory at 0x%llx, assuming node 0\n", in phys_to_target_node()
|
| D | amd-pstate.h | 36 * assuming ideal conditions
38 * assuming ideal operating conditions
|
| /Linux-v6.1/Documentation/networking/ |
| D | multiqueue.rst | 51 qdiscs. To add the MULTIQ qdisc to your network device, assuming the device
57 the device reports, and bring the qdisc online. Assuming eth0 has 4 Tx
69 skbedit, has been added. Assuming you wanted to route all traffic to a
|
| /Linux-v6.1/arch/alpha/kernel/ |
| D | irq_srm.c | 3 * Handle interrupts from the SRM, assuming no additional weirdness.
37 /* Handle interrupts from the SRM, assuming no additional weirdness. */
|
| /Linux-v6.1/Documentation/devicetree/bindings/rtc/ |
| D | ingenic,rtc.yaml | 54 (assuming RTC clock at 32 kHz)
62 (assuming RTC clock at 32 kHz)
|
| /Linux-v6.1/tools/testing/selftests/kvm/x86_64/ |
| D | kvm_clock_test.c | 148 pr_info("failed to open clocksource file: %d; assuming TSC.\n", in check_clocksource()
154 pr_info("failed to stat clocksource file: %d; assuming TSC.\n", in check_clocksource()
163 pr_info("failed to read clocksource file: %d; assuming TSC.\n", in check_clocksource()
|
| /Linux-v6.1/Documentation/admin-guide/ |
| D | sysfs-rules.rst | 128 Assuming ``/sys/class/<subsystem>`` and ``/sys/bus/<subsystem>``, or
135 at the same level, never in a hierarchy. Assuming the block subsystem to
146 path as an element. Assuming the existence of the "device"-link for
156 element. Assuming the existence of these links for devices which are
|
| /Linux-v6.1/sound/ |
| D | Kconfig | 81 # here assuming USB is defined before ALSA
87 # here assuming PCMCIA is defined before ALSA
|
| /Linux-v6.1/drivers/comedi/ |
| D | comedi_pcmcia.c | 18 * Assuming @dev->hw_dev is non-%NULL, it is assumed to be pointing to a
45 * Assuming @dev->hw_dev is non-%NULL, it is assumed to be pointing to a a
95 * Assuming @dev->hw_dev is non-%NULL, it is assumed to be pointing to a
|
| D | comedi_pci.c | 18 * Assuming @dev->hw_dev is non-%NULL, it is assumed to be pointing to a
34 * Assuming @dev->hw_dev is non-%NULL, it is assumed to be pointing to a
74 * Assuming @dev->hw_dev is non-%NULL, it is assumed to be pointing to a
|
| D | comedi_usb.c | 17 * Assuming @dev->hw_dev is non-%NULL, it is assumed to be pointing to a
33 * Assuming @dev->hw_dev is non-%NULL, it is assumed to be pointing to a
|
| /Linux-v6.1/Documentation/hwmon/ |
| D | ltc2990.rst | 55 curr1_input Current in mA across V1-V2 assuming a 1mOhm sense resistor
56 curr2_input Current in mA across V3-V4 assuming a 1mOhm sense resistor
|
| D | g760a.rst | 30 from the measured speed pulse period by assuming again a 32kHz clock
|
| /Linux-v6.1/drivers/input/misc/ |
| D | cma3000_d0x.c | 185 "Invalid G range specified, assuming 8G\n"); in cma3000_poweron()
313 "Invalid mode specified, assuming Motion Detect\n"); in cma3000_init()
319 "Invalid G range specified, assuming 8G\n"); in cma3000_init()
|
| /Linux-v6.1/include/vdso/ |
| D | jiffies.h | 8 /* TICK_NSEC is the time between ticks in nsec assuming SHIFTED_HZ */
|
| /Linux-v6.1/include/linux/sunrpc/ |
| D | msg_prot.h | 177 * Assuming big-endian ordering, h1, h2, h3, and h4, are respectively,
179 * Assuming big-endian ordering, p1 and p2 are, respectively, the first
|
| /Linux-v6.1/arch/arm/include/asm/ |
| D | kasan.h | 20 * The compiler uses a shadow offset assuming that addresses start
|
| /Linux-v6.1/include/linux/can/ |
| D | length.h | 80 * assuming CRC21, rounded up and ignoring bitstuffing
109 * assuming CRC21, rounded up and ignoring bitstuffing
|
| /Linux-v6.1/Documentation/gpu/rfc/ |
| D | i915_small_bar.h | 62 * small BAR configuration, assuming we are able to load
162 * possible to end up with a small BAR configuration, assuming we can
|
| /Linux-v6.1/arch/x86/include/asm/ |
| D | kasan.h | 10 * Compiler uses shadow offset assuming that addresses start
|
| /Linux-v6.1/arch/arm/mach-sa1100/include/mach/ |
| D | memory.h | 16 * our memory map representation. Assuming all memory nodes have equal access
|
| /Linux-v6.1/arch/powerpc/platforms/52xx/ |
| D | Kconfig | 15 supported assuming the following:
|
| /Linux-v6.1/Documentation/block/ |
| D | switching-sched.rst | 11 assuming that you have sysfs mounted on /sys. If you don't have sysfs mounted,
|
| /Linux-v6.1/tools/testing/selftests/powerpc/eeh/ |
| D | eeh-basic.sh | 11 # record the devices that we break in here. Assuming everything
|
12345678910>>...38
