Home
last modified time | relevance | path

Searched full:allows (Results 1 – 25 of 2863) sorted by relevance

12345678910>>...115

/Linux-v5.15/drivers/pinctrl/intel/
DKconfig24 allows configuring of SoC pins and using them as GPIOs.
36 provides an interface that allows configuring of PCH pins and
47 interface that allows configuring of SoC pins and using them as
63 This pinctrl driver provides an interface that allows configuring
71 Broxton pinctrl driver provides an interface that allows
79 This pinctrl driver provides an interface that allows configuring
87 This pinctrl driver provides an interface that allows configuring
95 This pinctrl driver provides an interface that allows configuring
103 This pinctrl driver provides an interface that allows configuring
111 This pinctrl driver provides an interface that allows configuring
[all …]
/Linux-v5.15/drivers/leds/trigger/
DKconfig15 This allows LEDs to be controlled by a programmable timer
25 This allows LEDs to blink in one-shot pulses with parameters
39 This allows LEDs to be controlled by disk activity.
46 This allows LEDs to be controlled by MTD activity.
52 This allows LEDs to be controlled by a CPU load average.
60 This allows LEDs to be controlled as a backlight device: they
68 This allows LEDs to be controlled by active CPUs. This shows
77 This allows LEDs to be controlled by an immediate CPU usage.
86 This allows LEDs to be controlled by gpio events. It's good
97 This allows LEDs to be initialised in the ON state.
[all …]
/Linux-v5.15/net/netfilter/
DKconfig10 This allows you to classify packets from ingress using the Netfilter
159 extension. This allows you to attach timeout policies to flow
169 This allows you to store the flow start-time and to obtain
225 machine, then you may want to enable this feature. This allows the
385 fine-grain tuning. This allows you to attach specific timeout
417 The NAT option allows masquerading, port forwarding and other
468 allows you to construct mappings between matchings and actions
570 This option adds the "objref" expression that allows you to refer to
623 This option allows using the FIB expression from the inet table.
640 This option allows matching for the presence or absence of a
[all …]
/Linux-v5.15/net/bridge/netfilter/
DKconfig96 This option adds the among match, which allows matching the MAC source
105 This option adds the ARP match, which allows ARP and RARP header field
113 This option adds the IP match, which allows basic IP header field
122 This option adds the IP6 match, which allows basic IPV6 header field
130 This option adds the limit match, which allows you to control
140 This option adds the mark match, which allows matching frames based on
150 This option adds the packet type match, which allows matching on the
161 allows STP header field filtering.
168 This option adds the 802.1Q vlan match, which allows the filtering of
179 This option adds the arp reply target, which allows
[all …]
/Linux-v5.15/net/ipv6/netfilter/
DKconfig44 It also allows query of the FIB for the route type, e.g. local, unicast,
97 This module allows one to match AH packets.
115 frag matching allows you to match packets based on the fragmentation
124 This allows one to match packets based on the hop-by-hop
142 This module allows one to match packets based upon
151 This module allows one to match MH packets.
160 This option allows you to match packets whose replies would
170 rt matching allows you to match packets based on the routing
179 srh matching allows you to match packets based on the segment
210 The REJECT target allows a filtering rule to specify that an ICMPv6
[all …]
/Linux-v5.15/Documentation/devicetree/bindings/input/touchscreen/
Dhycon,hy46xx.yaml50 description: Allows setting the sensitivity in the range from 0 to 255.
57 description: Allows enabling glove setting.
60 description: Allows setting the report speed in Hertz.
66 description: Allows enabling power noise filter.
69 description: Allows setting how many samples throw before reporting touch
76 description: Allows setting the sensitivity distance in the range from 0 to 5.
82 description: Allows setting the edge compensation in the range from 0 to 16.
/Linux-v5.15/Documentation/virt/kvm/devices/
Dvm.rst49 Allows userspace to query the actual limit and set a new limit for
63 Allows user space to retrieve machine and kvm specific cpu related information::
82 Allows user space to retrieve or request to change cpu related information for a vcpu::
109 Allows user space to retrieve available cpu features. A feature is available if
126 Allows user space to retrieve or change enabled cpu features for all VCPUs of a
143 Allows user space to retrieve available cpu subfunctions without any filtering
182 Allows user space to retrieve or change cpu subfunctions to be indicated for
212 Allows user space to set/get the TOD clock extension (u8) (superseded by
222 Allows user space to set/get bits 0-63 of the TOD clock register as defined in
231 Allows user space to set/get bits 0-63 of the TOD clock register as defined in
[all …]
/Linux-v5.15/Documentation/input/devices/
Dedt-ft5x06.rst15 The driver allows configuration of the touch screen via a set of sysfs files:
18 allows setting the "click"-threshold in the range from 0 to 80.
21 allows setting the sensitivity in the range from 0 to 31. Note that
25 allows setting the edge compensation in the range from 0 to 31.
28 allows setting the report rate in the range from 3 to 14.
40 allows switching the sensor between "factory mode" and "operation
/Linux-v5.15/drivers/xen/
DKconfig9 The balloon driver allows the Xen domain to request more memory from
18 Memory hotplug support for Xen balloon driver allows expanding memory
87 The evtchn driver allows a userspace process to trigger event
142 Allows userspace processes to use grants.
149 Allows userspace processes and kernel modules to use Xen backed
160 Allows userspace processes to create pages with access granted
190 The PCI device backend driver allows the kernel to export arbitrary
195 The parameter "passthrough" allows you specify how you want the PCI
201 into the kernel) allows you to bind the PCI devices to this module
223 allows PV Calls frontends to send POSIX calls to the backend,
[all …]
/Linux-v5.15/drivers/nvme/target/
DKconfig11 it allows the Linux kernel to implement NVMe subsystems and
25 NVMe Over Fabrics protocol. It allows for hosts to manage and
48 This enables the NVMe RDMA target support, which allows exporting NVMe
59 This enables the NVMe FC target support, which allows exporting NVMe
82 This enables the NVMe TCP target support, which allows exporting NVMe
/Linux-v5.15/net/ipv4/netfilter/
DKconfig48 It also allows query of the FIB for the route type, e.g. local, unicast,
106 SNMP payloads. In conjunction with NAT, it allows a network
146 This match extension allows you to match a range of SPIs
165 This option allows you to match packets whose replies would
197 The REJECT target allows a filtering rule to specify that an ICMP
209 The SYNPROXY target allows you to intercept TCP connections and
211 server. This allows to avoid conntrack and server resource usage
224 This enables the `nat' table in iptables. This allows masquerading,
278 The CLUSTERIP target allows you to build load-balancing clusters of
360 Allows altering the ARP packet payload: source and destination
/Linux-v5.15/arch/mips/sgi-ip27/
DKconfig11 in either N-Modes which allows for more nodes or M-Mode which allows
19 in either N-Modes which allows for more nodes or M-Mode which allows
/Linux-v5.15/Documentation/virt/
Dparavirt_ops.rst11 hypervisors. It allows each hypervisor to override critical operations and
12 allows a single kernel binary to run on all supported execution environments
17 functionalities in various areas. pv-ops allows for optimizations at run
27 - indirect call which allows optimization with binary patch
/Linux-v5.15/fs/fuse/
DKconfig25 This FUSE extension allows character devices to be
36 The Virtio Filesystem allows guests to mount file systems from the
50 This allows bypassing guest page cache and allows mapping host page
/Linux-v5.15/Documentation/bpf/
Dringbuf.rst86 - ``bpf_ringbuf_output()`` allows to *copy* data from one place to a ring
97 because record has to be prepared in some other place first. But it allows to
104 than BPF stack space allows, so many programs have use extra per-CPU array as
106 completely. But in exchange, it only allows a known constant size of memory to
122 ``bpf_ringbuf_query()`` helper allows to query various properties of ring
138 helpers, it allows BPF program a high degree of control and, e.g., more
146 This reserve/commit schema allows a natural way for multiple producers, either
172 allows ``bpf_ringbuf_commit()``/``bpf_ringbuf_discard()`` to accept only the
188 allows to not take any special measures for samples that have to wrap around
201 this allows to achieve a very high throughput without having to resort to
/Linux-v5.15/drivers/infiniband/
DKconfig23 is the kernel side of the userspace MAD support, which allows
34 communication manager (CM). This allows userspace processes
56 Together with driver support this allows registration of
66 This allows for a generic connection abstraction over RDMA.
74 This allows the user to config the default GID type that the CM
/Linux-v5.15/drivers/char/mwave/
DREADME19 thinkpad configuration utility then this parameter allows the
24 thinkpad configuration utility then this parameter allows the
29 thinkpad configuration utility then this parameter allows the
34 thinkpad configuration utility then this parameter allows the
/Linux-v5.15/kernel/
DKconfig.preempt30 This allows reaction to interactive events by allowing a
32 is in kernel mode executing a system call. This allows
47 preemptible. This allows reaction to interactive events by
51 This allows applications to run more 'smoothly' even when the
88 This option allows to define the preemption model on the kernel
/Linux-v5.15/mm/
DKconfig15 This option allows you to change some of the ways that
43 holes is their physical address space and allows memory
229 Free page reporting allows for the incremental acquisition of
242 Allows the migration of the physical location of pages of processes
258 Allows the pageblock_order value to be dynamic instead of just standard
335 with MCA recovery. This allows a system to continue running
378 Transparent Hugepages allows the kernel to use huge pages and
476 This enables the Contiguous Memory Allocator which allows other
478 CMA reserves a region of memory and allows only movable pages to
513 CMA allows to create CMA areas for particular purpose, mainly,
[all …]
/Linux-v5.15/arch/nios2/
DKconfig130 This option allows you to set the link address offset of the zImage.
148 This option allows you to set the virtual address of the kernel MMU region.
156 This option allows you to set the virtual base address of the kernel MMU region.
162 This option allows you to set the virtual address of the kernel region.
174 This option allows you to set the virtual address of the I/O region.
/Linux-v5.15/include/trace/events/
Dio_uring.h21 * Allows to trace io_uring creation and provide pointer to a context, that can
62 * Allows to trace fixed files/buffers/eventfds, that could be registered to
104 * Allows to trace out how often an SQE file reference is obtained, which can
135 * Allows to trace asynchronous work submission.
172 * Allows to track deferred requests, to get an insight about what requests are
205 * Allows to track linked requests, to understand dependencies between requests
236 * Allows to track waiting for CQE, so that we can e.g. troubleshoot
265 * Allows to track linked requests cancellation, to see not only that some work
332 * Allows to track SQE submitting, to understand what was the source of it, SQ
378 * Allows to track which fds are waiting for and what are the events of
[all …]
/Linux-v5.15/arch/um/drivers/
DKconfig14 The User-Mode Linux environment allows you to create virtual serial
153 The Ethertap User-Mode Linux network transport allows a single
179 The UML TUN/TAP network transport allows a UML instance to exchange
196 The slip User-Mode Linux network transport allows a running UML to
217 This User-Mode Linux network transport allows one or more running
251 This User-Mode Linux network transport allows one or more running
275 This Multicast User-Mode Linux network transport allows multiple
317 The SLiRP User-Mode Linux network transport allows a running UML
323 frames. In general, slirp allows the UML the same IP connectivity
/Linux-v5.15/Documentation/ABI/testing/
Dsysfs-class-chromeos-driver-cros-ec-lightbar30 This allows you to control each LED segment. If the
49 This allows you to upload and run custom lightbar sequences.
59 displaying. Writing to this file allows you to change the
66 This allows you to take the control of the lightbar. This
Dsysfs-platform-dell-laptop7 This file allows to control the automatic keyboard
18 This file allows to specifiy the on/off threshold value,
27 This file allows to control the input triggers that
53 This file allows to specify the interval after which the
/Linux-v5.15/drivers/crypto/marvell/
DKconfig18 This driver allows you to utilize the Cryptographic Engines and
33 This driver allows you to utilize the Marvell Cryptographic
51 This driver allows you to utilize the Marvell Cryptographic

12345678910>>...115