Searched full:achieved (Results 1 – 25 of 216) sorted by relevance
123456789
230 or 0 if completion was achieved. There is a _timeout variant as well::247 achieved calls complete() to signal exactly one of the waiters that it can257 a thread starts waiting. This is achieved by the waiter "consuming"
16 modules. This is achieved by adding multi-led nodes layer to the
37 due to the PWM specificity, where lower brightness is achieved
32 This is the lowest possible system power state, achieved only when CPU is in
7 communication is achieved through a set of registers for message storage and18 is achieved through the appropriate programming of the rx and tx interrupt
23 * L1 I$ fetch block boundary which can be achieved by using
37 * the same can be achieved by means of CMD_START_MEAS which takes
21 API. Cropping a smaller image from a larger one is achieved by setting
12 However, a similar kind of flexibility can be achieved by using VRFs and
21 * GOT references). This is achieved by defining STATIC_RW_DATA to
14 Thermal management is achieved in devicetree by describing the sensor hardware
36 description: minimum pressure on the touchscreen to be achieved in order
53 better behavior with mplayer can be achieved by setting to a higher
52 achieved by adding an alias to the CAM. There is no way to disable
16 # achieved by piping to sort -k5,5g.
62 achieved by the scope API.
34 Maximal throughput with minimal bus load will usually be achieved in the
15 order to control their power supplies. This mapping can be achieved in machine
81 * @framerate: framerate achieved with the corresponding blanking intervals,
49 …ng of 100% would indicate the maximum 4 uops retired per cycle has been achieved. Maximizing Reti…56 …ng of 100% would indicate the maximum 4 uops retired per cycle has been achieved. Maximizing Reti…
11 * better performance can be achieved by making the scheduler prefer
40 * Strangely enough, best performance is achieved in mc_copy_user_page()
88 * achieved if the switch that connects the cluster nodes support some in xt_cluster_mt()
