Searched full:accepts (Results 1 – 25 of 332) sorted by relevance
12345678910>>...14
| /Linux-v6.6/Documentation/devicetree/bindings/phy/ |
| D | qcom,usb-snps-femto-v2.yaml | 69 The hardware accepts only discrete values. The value closest to the
78 The hardware accepts only discrete values. The value closest to the
86 The hardware accepts only discrete values. The value closest to the
98 The hardware accepts only discrete values. The value closest to the
110 The hardware accepts only discrete values. The value closest to the
118 The hardware accepts only discrete values. The value closest to the
127 The hardware accepts only discrete values. The value closest to the
137 resistance on the USB. The hardware accepts only discrete values. The
148 The hardware accepts only discrete values. The value closest to the
|
| /Linux-v6.6/include/uapi/linux/usb/ |
| D | raw_gadget.h | 102 /* Used as addr in struct usb_raw_ep_info if endpoint accepts any address. */
156 * Accepts a pointer to the usb_raw_init struct as an argument.
170 * Accepts a pointer to the usb_raw_event struct.
179 * Accepts a pointer to the usb_raw_ep_io struct as an argument.
189 * Accepts a pointer to the usb_raw_ep_descs struct as an argument.
196 * Accepts endpoint handle as an argument.
206 * Accepts a pointer to the usb_raw_ep_io struct as an argument.
221 * Accepts current limit in 2 mA units as an argument.
242 * Accepts endpoint handle as an argument.
|
| /Linux-v6.6/arch/m68k/include/asm/ |
| D | macintosh.h | 81 #define MAC_EXP_PDS 1 /* Accepts only a PDS card */
82 #define MAC_EXP_NUBUS 2 /* Accepts only NuBus card(s) */
83 #define MAC_EXP_PDS_NUBUS 3 /* Accepts PDS card and/or NuBus card(s) */
84 #define MAC_EXP_PDS_COMM 4 /* Accepts PDS card or Comm Slot card */
|
| /Linux-v6.6/Documentation/core-api/irq/ |
| D | irq-domain.rst | 52 by calling irq_create_mapping() which accepts the irq_domain and a
110 accepts an Open Firmware specific 'struct device_node', while the latter
111 accepts a more general abstraction 'struct fwnode_handle'.
134 accepts an Open Firmware specific 'struct device_node', while the latter
135 accepts a more general abstraction 'struct fwnode_handle'.
212 accepts an Open Firmware specific 'struct device_node', while the latter
213 accepts a more general abstraction 'struct fwnode_handle'.
|
| /Linux-v6.6/drivers/scsi/bfa/ |
| D | bfa_defs_fcs.h | 38 u32 flogi_accepts; /* FLOGI accepts received */
280 u32 fdisc_accepts; /* fdisc accepts */
284 u32 fdisc_acc_bad; /* bad fdisc accepts */
294 u32 logo_accepts; /* logo accepts */
357 u32 plogi_accs; /* plogi accepts */
370 u32 logo_accs; /* LOGO accepts from rport */
451 u32 prli_rsp_acc; /* num prli rsp accepts */
|
| /Linux-v6.6/drivers/net/ethernet/cavium/thunder/ |
| D | nicvf_queues.h | 99 * HW accepts pkt if unused CQE >= 2560
100 * RED accepts pkt if unused CQE < 2304 & >= 2560
109 * HW accepts pkt if unused RBs >= 256
110 * RED accepts pkt if unused RBs < 256 & >= 0
|
| /Linux-v6.6/Documentation/ABI/testing/ |
| D | sysfs-driver-toshiba_acpi | 13 Note that from kernel 3.16 onwards this file accepts all listed
14 parameters, kernel 3.15 only accepts the first two (FN-Z and
91 Note that from kernel 4.1 onwards this file accepts all listed
|
| D | sysfs-bus-coresight-devices-tpdm | 11 Accepts only one of the 2 values - 1 or 2.
|
| D | sysfs-driver-hid-picolcd | 36 Writing: accepts new refresh rate expressed in integer Hz
|
| /Linux-v6.6/net/ax25/ |
| D | Kconfig | 57 networking. A DAMA server (called "master") accepts incoming traffic
72 networking. A DAMA server (called "master") accepts incoming traffic
|
| /Linux-v6.6/Documentation/admin-guide/ |
| D | pstore-blk.rst | 48 When pstore/blk is built as a module, "blkdev" accepts the following variants:
56 When pstore/blk is built into the kernel, "blkdev" accepts the following variants:
70 It accepts the following variants for MTD device:
|
| /Linux-v6.6/drivers/hwmon/ |
| D | g762.c | 269 /* Set pwm mode. Accepts either 0 (PWM mode) or 1 (DC mode) */
299 /* Set fan clock divisor. Accepts either 1, 2, 4 or 8. */
339 /* Set fan gear mode. Accepts either 0, 1 or 2. */
375 /* Set number of fan pulses per revolution. Accepts either 2 or 4. */
405 /* Set fan mode. Accepts either 1 (open-loop) or 2 (closed-loop). */
446 /* Set PWM polarity. Accepts either 0 (positive duty) or 1 (negative duty) */
477 * Set pwm value. Accepts values between 0 (stops the fan) and
|
| /Linux-v6.6/drivers/firmware/efi/libstub/ |
| D | unaccepted_memory.c | 92 * 1. Accepts the memory immediately and in its entirety
93 * 2. Accepts unaligned parts, and marks *some* aligned part unaccepted
|
| /Linux-v6.6/Documentation/arch/arm/sa1100/ |
| D | lart.rst | 8 through a number of connectors. The powersupply accepts voltages
|
| /Linux-v6.6/Documentation/userspace-api/media/drivers/ |
| D | omap3isp-uapi.rst | 85 control. VIDIOC_OMAP3ISP_CCDC_CFG IOCTL accepts a pointer to struct
87 accepts a pointer to struct omap3isp_prev_update_config. The definition of
|
| /Linux-v6.6/Documentation/admin-guide/mm/ |
| D | multigen_lru.rst | 27 ``enabled`` accepts different values to enable or disable the
86 ``/sys/kernel/debug/lru_gen`` accepts commands described in the
|
| /Linux-v6.6/scripts/ |
| D | Makefile.kcsan | 3 # because Clang accepts "--param" even if it is unused.
|
| /Linux-v6.6/include/media/i2c/ |
| D | tvaudio.h | 29 /* The tvaudio module accepts the following inputs: */
|
| /Linux-v6.6/include/target/iscsi/ |
| D | iscsi_target_stat.h | 49 u32 accepts; member
|
| /Linux-v6.6/tools/testing/selftests/ftrace/test.d/ftrace/ |
| D | func-filter-glob.tc | 36 if grep -q 'accepts: .* glob-matching-pattern' README ; then
|
| /Linux-v6.6/Documentation/devicetree/bindings/clock/ |
| D | qcom,rpmhcc.yaml | 14 some Qualcomm Technologies Inc. SoCs. It accepts clock requests from
|
| /Linux-v6.6/arch/x86/coco/tdx/ |
| D | tdx-shared.c | 55 * Try larger accepts first. It gives chance to VMM to keep in tdx_accept_memory()
|
| /Linux-v6.6/Documentation/kbuild/ |
| D | kconfig-macro-language.rst | 109 The "shell" function accepts a single argument that is expanded and passed
191 accepts only one. To pass commas in arguments, you can use the following trick::
|
| /Linux-v6.6/arch/x86/events/ |
| D | probe.c | 14 * Accepts msr[] array with non populated entries as long as either
|
| /Linux-v6.6/tools/usb/usbip/doc/ |
| D | usbipd.8 | 16 The daemon accepts connections from USB/IP clients
|
12345678910>>...14
