Searched full:absent (Results 1 – 25 of 243) sorted by relevance
12345678910
/Linux-v6.1/Documentation/devicetree/bindings/net/ |
D | ibm,emac.txt | 65 - phy-address : 1 cell, optional, MDIO address of the PHY. If absent, 68 for, used if phy-address is absent. bit 0x00000001 is 70 For Axon it can be absent, though my current driver 77 operations (if absent the value is the same as 78 rx-fifo-size). For Axon, either absent or 2048. 80 operations (if absent the value is the same as 81 tx-fifo-size). For Axon, either absent or 2048.
|
D | lpc-eth.txt | 10 absent, "rmii" is assumed.
|
D | davinci_emac.txt | 22 If absent, davinci_emac driver defaults to 100/FULL.
|
/Linux-v6.1/Documentation/devicetree/bindings/powerpc/opal/ |
D | power-mgt.txt | 69 property. If the property is absent, the target residency for 76 This property is required on POWER9 and absent on POWER8. 82 required on POWER9 and absent on POWER8. 111 is an optional property on POWER8 and is absent on 118 property on POWER8 and is absent on POWER9.
|
/Linux-v6.1/Documentation/devicetree/bindings/sound/ |
D | alc5623.txt | 11 Register. If absent or has the value of 0, the 15 Control Register. If absent or has value 0, the
|
D | wlf,wm8962.yaml | 62 If absent, the default should be the register default. 69 A list of GPIO configuration register values. If absent, no
|
D | wm8994.txt | 44 - wlf,gpio-cfg : A list of GPIO configuration register values. If absent, 50 WM8958. If absent the register defaults will be used.
|
D | fsl,sai.yaml | 83 first for the fifo data. If this property is absent, 105 If both fsl,sai-asynchronous and fsl,sai-synchronous-rx are absent, the
|
D | wm8741.txt | 16 DIFF in register R8 (MODE_CONTROL_2). If absent, the default is 0, shall be:
|
D | tdm-slot.txt | 18 to specify an explicit mapping of the channels and the slots. If it's absent
|
D | pcm512x.txt | 20 is absent the device will be configured to clock from BCLK. If pll-in
|
/Linux-v6.1/arch/arc/include/asm/ |
D | asserts.h | 17 * - panic in case of OPT enabled but corresponding HW absent. 27 * - panic in case of OPT enabled but corresponding HW absent.
|
/Linux-v6.1/Documentation/devicetree/bindings/arm/ |
D | l2c2x0.yaml | 186 (forcibly enable), property absent (retain settings set by firmware) 193 <1> (forcibly enable), property absent (retain settings set by 201 disable), <1> (forcibly enable), property absent (OS specific behavior, 208 <1> (forcibly enable), property absent (OS specific behavior,
|
/Linux-v6.1/Documentation/ABI/testing/ |
D | sysfs-class-mtd | 107 absent, ram, rom, nor, nand, mlc-nand, dataflash, ubi, unknown 145 or exceeds this value, -EUCLEAN is returned. Otherwise, absent 170 returned, absent a hard error. 233 This attribute is absent on flash devices, so it can be used
|
/Linux-v6.1/Documentation/devicetree/bindings/bus/ |
D | simple-pm-bus.yaml | 46 # Required if power-domains is absent, optional otherwise 49 # Required if clocks is absent, optional otherwise
|
/Linux-v6.1/drivers/mtd/chips/ |
D | map_absent.c | 3 * Common code to handle absent "placeholder" devices 113 MODULE_DESCRIPTION("Placeholder MTD chip driver for 'absent' chips");
|
/Linux-v6.1/Documentation/driver-api/ |
D | slimbus.rst | 84 Similarly, SLIMbus devices 'report absent' when they go down. A 'device_down' 85 callback notifies the driver when the device reports absent and its logical
|
/Linux-v6.1/include/uapi/linux/ |
D | atmsap.h | 109 /* absent */ 118 /* absent */
|
/Linux-v6.1/include/linux/ |
D | slimbus.h | 31 * @SLIM_DEVICE_STATUS_DOWN: Slim device is absent or not reported yet. 79 * - The device reports absent, or the bus goes down.
|
/Linux-v6.1/Documentation/devicetree/bindings/spi/ |
D | spi-bcm63xx-hsspi.txt | 14 if absent.
|
D | spi-bcm63xx.txt | 14 if absent.
|
/Linux-v6.1/Documentation/devicetree/bindings/display/ |
D | multi-inno,mi0283qt.txt | 13 - absent: IM=x101 3-wire 9-bit data serial interface
|
/Linux-v6.1/Documentation/devicetree/bindings/gpio/ |
D | gpio_atmel.txt | 17 - #gpio-lines: Number of gpio if absent 32.
|
/Linux-v6.1/Documentation/devicetree/bindings/display/panel/ |
D | panel-edp.yaml | 99 hpd-absent-delay-ms: 106 and hpd-absent-delay was 200 ms then we'd do a fixed 80 ms delay and
|
/Linux-v6.1/drivers/media/usb/pwc/ |
D | pwc-timon.h | 26 will be chosen (unless the decompressor is absent). Sometimes there are only
|
12345678910