| /Linux-v6.1/Documentation/devicetree/bindings/hwmon/ |
| D | ntc-thermistor.yaml | 3 $id: http://devicetree.org/schemas/hwmon/ntc-thermistor.yaml#
6 title: NTC thermistor temperature sensors
20 When used in practice, a thermistor is often connected between ground, a
34 |/| Thermistor | Measured voltage (mv)
48 The arrangements of where we measure the voltage over the thermistor are
52 If the pull-up resistance is 0 one end of the thermistor is connected to the
53 positive voltage and we get the thermistor on top of a pull-down resistor
54 and we take the measure between the thermistor and the pull-down resistor.
56 Conversely if the pull-down resistance is zero, one end of the thermistor is
57 connected to ground and we get the thermistor under the pull-up resistor
[all …]
|
| /Linux-v6.1/Documentation/devicetree/bindings/iio/temperature/ |
| D | adi,ltc2983.yaml | 257 "^thermistor@":
260 Represents a thermistor sensor which is connected to one of the device
266 19 - Thermistor 44004/44033 2.252kohm at 25°C
267 20 - Thermistor 44005/44030 3kohm at 25°C
268 21 - Thermistor 44007/44034 5kohm at 25°C
269 22 - Thermistor 44006/44031 10kohm at 25°C
270 23 - Thermistor 44008/44032 30kohm at 25°C
271 24 - Thermistor YSI 400 2.252kohm at 25°C
272 25 - Thermistor Spectrum 1003k 1kohm
273 26 - Thermistor Custom Steinhart-Hart
[all …]
|
| /Linux-v6.1/arch/arm64/boot/dts/qcom/ |
| D | sc7180-trogdor-coachz-r1.dts | 18 * CoachZ rev1 is stuffed with a 47k NTC as charger thermistor which currently
27 /delete-node/ skin-temp-thermistor@4e;
28 /delete-node/ charger-thermistor@4f;
34 /delete-node/ charger-thermistor@0;
35 /delete-node/ skin-temp-thermistor@1;
39 * CoachZ rev1 is stuffed with a 47k NTC as thermistor for skin temperature,
|
| D | sc7180-trogdor-pompom-r2.dts | 18 * Pompom rev2 is stuffed with a 47k NTC as charger thermistor which currently
27 /delete-node/ charger-thermistor@4f;
31 /delete-node/ charger-thermistor@0;
|
| D | sc7180-trogdor-pompom-r1.dts | 21 * Pompom rev1 is stuffed with a 47k NTC as charger thermistor which currently
30 /delete-node/ charger-thermistor@4f;
34 /delete-node/ charger-thermistor@0;
|
| D | sc7180-trogdor-lazor.dtsi | 25 * Lazor is stuffed with a 47k NTC as charger thermistor which currently is
58 /delete-node/ charger-thermistor@4f;
64 /delete-node/ charger-thermistor@0;
|
| D | sc7180-trogdor-coachz.dtsi | 122 skin-temp-thermistor@4e {
132 skin-temp-thermistor@1 {
|
| D | sc7180-trogdor-homestar.dtsi | 130 skin-temp-thermistor@4d {
140 skin-temp-thermistor@1 {
|
| D | sc7180-trogdor-pompom.dtsi | 151 5v-choke-thermistor@4e {
161 5v-choke-thermistor@1 {
|
| D | sc7180-trogdor-wormdingler.dtsi | 171 skin-temp-thermistor@4d {
181 skin-temp-thermistor@1 {
|
| D | sdm845-mtp.dts | 581 xo-thermistor@1 {
588 msm-thermistor@2 {
595 pa-thermistor@3 {
602 quiet-thermistor@4 {
|
| /Linux-v6.1/Documentation/hwmon/ |
| D | ntc_thermistor.rst | 32 The NTC (Negative Temperature Coefficient) thermistor is a simple thermistor
42 [TH] the thermistor
103 name the mandatory global attribute, the thermistor name.
105 temp1_type RO always 4 (thermistor)
111 Note that each NTC thermistor has only _one_ thermistor; thus, only temp1 exists.
|
| D | w83781d.rst | 142 TN3904 transistor, and 3435 the default thermistor value. Other values
197 - Problems with diode/thermistor settings (supported?)
246 > reprogramming the R-T table if the Beta of the thermistor is not
252 confidential. If you have another Beta value of thermistor, we can help
254 Table which can be gotten by thermistor vendor. Therefore we will calculate
260 > programmable to be either thermistor or Pentium II diode inputs.
269 thermistor 0 0 0
|
| D | mc13783-adc.rst | 53 5 General Purpose ADIN5 / Battery Pack Thermistor 0 - 2.30V No
80 5 General Purpose ADIN5 / Battery Pack Thermistor 0 - 2.4V No
|
| D | vt1211.rst | 70 UCH1/Reading2 in0 temp3 NTC type thermistor
154 pin (Vpin) is formed by a voltage divider made of the thermistor (Rth) and a
159 The equation for the thermistor is as follows (google it if you want to know
|
| D | wm831x.rst | 40 thermistor component.
|
| /Linux-v6.1/drivers/iio/temperature/ |
| D | ltc2983.c | 116 /* cold junction for thermocouples and rsense for rtd's and thermistor's */
554 struct ltc2983_thermistor *thermistor = to_thermistor(sensor); in ltc2983_thermistor_assign_chan() local
557 chan_val = LTC2983_CHAN_ASSIGN(thermistor->r_sense_chan); in ltc2983_thermistor_assign_chan()
558 chan_val |= LTC2983_THERMISTOR_CFG(thermistor->sensor_config); in ltc2983_thermistor_assign_chan()
560 LTC2983_THERMISTOR_EXC_CURRENT(thermistor->excitation_current); in ltc2983_thermistor_assign_chan()
562 if (thermistor->custom) { in ltc2983_thermistor_assign_chan()
566 thermistor->custom, in ltc2983_thermistor_assign_chan()
877 struct ltc2983_thermistor *thermistor; in ltc2983_thermistor_new() local
883 thermistor = devm_kzalloc(dev, sizeof(*thermistor), GFP_KERNEL); in ltc2983_thermistor_new()
884 if (!thermistor) in ltc2983_thermistor_new()
[all …]
|
| /Linux-v6.1/Documentation/devicetree/bindings/power/supply/ |
| D | stericsson,ab8500-battery.txt | 7 thermistor-on-batctrl:
8 A boolean value indicating thermistor interface to battery
18 thermistor-on-batctrl;
|
| /Linux-v6.1/Documentation/devicetree/bindings/iio/adc/ |
| D | adi,ad7280a.yaml | 47 adi,thermistor-termination:
50 Enable the thermistor termination function.
73 adi,thermistor-termination;
|
| D | samsung,exynos-adc.yaml | 138 /* NTC thermistor is a hwmon device */
139 thermistor {
|
| D | qcom,spmi-rradc.yaml | 15 the battery thermistor die temperature, charger temperature, USB and DC input
|
| /Linux-v6.1/drivers/hwmon/ |
| D | nct6683.c | 201 "Thermistor 14",
202 "Thermistor 15",
203 "Thermistor 16",
204 "Thermistor 0",
205 "Thermistor 1",
206 "Thermistor 2",
207 "Thermistor 3",
208 "Thermistor 4",
209 "Thermistor 5", /* 0x10 */
210 "Thermistor 6",
[all …]
|
| D | ntc_thermistor.c | 332 * thermistor is using for conversion of the analog values.
651 dev_info(dev, "Thermistor type: %s successfully probed.\n", in ntc_thermistor_probe()
696 .name = "ntc-thermistor",
705 MODULE_DESCRIPTION("NTC Thermistor Driver");
708 MODULE_ALIAS("platform:ntc-thermistor");
|
| /Linux-v6.1/include/linux/iio/adc/ |
| D | qcom-vadc-common.h | 90 * SCALE_XOTHERM: Returns XO thermistor voltage in millidegC.
96 * SCALE_HW_CALIB_XOTHERM: Returns XO thermistor voltage in millidegC using
|
| /Linux-v6.1/arch/arm/boot/dts/ |
| D | cros-adc-thermistors.dtsi | 3 * Thermistor dts fragment for devices that use Thermistors as
|
