Searched full:trm (Results 1 – 25 of 188) sorted by relevance
12345678
| /Linux-v6.1/Documentation/devicetree/bindings/pinctrl/ |
| D | nvidia,tegra20-pinmux.txt | 37 TRM to determine which are valid for each pin or group.
48 or "LPMD1" and "LPMD0" in the Tegra TRM.
51 Tegra TRM.
54 Tegra TRM.
57 "DRVDN_SLWR" in the Tegra TRM.
60 "DRVUP_SLWF" in the Tegra TRM.
63 or groups. See the Tegra TRM and various pinmux spreadsheets for complete
|
| D | nvidia,tegra210-pinmux.txt | 31 See the TRM to determine which properties and values apply to each pin/group.
68 Tegra TRM.
71 Tegra TRM.
74 "DRVDN_SLWR" in the Tegra TRM.
77 "DRVUP_SLWF" in the Tegra TRM.
|
| D | nvidia,tegra194-pinmux.txt | 19 See the TRM to determine which properties and values apply to each pin/group.
53 Tegra TRM.
56 Tegra TRM.
|
| /Linux-v6.1/Documentation/translations/zh_CN/video4linux/ |
| D | omap3isp.txt | 221 大多数域的解释可以在 OMAP 的 TRM 中找到。以下两个域对于以上所有的
222 私有 IOCTL 配置都很常见，由于他们没有在 TRM 中提及，故需要对其有
257 OMAP 3430 TRM:
261 OMAP 35xx TRM:
264 OMAP 3630 TRM:
268 DM 3730 TRM:
|
| /Linux-v6.1/Documentation/devicetree/bindings/clock/ |
| D | nvidia,tegra124-dfll.txt | 40 - nvidia,droop-ctrl: See the register CL_DVFS_DROOP_CTRL in the TRM.
41 - nvidia,force-mode: See the field DFLL_PARAMS_FORCE_MODE in the TRM.
42 - nvidia,cf: Numeric value, see the field DFLL_PARAMS_CF_PARAM in the TRM.
43 - nvidia,ci: Numeric value, see the field DFLL_PARAMS_CI_PARAM in the TRM.
44 - nvidia,cg: Numeric value, see the field DFLL_PARAMS_CG_PARAM in the TRM.
47 - nvidia,cg-scale: Boolean value, see the field DFLL_PARAMS_CG_SCALE in the TRM.
|
| /Linux-v6.1/Documentation/admin-guide/media/ |
| D | omap3isp.rst | 74 OMAP 3430 TRM:
78 OMAP 35xx TRM:
81 OMAP 3630 TRM:
85 DM 3730 TRM:
|
| /Linux-v6.1/drivers/bus/ |
| D | omap-ocp2scp.c | 48 * As per AM572x TRM: http://www.ti.com/lit/ug/spruhz6/spruhz6.pdf in omap_ocp2scp_probe()
50 * As per OMAP4430 TRM: http://www.ti.com/lit/ug/swpu231ap/swpu231ap.pdf in omap_ocp2scp_probe()
52 * As per OMAP4460 TRM: http://www.ti.com/lit/ug/swpu235ab/swpu235ab.pdf in omap_ocp2scp_probe()
54 * As per OMAP543x TRM http://www.ti.com/lit/pdf/swpu249 in omap_ocp2scp_probe()
|
| /Linux-v6.1/Documentation/admin-guide/perf/ |
| D | arm-cmn.rst | 25 Most events are specified in a format based directly on the TRM
45 (as defined in the "Node ID Mapping" section of the TRM).
59 "wp_exclusive" are specified per the TRM definitions for dtm_wp_config0.
|
| D | arm_dsu_pmu.rst | 21 The user should refer to the TRM of the product to figure out the supported events
|
| /Linux-v6.1/drivers/phy/ti/ |
| D | phy-dm816x-usb.c | 21 * TRM has two sets of USB_CTRL registers.. The correct register bits
22 * are in TRM section 24.9.8.2 USB_CTRL Register. The TRM documents the
29 * according to the TRM. It's possible that USBPHY_CTRL is more generic,
|
| D | phy-ti-pipe3.c | 215 /* DRA75x TRM Table 26-17 Preferred USB3_PHY_RX SCP Register Settings */
241 /* DRA75x TRM Table 26-9 Preferred SATA_PHY_RX SCP Register Settings */
251 .dig_hs_rate = 0, /* Not in TRM preferred settings */
252 .dig_ovrd_hs_rate = 0, /* Not in TRM preferred settings */
266 /* DRA75x TRM Table 26-62 Preferred PCIe_PHY_RX SCP Register Settings */
505 * as recommended in AM572x TRM SPRUHZ6, section 18.5.2.2, table in ti_pipe3_init()
|
| /Linux-v6.1/drivers/firmware/ |
| D | ti_sci.h | 789 * For detailed information on the settings, see the UDMAP section of the TRM.
836 * For detailed information on the settings, see the UDMAP section of the TRM.
937 * section of the TRM for restrictions regarding this parameter.
1158 * section of the TRM for more information on this setting. Valid values for
1171 * See the UDMAP section of the TRM for more information on this setting.
1176 * See the UDMAP section of the TRM for more information on this setting.
1181 * See the UDMAP section of the TRM for more information on this setting.
1186 * See the UDMAP section of the TRM for more information on this setting.
1191 * the UDMAP section of the TRM for more information on this setting.
1196 * the UDMAP section of the TRM for more information on this setting.
[all …]
|
| /Linux-v6.1/drivers/pinctrl/ti/ |
| D | pinctrl-ti-iodelay.c | 31 * @signature_mask: CONFIG_REG mask for the signature bits (see TRM)
32 * @signature_value: CONFIG_REG signature value to be written (see TRM)
33 * @lock_mask: CONFIG_REG mask for the lock bits (see TRM)
34 * @lock_val: CONFIG_REG lock value for the lock bits (see TRM)
35 * @unlock_val:CONFIG_REG unlock value for the lock bits (see TRM)
36 * @binary_data_coarse_mask: CONFIG_REG coarse mask (see TRM)
37 * @binary_data_fine_mask: CONFIG_REG fine mask (see TRM)
86 * struct ti_iodelay_reg_values - Computed io_reg configuration values (see TRM)
197 * Update the configuration register as per TRM and lockup once done.
198 * *IMPORTANT NOTE* SoC TRM does recommend doing iodelay programmation only
|
| /Linux-v6.1/drivers/thermal/ti-soc-thermal/ |
| D | omap4xxx-bandgap.h | 57 * ADC conversion table limits. Ignore values outside the TRM listed
58 * range to avoid bogus thermal shutdowns. See omap4430 TRM chapter
|
| /Linux-v6.1/arch/arm/mach-omap2/ |
| D | omap_hwmod_81xx_data.c | 25 * Common alwon .clkctrl_offs from dm814x TRM "Table 2-278. CM_ALWON REGISTERS"
26 * also dm816x TRM 18.7.17 CM_ALWON device register values minus 0x1400.
95 * TRM 18.7.6 CM_DEFAULT device register values minus 0x500
124 * L4 standard peripherals, see TRM table 1-12 for devices using this.
125 * See TRM table 1-73 for devices using the 125MHz SYSCLK6 clock.
135 * L4 high-speed peripherals. For devices using this, please see the TRM
136 * table 1-13. On dm816x, only EMAC, MDIO and SATA use this. See also TRM
|
| D | prm2xxx_3xxx.h | 186 * check TRM if you are unsure
222 * 2420 TRM sometimes uses "EN_WAKEUP" instead of "EN_WKUP"
|
| /Linux-v6.1/arch/arm/boot/dts/ |
| D | omap3-gta04a5one.dts | 19 /* data lines, gpmc_d0..d7 not muxable according to TRM */
31 * according to TRM. OneNAND seems to require PIN_INPUT on clock.
|
| D | am3517.dtsi | 33 * AM3517 TRM only lists 600MHz @ 1.2V, but omap36xx
156 /* Table Table 5-79 of the TRM shows 480ab000 is reserved */
|
| /Linux-v6.1/drivers/clk/davinci/ |
| D | psc-dm365.c | 72 * The TRM (ARM Subsystem User's Guide) shows two clocks input into
80 * Its not fully clear from TRM (ARM Subsystem User's Guide) as to what
|
| /Linux-v6.1/drivers/clk/ti/ |
| D | dpll44xx.c | 21 * defined in OMAP4430/60 Public TRM section 3.6.3.3.2 "Enable Control,
87 * Public TRM section 3.6.3.3.2 "Enable Control, Status, and Low-Power
|
| /Linux-v6.1/drivers/nvmem/ |
| D | vf610-ocotp.c | 122 /* Refer section OTP read/write timing parameters in TRM */ in vf610_ocotp_calculate_timing()
183 * 0xBADABADA as mentioned by the TRM. We just read this in vf610_ocotp_read()
|
| /Linux-v6.1/arch/arm64/boot/dts/ti/ |
| D | k3-j721s2.dtsi | 5 * TRM (SPRUJ28 – NOVEMBER 2021) : http://www.ti.com/lit/pdf/spruj28
107 /* Recommendation from GIC500 TRM Table A.3 */
|
| /Linux-v6.1/Documentation/devicetree/bindings/dma/ |
| D | nvidia,tegra20-apbdma.txt | 16 select value for the peripheral. For more details, consult the Tegra TRM's
|
| /Linux-v6.1/Documentation/devicetree/bindings/mfd/ |
| D | twl4030-audio.txt | 19 -ti,offset_cncl_path: Offset cancellation path selection, refer to TRM for the
|
| /Linux-v6.1/Documentation/devicetree/bindings/reset/ |
| D | zynq-reset.txt | 5 See Chapter 26 of the Zynq TRM (UG585) for more information about Zynq resets.
|
12345678
